Question about Cars & Trucks

Open Question

Where are is the drain plug and fill plug to mitsubishi triton 1993

Posted by Anonymous on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 42 Answers

SOURCE: location of drain plug, fill plug and correct oil level plug for 5 speed manual transmission

I don't know if there is a fill plug. I just use the level plug located on driver's side right above the inner CV joint of the half-shaft (axle) to fill it. A piece of flexible tubing connected to a funnel works well. The drain plug is fairly near the center of the bottom of the gearbox housing (behind the bell housing). The level plug has a 24mm, fairly flat, hex head, and the drain plug is a recessed plug with a 3/8" (?) square hole (for a socket handle).

Posted on Apr 23, 2010

  • 130 Answers

SOURCE: Where is the oil drain

On the oil pan it should be 17mm unless it has been changed.

Posted on May 09, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Spark plug gap for 1997 mitsubishi trition 2.4 petrol ute


Spark plug gap does not effect the engine timing so it's not that critical. Thirty 5 (.035) should work just fine.
Otherwise consult a service manual fro your model or call a Mitsubishi service centre

mitsubishi triton service manual
Mitsubishi Triton L200 2006 2013 Workshop Manuals Factory Service Manuals

May 27, 2014 | Mitsubishi Pickup Cars & Trucks

1 Answer

Is the transfer case and transmission fluid connected or do they run as seperate units on a mitsubishi montero sport 2003


More than likely both units will use atf, but will run as separate units. There should be drain and fill plugs on the transfer case. Plug towards the bottom of the case would be the drain, plug about halfway up would be the fill. Add fluid untill it runs out of this mid-position plug and replace the plug.

Aug 19, 2011 | Mitsubishi Montero Sport Cars & Trucks

1 Answer

Where is the oil drain plug located on 1993 mitsubishi montero


On the oil pan it should be 17mm unless it has been changed.

May 09, 2011 | 1993 Mitsubishi Montero

1 Answer

Cannot locate position in motor to replace gear box oil; in 1993 5 gear manual toyota celica



  • You don't have a dip stick on this car. You have to go underneath the car and on the transmission you will see two plugs, one on top of the other. The one on top is the fill. The one on the bottom is the drain plug.

  1. To fill it you need a funnel with a hose on it.
  2. Remove the fill plug (top) and fill the transmission just until the gear lube barely seeps out and replug it.
  3. This is now the properly filled.
  4. Plug the fill hole back up.


  1. If you get a container and put it under the drain plug on the transmission and pull the top fill plug FIRST and then the bottom drain plug and let all the gear lube run out.
  2. Now plug the drain hole and fill the transmission till it seeps out.
  3. Now plug the fill hole.
  4. You just did a transmission flush on your vehicle and saved yourself $75usd shop charge.


Regards, Tony

Apr 27, 2011 | 1993 Toyota Celica

3 Answers

My Mitsubishi triton ute is breaking down mid way through rev ran


hi i have the same problem with my 89 triton and changed the head and everything you have did you work it out .i heard the carbys are notorious for stuffin up

May 02, 2010 | 1989 Mitsubishi Starion

1 Answer

How to replace cluch fluid in mitsubishi triton 1998 ute?


On the slave cylinder will be a bleed port, remove this fitting (port), remove the fill cap and let the fluid drain into a pan, will not take long if you help by pushing on the clutch pedal a few times.

Jan 24, 2010 | 1998 Mitsubishi Eclipse

1 Answer

Air con charging stubs


One is near the compressor, the other is near the firewall in my mitsubishi triton. I hope yours is similar.Another possibility is behind the front grill.

Aug 07, 2009 | 1993 Mitsubishi Montero

1 Answer

Location of drain plug, fill plug and correct oil level plug for 5 speed manual transmission


I don't know if there is a fill plug. I just use the level plug located on driver's side right above the inner CV joint of the half-shaft (axle) to fill it. A piece of flexible tubing connected to a funnel works well. The drain plug is fairly near the center of the bottom of the gearbox housing (behind the bell housing). The level plug has a 24mm, fairly flat, hex head, and the drain plug is a recessed plug with a 3/8" (?) square hole (for a socket handle).

Jun 02, 2009 | 1993 Geo Metro

1 Answer

Where is the fill plug for the rear axle? i dont see one. i do however see the drain plug but there has to be a fill plug right?


Yes. Drain plug is in bottom, fill plug would be about half way up the differential housing. Probably the same type plug for both.

May 06, 2009 | 1993 Dodge Dakota

1 Answer

Manual transmission


no it is not required. just be sure to tighten the drain plug securely.

and use 10w30 motor oil to fill the tranny.

Apr 11, 2009 | 1993 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...