Question about 2003 Chevrolet Express

1 Answer

My chevrolet express 2500 has a problem . the ABS/TCS

Please my chevrolet express 2500 has a problem . the ABS/TCS light comes on.after checking with the scan tools i have got those codes; C0055,P0753,P0502. I need your help to assist me. because first, I don't have its wiring diagram and where the IP FUSE is located. thanks

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert
  • 103 Answers

This could be a little hard for the average person to fix. C0055 is the reason the ABS lite is on and it has to do with the speed sensor circuit. PO502 is also related as it has to do with the VSS circuit and will require some specialized equipment to correctly diagnose and repair, Sorry.
PO753, Locate the fuse block on the IP. Now locate the "IGNITION 0" fuse and replace it because it is blown.This will correct the P0753 code and correct the transmission shift inhibit problem.

Posted on Aug 29, 2009

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: 1999 chevrolet silverado 2500 2wd abs motor pack gone out.

disconnect the battery for 30 seconds

Posted on May 27, 2009

  • 315 Answers

SOURCE: what tools are needed to remove brake calipers on 2004 Chevrolet

I think a quick look at your calipers will answer that question lol

Posted on Mar 27, 2009

dennymulford
  • 1055 Answers

SOURCE: v-8 engine want start without starting fluid runs fine once start

have you gave it a tune up lately?

Posted on Mar 01, 2009

  • 3600 Answers

SOURCE: Chevrolet Automatic express 2500 gear shifter is

gear shift selector roll pin that holds shift lever in postion shift rod shift rod pivot and spring assembly, colomm retainer assembly pin for shift lever lower and shift linkage lower.

Posted on Sep 10, 2009

  • 1752 Answers

SOURCE: how do I GET BAD CENSORS REPLACED ON MY

With that many sensor codes, you should get three estimates from three local shops.

Posted on Oct 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Light abs traction control stays 1998 buick park avenue


PRE-DIAGNOSTIC INSPECTIONBefore diagnosing ABS/TCS, perform a comprehensive visual inspection of system as follows.Check ABS/TCS wiring harness connectors for looseness. Check harness routing; pay particular attention to wheel speed sensor wiring harness routing. Check fuses No. 1D, 5B and 6B in instrument panel fuse block. Check fuses No. 1 and 2 in underhood fuse block. Check brake fluid level in master cylinder reservoir. Check brake fluid level in Pressure Modulator Valve (PMV) assembly reservoir. Ensure parking brake is fully released. Ensure parking brake switch is functioning properly. Always perform ABS/TCS system functional check before using DIAGNOSTIC CODE CHARTSThe EBCM/EBTCM has self-diagnostic capability, which can detect system failures. Fault codes stored by EBCM/EBTCM can be displayed using Tech 1 scan tester. There are no provisions for flash code diagnostics.Begin ABS/TCS diagnosis with PRE-DIAGNOSTIC INSPECTION procedure. If failures are found during pre-diagnostic inspection, perform necessary repairs, and proceed with ABS/TCS FUNCTIONAL CHECK. See Fig. 5 .If no failures are found during pre-diagnostic inspection, go to ABS/TCS FUNCTIONAL CHECK. See Fig. 5 . The ABS/TCS FUNCTIONAL CHECK will either indicate ABS/TCS is functioning properly or direct technician to various diagnostic procedures such as diagnostic charts, symptom diagnosis or BRAKE warning light diagnosis.CHART D - TRACTION OFF WARNING LIGHT ON CONTINUOUSLY & NO DTC SET (BUICK WITH UH8 OR U2A INSTRUMENT CLUSTER)Circuit DescriptionWhen ignition switch is first turned to RUN position, EBTCM goes through a self-test, which lasts 2-4 seconds. During self-test, EBTCM commands TRACTION OFF indicator warning light on. Powertrain Control Module (PCM) can also command EBTCM to set a Code 75 which will illuminate TRACTION OFF indicator.Traction control switch is located either on instrument panel center trim plate or driver's front door trim panel. Switch allows driver to select traction control mode (on/off). When traction control system is turned off, TRACTION OFF warning light comes on.EBTCM monitors transaxle temperature through

Jul 12, 2014 | 1998 Buick Park Avenue

1 Answer

Diagnosis ABS & TCS dashboard lights on


You will need access to a scan tool that "talks" to the ABS module. As for the fix, it depends on what the diagnosis tells you.

Jan 29, 2014 | 1997 Mazda 626

1 Answer

Abs and tcs light on 2000 chevy montecarlo


The abs light comes on when a fault is detected with abs system. Your best bet is to have the abs system scanned for trouble codes. Typically loose wheel bearings, or broken abs sensor harness wires are the two most common causes for the abs light to come on.

Apr 01, 2013 | 2000 Chevrolet Monte Carlo

1 Answer

My airbag warning light is permanantly on


Cluster warning lights

Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS, TPMS, MIL, CEL and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Anti-lock brake system. TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module. TPMS Tire Pressure Monitor System, MIL Malfunction Indicator Lamp, CEL Check Engine Light.

Dec 20, 2012 | 2007 Chevrolet Lacetti 1.6

1 Answer

How do I disengage the ABS in 1992 Chevy Cavalier


Cluster warning lights

Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS, TPMS, MIL, CEL and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Anti-lock brake system. TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module. TPMS Tire Pressure Monitor System, MIL Malfunction Indicator Lamp, CEL Check Engine Light.

Dec 19, 2012 | 1992 Chevrolet Cavalier

1 Answer

Abs light will not reset have replaced wheel sensor wires are good as i replaced speed sensor wires are good what next ??


Cluster warning lights

Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS, TPMS, MIL, CEL and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Anti-lock brake system. TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module. TPMS Tire Pressure Monitor System, MIL Malfunction Indicator Lamp, CEL Check Engine Light.

Dec 06, 2012 | 2002 Chevrolet Astro

1 Answer

I have a 2010 Chevrolet Impala and a light come on the dash that said car hot A/C off and then a check engine light with that and the A/C would not work.So i had the code read and the code pulled up


Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS, TPMS and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Anti-lock brake system. TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module. TPMS Tire Pressure Monitor System

Oct 31, 2012 | Cars & Trucks

1 Answer

Reduce power engine


Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS and BCM faults) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module

Oct 09, 2012 | 2003 Chevrolet Suburban

2 Answers

I have a 2008 Chevy Impala and the ABS and TCS warning lights come off an on sproadically. What is causing this?


go to advance auto and ask them to scan your car..it might show what it wrong...but the abs sensor is most likly the problem

May 23, 2012 | 2005 Chevrolet Impala

2 Answers

2002 honda accord tcs light comes on and will not go off


I assume tht is traction control. Check fuses ,eeven abs fuses ,traction control is part of abs. If fuses ok will need scan tool to find cause of lite going on. Most common are abs sensors and broken abs wires. And if abs tone ring is part of axle shaft some rock may have damaged teeth of ring .

Apr 23, 2009 | 2002 Honda Accord

Not finding what you are looking for?
2003 Chevrolet Express Logo

1,046 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...