Question about Cars & Trucks

1 Answer

Power control module has gone out - where to find one to replace it. 2006 Trailblazer

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 3,103 Answers

Parts store can tell you..

Posted on Dec 28, 2013


3 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 85 Answers

SOURCE: After replacing drivers door master control

i did mine in an 03 envoy and it was plug and play no programming, and it was used

Posted on Mar 29, 2010

  • 1949 Answers

SOURCE: 2006 chevy trailblazer driver side

replace the master switch in the drivers door.....sometimes they are a problem...hope this helps

Posted on Nov 15, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 06 Chevy trailblazer and the 4wd/auto switch is gone and it has been jumping from 4wd to auto . What do I do to fix it, I don't think a new switch is the fix

Most likely the control module assembly is the problem. It can be located under the dash and sometimes behind the passenger kick panel cover. You will normally hear a click noise when you engage the 4x4 and this click noise will indicate the location of the controller. You may not be able to access 4x4 hi if the lights are flashing but 4x4lo usually works.

Apr 25, 2015 | 2006 Chevrolet Trailblazer

1 Answer

I have a 2006 Trailblazer that is losing battery power overnight. I have traced the draw to fuse TBC3. Can anyone tell me what is connected to that fuse?

The TBC3 fuse is for the truck body controller module. You must have a short somewhere in the wiring harness or with a bulb.

Mar 09, 2015 | 2006 Chevrolet Trailblazer

1 Answer

2006 Chevy Trailblazer - Hit a small bump in the road and the ABS light comes, Traction control light and then it goes into power down mode. Had a scan done on it at a local parts store and they said is...

More than likely one of the wheel speed sensors was damaged or its connector was jarred loose. The ABS control module is the heart of the ABS system and rarely goes bad. Suggest you take it to a mechanic that is familiar with the Trailblazer and have a diagnostic done.

Oct 10, 2011 | 2006 Chevrolet Trailblazer

1 Answer

Drivers door control panel (power window heated seat locks ect ) what to do none of it is working 2006 chevy trail blazer

Check fuse #10 in the rear fuse panel. If fuse OK, try switching passenger side control module into driver's side. Also check for broken wires in wiring harness that goes between body and driver's door.

Sep 03, 2011 | 2006 Chevrolet Trailblazer

1 Answer

2006 chevy trailblazer driver side control module doesnt wor even whit a new module! what else can i do?

replace the master switch in the drivers door.....sometimes they are a problem...hope this helps

Nov 15, 2010 | 2006 Chevrolet Trailblazer Ext

1 Answer

Window left open during rain now power window and lock not working on driver side door on 2006 chevy trailblazer

{: ) That's too bad. The driver door module could have been internally shorted out. It's normally not serviceable. A new driver door switch or module will need to be programmed to your vehicle before it functions properly.

Jul 15, 2010 | 2006 Chevrolet Trailblazer

1 Answer

The heater / ac control only works with one or two desired settings.defrost will not work at all (2006 chevy trailblazer)

The actuator motor that controls the defrost,to floor,to vent ,has gone out,this will be a job to take to the shop,the dash will have to be pulled out toward the seats to replace the actuator motor.

Jan 21, 2010 | 2006 Chevrolet Trailblazer

2 Answers

2006 trailblazer 4x4 4.2, stalls while driving. Engine shuts down, whenever and wherever it feels like it. No pattern other than about every 2-5 miles, has worsened to this point over last 10 days....

ok well try this when it stalls see if spark is present and if it is not and it cools down and starts then you might need to replace ignition control module good luck

Aug 08, 2009 | 2006 Chevrolet Trailblazer

1 Answer

No controls on driver side of my 2006 trailblazer

sounds like your drivers door module either fried or lost power, if you can get it scanned it should come up with a trouble code, or if your inclined, you can check the connectors on the module for the switches and make sure they are in all the way. just gently pull up on the trim around the switches starting at the rear of the trim, 2 clips hold it in place, it should pop out, then you can check the connectors

Jun 19, 2009 | 2006 Chevrolet Trailblazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides