Question about 2002 Ford Mustang

1 Answer

Where is the engine speed sensor on a 02 mustang

Where is the engine speed sensor located on a 02 mustang

Posted by on

  • Mike Butler
    Mike Butler May 11, 2010

    Is it engine speed sensor or vehicle speed sensor your looking for?



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 453 Answers

Located on the trans on drivers side it will have your speedometer cable connected to it.

Posted on May 18, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Location speed control sensor 1996 silverado

This code is actually talking about the 02 (oxygen sensor) in the exhaust system. Bank 2 sensor 1 is the location. This is the sensor in the exhaust on the passenger side of the engine closest to the engine. Usually in the exhaust manifold.

Feb 13, 2015 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

Locate 02 sensor

On the I6 engine, the precat sensor is located on the passenger side of the engine right below the exhaust manifold. Easty to get to, unplug the sensor and use an 02 sensor socket to remove. Post cat sensor is underneath after the cat. The connector to unplug is located in a difficult position, near the top of the transmission. I find that moving yourself toward the rear of the car and reach in the easiest. As opposed to reaching in right above the 02 sensor.

May 13, 2014 | 2003 Chevrolet TrailBlazer

1 Answer

Where is the speed sensor located?

For location and diagram of speed sensor,click the link below :---
----------This will help.Thanks.

Feb 28, 2012 | 2001 Kia Optima

1 Answer

We have a 98 for mustang v6 3.6 liter engine. the check engine light came on and gave us the code p1131..i have searched the internet for possible solutions but want to know if any one experienced this to...

P1131 - Insufficent Switching 02 Bank 1 Sensor - 1 Sensor / Lean.

Sensor 1 on bank 1 is the passenger's side upstream 02 sensor.

Start by cleaning the MAS and Filter and see if this helps. If not, you will probably need to replace the O2 sensor.

It COULD also be a bad No.2 injector I believe

Jul 05, 2011 | 1998 Ford Mustang

2 Answers

Speedometer reads 15 to 30 mph than actual speed. Just started , cold here tires are the sameas before. 2005 v6 mustang

Sound like the speed sensor is not working right. Located on the drivers side of trans where the speedometer cable plugs in to the speed sensor. One 10mm bolt with clip holds it to trans.

Jan 10, 2010 | 2005 Ford Mustang

2 Answers

Where to find 02 sensor heater circuit malfuction bank 1 sensor1

This sensor will be located before your catalytic converter and will be on the same side as cylinder 1 of your engine

Sep 09, 2009 | 2000 Ford Mustang

1 Answer

Service engine

if you want to change you fuel filter it take a special tool for a ford it should be in on the inside frame under the drive side. Also try taking your car to and auto part store and have them run the obd 2 code reader to find out why your engine light is on they usual don't charge for that

Jan 19, 2009 | 2002 Ford Mustang

1 Answer

02 mustang gt convertible

4.6 V8. Its on the passenger side, front of the engine. You'll need to remove the AC Compressor to get to it, it's a black sensor, with one bolt holding it in place, with 2 wires comming off of it. Its right behind the AC Compressor

Sep 27, 2008 | 2002 Ford Mustang

Not finding what you are looking for?
2002 Ford Mustang Logo

Related Topics:

208 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers


Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides