Question about 2006 Toyota Corolla 1.8

1 Answer

Idiling high - 2006 Toyota Corolla 1.8

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 20,706 Answers

Hot or cold engine

the EFI works in 4 modes. cold to hot.
cold, warming, hot. or overheated.
1,2,3,4,
i cant guess

Posted on Dec 28, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

93 3003 MERCEDES 2.8 DIDNT PASS SMOG NO CHECK ENG LIGHT ON SMOG GUY SAID EGR STUCK IDILES A LITTLE ROUGH BUT RUNS GOOD AT HIGH SPEEDS WHAT DO I DO?


run the fault codes to ensure that the EGR valve is faulty. Engine lights to not always come on unless there is something drastic going on with the engine /gearbox so that you can stop the car before damage is done.

Apr 25, 2014 | 1989 Mercedes-Benz 300-Class

1 Answer

My idilling runs very high


Check for a vacuum leak in any rubber hoses you may have connecting to the intake manifold or plenum, etc.

Aug 20, 2012 | 2003 Pontiac Montana

1 Answer

My 1998 Explorer on startup idiling to high, it occasionally revs up and down while idiling. Is there a trottle position sensor that controls the idiling rpm?


there is a tps located on the intake where the inlet tube for air intake connects, it would be on the left side of the throttle body. does the trk run rough on idle? up/down sputter sometimes stall? Is check engine light on? if no light,check all vacuum lines for cracks/splits loose fit. do this by spraying carb choke cleaner on connections motor rpms will change if leak is present. also spray around perimeter of intake housing where mates with lower intake if engine revs you have bad intake gasket.I Just replaced upper and lower intake on my 98 and shazaam, runs like it should. but do your checks first,unessasary fixes are costly and **** you off.

Jan 03, 2011 | 1998 Ford Explorer

1 Answer

It is idilin to high i have adjusted the idil screw and the throttle cable is loose not tight so the cable


idling high could be either a throttle position sensor or a vacuum leak letting in too much air.

Jul 31, 2010 | 1999 Isuzu Rodeo

1 Answer

High idile


turn the idle down. you need a flat head screw driver and find the idle switch and turn it down.

Dec 30, 2009 | 1989 Jeep Cherokee

1 Answer

1986 subaru gl wagon non turbo stays idiling at 2500


Hate to tell you this but sounds like the problem is a vacuum leak. This will make the engine rev. Check all the vacuum lines before making any adjustment. Have to dig out some of my old books to find factory settings for that carb. Good luck and I will try to find in case you need them to restore carb settings.

Apr 13, 2009 | 1986 Subaru Gl 2 Door

1 Answer

Idiling


yes you can and quite easily. on your throttle body there is a cable that runs to a metal thing that turns and that is your throttle cable. when you press the throttle it pulls the cable and makes the engine rev up. all you need to do is tighten up the nuts where the cable goes threw the metal and the rpms will go up. i suggest doing it while car is running

Nov 14, 2008 | 1995 Mazda MX-6

1 Answer

Chyrsler sebring lxi 1995 2.5 v6 24 valve


ok this sounds easy when you ran the vehicle the computer controled the idiling motor now that you replace the idiling motor the computer hasnt been reset to except the new parameters
once you reset computer this should bring the idle back down to its specified idle
you can also adjust back of gas pedel the idle cable and on the throttle body by the idling screw

Jun 13, 2008 | 1995 Chrysler Sebring

Not finding what you are looking for?
2006 Toyota Corolla 1.8 Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...