Question about Cars & Trucks
I have a 2002 Isuzu Rodeo that won't start. It has spark and fuel. It will crank but won't turn over and start.
Out of time?? check the rotor once its at top dead center on 1 cylinder.. see if its out..
Posted on Dec 28, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: wont start 1999 isuzu rodeo
Locate the Fuel Filter and Take it loose. Try to Start the Truck, If the Pump is Good, Fuel will come out of the Fuel line going to the Filter. Please Rate My Response! Thanks!
Posted on Feb 07, 2009
SOURCE: 2000 isuzu Rodeo wont start
Could be your neutral safety switch, or it's not all the way in park. Broken or loose wires in the starting circuit. Inspect all wires and connectors at the battery, starter solenoid, and ignition switch. Or your starter pinion is jammed in the ring gear. Remove starter and inspect. Last but not least, your engine is seized. You don't want that one. Good luck.
Posted on May 22, 2009
SOURCE: 2002 isuzu rodeo won't start
the clutch switch is located on the clutch pedal support, if you put your hand on the clutch pedal run your hand up and the switch will be at the top. now if you are going to replace this switch I would try to adjust the switch first the amount of time it takes and this would confirm that it's the switch. ensure clutch pedal is fully returned, disconnect the electrical connector from the switch. loosen lock nut and tighten clutch switch by hand until switch is firmly against clutch lever. back the switch out 1/2 turn, the switch plunger should extend .02-.06" (.5-1.5 mm).
hope this helps
Posted on Jul 13, 2009
SOURCE: Crank Sensor in 94 Isuzu Rodeo
it's on the bottom of the motor, towards the back on the passenger side. It has a small clip of wires and one screw holding it on. You may want to pull it up on ramps- if it'll run- otherwise, get under the Rodeo, it's up a little higher than the oil pan, and to the passenger side. (it's right on top of the two lines that run to the bottom of the radiator.) You will need a 10mm socket to remove it. I have added a few pics showing the location (i just completed this task myself)
Posted on Jul 24, 2009
Tips for a great answer:
Oct 16, 2014 | 2002 Isuzu Rodeo
Mar 21, 2013 | 1997 Isuzu Rodeo
Jul 15, 2012 | 1999 Isuzu Rodeo
Feb 11, 2012 | 1995 Isuzu Rodeo
Sep 15, 2011 | 1994 Isuzu Rodeo
Jul 09, 2011 | 2002 Isuzu Rodeo
Apr 20, 2011 | 1995 Isuzu Rodeo
165 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: