Question about Cars & Trucks

1 Answer

I got a 95 tahoe the trans has been rebulit and the rear end has been replace but i feel a vibartion when i mash own the gas

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 239 Answers

CHECK FOR LOOSE OR MISSING FASTENERS, BRACES ETC.
SOMETHING GROUNDING OUT (HITTING) WHEN MOTOR IS TORQUED.

Posted on Dec 28, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 74 Answers

SOURCE: 2003 chevy tahoe front rear end fluid

i think what you are talking about is the front differential. you will wanna put gear oil in it. the correct weight would be found in your manual.


Posted on Feb 20, 2009

jgwhomeequip
  • 1902 Answers

SOURCE: 99 CHEVY TAHOE AND WANT TO REPLACE MY REAR END WITH DISC BRAKES

98 Z71 Chevy rear end will work on this. You may need to get a kit to install disc

Posted on Apr 18, 2009

  • 150 Answers

SOURCE: 94 caprice v8 an i cant spin wheels (burnout) what to do

Sounds like the timing is retarded. Loosen the distributor hold down bolt and turn the distributor counter clockwise about a half inch or so. Then drive the car. If it runs better then get a timing light and set the timing to 10 to 15 degrees before top dead center (btdc) at idle with EST disabled (if equipped) or if it has a vacuum advance with vacuum hose disconnected. Good luck.

Posted on May 20, 2009

  • 6 Answers

SOURCE: while driving, it occasionally feels like someone

I am going to guess that you're correct on your Transmission, is it only when your vehicle is getting ready to shift?

Posted on Jun 04, 2009

  • 42 Answers

SOURCE: why is my 95 jeep

Please check the shock mounting hardware. Are the shocks in good shape? Additionally, make sure the trailing arms are not cracked.

Posted on May 25, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What else can i try are is it maybe a valcaume line i can replace


My advice to you if you can afford it it to take your car to a transmission shop, because to me, it sounds like your transmission is going very bad. It is slipping and that is why when you mash the gas, then it works. Best Of Luck.

Jul 04, 2015 | 1994 Cadillac Fleetwood

1 Answer

700r4 trans. rebulit download


Welcome to http://www.stylemalls.com//

where is the most popular Panthers online shop.


((( http://www.stylemalls.com/ )))

lower price fast shippment with higher quality!!

WE ACCEPT CREDIT CARD /WESTERN UNION PAYMENT
YOU MUST NOT MISS IT!!!

Jul 04, 2013 | Cars & Trucks

1 Answer

2005 chevy tahoe has a terrible roar coming from the rear differential. The roar becomes an unbearable whine at 45 mph. Any ideas what is causing this problem?


roar fron the rear end indicates the pinion is not meshing with the crown , most probably bad bearings, disconnect the drive shaft and rock the yoke or turn it slow you will feel the roughness, the only fix is replacement of the rear end

Aug 14, 2010 | 2005 Chevrolet Tahoe

1 Answer

Hard shifting after highway driving 1998 tahoe. After driving on the highway (mostly in hot weather) after coming to complete stop the car shifts hard at about 10 mph. Ramdonly does this from time to time....


sounds like your pressure control solenoid inside your trans is sticking you will have to have your pan pulled and have the solenods checked or replaced since it only fails at times it might check out ok when the pan is pulled.

Nov 15, 2009 | Chevrolet Tahoe Cars & Trucks

1 Answer

When I put my 2004 chevy tahoe in gear the rear end makes a loud whinning noise and does nothing then in with clack loud and catch and start going?????


A few broken ring gear teeth will cause that. BUT it wouldn't go very far till it made a whole lot more noise. The transmission will make lots of noises and can cause the same symptons you are complaining about. If it's 4x4 try and put it in four wheel drive and see what happens, don't drive far, that will help narrow it down between trans and rear end. If it's not 4x4 then if you can, remove the rear drive line, jack up the rear tires so they are off the ground and try and spin the rear pinion drive flange (the thing that the drive line was bolted to). It should spin fairly freely (it will have some drag) if you feel any binding or grinding then the problem is in the rear end.
Report back with your findings so we can better assist you.
P.S. both will be a big job and unless you have experiance working on these type of jobs then it will most likly be best left to someone who know what they are doing.

Oct 20, 2009 | 2000 Chevrolet Tahoe

1 Answer

Wont shift out of second


When it shifts to third does it just feel like neutral? If yes it will need rebuilt again, you hurt the 3/4 clutch.

May 25, 2009 | 1995 Chevrolet Tahoe

1 Answer

94 caprice v8 an i cant spin wheels (burnout) what to do


Sounds like the timing is retarded. Loosen the distributor hold down bolt and turn the distributor counter clockwise about a half inch or so. Then drive the car. If it runs better then get a timing light and set the timing to 10 to 15 degrees before top dead center (btdc) at idle with EST disabled (if equipped) or if it has a vacuum advance with vacuum hose disconnected. Good luck.

May 20, 2009 | 1994 Chevrolet Caprice Classic

1 Answer

I have a 00 audi a4 quattro, occasionally while taking a right hand turn ususlly from a stop, there is a clicking noise I believe to be comming from rear right? But the main problem seems to be vibartion...


the clicking and vibration in the front end sounds like a tie rod in need of replacement possibly due to potholes. Could be a bent alloy wheel from the same as well which could be causing all of the above problems

Mar 13, 2009 | 1999 Audi A4

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...