Question about 2000 Buick Century

1 Answer

Camshaft sensor i need to find and replace my camshaft sensor on my 2000 buick century

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 239 Answers

3.8 under water pump 1 10mm bolt
3.1/3.4 inbetween front cover and intake same 1 bolt (has long wire lead connector on front valve cover

Posted on Dec 29, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

jeffk14
  • 16 Answers

SOURCE: how to replace a coolant level sensor, 2000 buick century

TRY THIS. Good luck!

Posted on Nov 22, 2008

Papa Chan
  • 56 Answers

SOURCE: how to replace a coolant level sensor, 2000 buick century

The coolant level sensor is located on the radiator. If you are looking at the engine from the front of the car it will be on the left side. There will some kind of clip holding it in the radiator. Removed the clip and pull the sensor out. You will lose coolant so try to swap it out quick or drain some of the coolant out. Once new sensor is installed, install clip to keep the sensor in place and reconnect the wires to the sensor. Crank the engine and make sure the coolant level is full. This should correct your problem.

Posted on Jan 04, 2009

johnsmith992
  • 37 Answers

SOURCE: replace heater core in a 2000 buick century

please do not tamper wid the aircon as the system is pressure filled with co"2 liquid gas.

Posted on Jan 29, 2009

MNfisherman
  • 11896 Answers

SOURCE: how to replace 2000 buick century temperature actuator

First, what is the problem that you need to replace the actuator? Is the air flow from the vents not changing? If this is the problem, the actuator is inside the venting behind the control panel and is difficult to get to but is possible. Follow the hoses on back of temp controls to the actuator. There should be 2 small bolt screws to remove to change out actuator.
If this is for something else, let me know

Posted on Jul 01, 2009

localwonder
  • 6784 Answers

SOURCE: where is camshaft position sensor located on 3.1l

HI. Your CMP will be located, just below the cam cover gasket rail, in front of the cam carrier.

Posted on Dec 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Check crank sensor 2000 buick century


Click the link mentioned below:---

How to test Crankshaft Position CKP Sensor?

--------------

Crankshaft Position Sensor Operation?

-------------------

These will help.

Thanks.


Dec 06, 2012 | 2000 Buick Century

1 Answer

I need to know where a crank sensor is located on a 1995 buick century?? And also need to know where the cam sensor is located


Crank sensor is in back of harmanic pulley (crankshaft), and camshaft sensor is on front of timing chain cover.

Aug 19, 2010 | 1995 Buick Century

1 Answer

Where is camshaft position sensor located on 3.1l buick century


HI. Your CMP will be located, just below the cam cover gasket rail, in front of the cam carrier.

Dec 15, 2009 | 1998 Buick Century

1 Answer

My 89 buick century starts and rus for awhile then dies and sometime does not start i put a new starter on two days age and it still doing it no check lights on


My 94 regal would sometimes start and sometimes not. Sometimes would just die like you turned off the key... after replacing many parts I ended up replacing the crankshaft position sensor and the camshaft positon sensor and it has worked great ever since...

Oct 28, 2009 | 1989 Buick Century

1 Answer

1987 Buick Century Limited V-6 engine w/ac. Engine cranks but won't start. Instrument panel light shows "Service Engine Soon". Also light shows "Oil Choke". And light shows picture of battery.


I took my car to my mechanic. He did a diagnostic circuit test on the engine and then replaced the distributer ignition module and camshaft and crankshaft position sensors.

Jun 18, 2009 | 1987 Buick Century

1 Answer

Canshaft sensor location


Hello, the camshaft location on a 3.1 is located under the power steering pump. The crankshaft position sensor is on the back of the block above the transmission, middleways of the motor.

Feb 21, 2009 | 2000 Buick Century

1 Answer

How to replace a coolant level sensor, 2000 buick century


The coolant level sensor is located on the radiator. If you are looking at the engine from the front of the car it will be on the left side. There will some kind of clip holding it in the radiator. Removed the clip and pull the sensor out. You will lose coolant so try to swap it out quick or drain some of the coolant out. Once new sensor is installed, install clip to keep the sensor in place and reconnect the wires to the sensor. Crank the engine and make sure the coolant level is full. This should correct your problem.

Dec 20, 2008 | 2000 Buick Century

1 Answer

1998 Buick Century 3.1 engine


camshaft position sensor it is located on the engine block on the belt side of the motor there is also a crank position sensor that is located on that same side, that is behind the main belt pulley. basically the computer is sensing that these two sensors are out of sync with each other this is a common problem, and is corrected by replacing the camshaft position sensor in most cases. Otherwise check the connections and wiring to the sensor please rate -jeff

Aug 09, 2008 | 1998 Buick Century

Not finding what you are looking for?
2000 Buick Century Logo

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...