Question about Lexus ES 300

1 Answer

The car surges to the right upon acceleration Lexus es300

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Lexus Master
  • 950 Answers

Check front and rear suspension bushes. Re-tighten all the front and rear suspension nuts and bolts.

Posted on Dec 28, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 290 Answers

SOURCE: The Lexus car remote key control model ES300

try this:

1. Start with key out of ignition, drivers door is open all others closed and
drivers door is unlocked.

2. Insert key into the ignition (DO NOT Turn) and Pull key out.
3. Perform these steps within 40 seconds.
A. Using the power lock switch on the drivers door, perform 5 lock/unlock cycles
starting with lock. Use an even pace and try to go about one cycle per second.
(1Cycle = 1 lock and 1 unlock).
B. Close, then open drivers door.

4. Perform these steps within 40 seconds.
A. Using the power lock switch on the drivers door, perform 5 lock/unlock cycles
starting with lock. Use an even pace and try to go about one cycle per second.
(1Cycle = 1 lock and 1 unlock).
B. Insert the key in the ignition cylinder.
C. Turn the ignition to ON (Do NOT Start) then back to OFF.
D. Remove the key from the ignition.

5. Press any button on remote for a minimum of 1 second.
System should now lock and unlock doors once.

6. Close and open drivers door.

7. Press any button on remote for a minimum of 1 second. System should now lock and
unlock doors. Once to confirm programming, twice to indicate programming failed.

8. Repeat steps 5, 6 and 7 for additional remotes.

Posted on Mar 23, 2009

  • 1 Answer

SOURCE: how to change lexus es300 2002 cabin air filter

I just changed the cabin filter of my ES300. I found the instructions on the manual, under airconditioning and audio. It's pretty easy to do. I bought the filter from Kragen's for $21.95.

Posted on Mar 27, 2009

  • 18 Answers

SOURCE: 2000 Lexus ES300 - 45K

Are you sure this is a rattle or is it more of a creaking noise? I have a 2000 ES300 and had an issue when I would go over speed bumps and the noise would drive me nuts! However replacing the bushing in the top of the strut mount is expensive due to the labor involved.. Replacement of the strut or the bushing isn't necessary. Just open the hood, locate the strut housing and you ll be able to see the black rubber bushing in the middle. Obtain a can of Heavy Duty silicone aerosol spray and attach a straw to the spray tip. Using a flathead screwdriver wedge the screwdriver between the top of the bushing and the metal pushing the screwdriver all the way to the edge of the metal underneath the roof of the metal housing. Then pry the edge of the bushing away from the metal housing so that the top of the edge of the bushing exposed and stick the straw end of the silicone into the spot and spray generously. Only slight bushing movement will be obtained as the bushing is pretty stiff but it will be enough. Work your way around using this technique until you get the spray fully around the bushing 360 degrees getting it into the area between the edge of the bushing and the metal. Then spray the silicone onto the top of the bushing filling it all the way up until it spills over the metal. After it drains down, repeat again making sure you fill it above the rim of the bushing so it seeps into the area between the bushing and he metal housing (or frame) because this is where the rubbing is taking place that is creating that awful noise. Repeat on the other side and your done. The main goal is to get the silicone into the area between the metal and the bushing along the edge. This happens to be the way I was able to do it. This totally solved my problem and now the car is so quiet there aren't any knocking, creaking or rattling noises. This was a hard solution to explain without visuals, hope you can follow. This will work for sure. The Heavy Duty Silicone spray I used was manufactured by CRC and I bought it from Walmart.

Posted on Jul 22, 2009

  • 1 Answer

SOURCE: 1993 Lexus LS400 acceleration stalls or surges

I HAD THE SAME PROBLEM WITH MY CAR. 93 LS 400. THAT WOULD BE YOUR FUEL FILTER OR THE FUEL PUMP GOING BAD. TRY CHANGING THE FILTER FIRST. THE DEALER TRIED TO CHARGE ME $980 TO CHANGE FUEL PUMP.

Posted on Jul 23, 2009

  • 6 Answers

SOURCE: amplifier location 1993 lexus es300

My Son has a 95 es300, the amp for it is located under the front passenger seat. The easiest way to access it is to remove the 4 bolts holding the seat down, and remove the seat. Takes about 5 minutes

Posted on Jul 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Lexus es300 acceleration problem, dangerous speeds


Sorry Danielle but your vehicle does not have electronic throttle control . Your best bet take it to a qualified repair shop that knows your vehicle better then you .

May 13, 2017 | Lexus ES 300 Cars & Trucks

2 Answers

Will a bad MAF on 92' Lexus es300 cause no spark?


No it will not cause a no spark condition.

Apr 26, 2012 | 1992 Lexus Es 300

1 Answer

Where is fuse box on 1999 lexus es300


You can check this website, you find there fuse box diagram and description for Lexus ES300


Lexus ES300 1999 fuse box diagram Auto Genius

Lexus ES300 2002 2003 fuse box diagram Auto Genius

Apr 11, 2012 | 2003 Lexus ES 300

1 Answer

When I accelerate in my Lexus Es300 sedan 2000 it jerks and cannot exceed a speed of 60kph. what causes the jerking?


Sound like you are not firing on all cylinders. Tune up, spark plugs, cables , fuel injector check

Apr 15, 2010 | 2000 Lexus ES 300

1 Answer

How to take out stock stereo and replace in 1999 lexus ES300


remove cup holders first then 2 screws on bottom then 2 screws through the ac vent and should slide right out
check ebay or a car custom place

Apr 14, 2009 | 2002 Lexus ES 300

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

874 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...