Question about 2010 Dodge Avenger SXT
I checked the fuse it looks fine, could it be a relay? If so, which relay controls the dash and tail lights? Thanks.
SHOULD BE 2 DIFFERENT FUSES
IP LAMPS AND TAIL LAMPS
CHECK RESISTOR SWITCH IS IT ALL THE WAY DOWN FOR IP LAMPS?
Posted on Dec 28, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
With the ignition off, press the TRIP and RESET buttons at the same time you turn on the ignition. HOLD the buttons for 10 sec and the instrument cluster will go into a diagnostic sequence. I dont have the codes but you can find them online (999 means ok).
Doing this procedure will reset the dash cluster which will solve most of the problems.
Posted on Aug 21, 2008
SOURCE: # 4 fuse blew out,
I KNOW YOU HAVE AN ELECTRICAL SHORT.WAS AN ALARM INSTALLED OR ANY OTHER TYPE OF ACCESSORY? CHECK WITH DODGE TO FIND OUT ABOUT A RECALL.IF SOMETHING WAS INSTALLED, TAKE IT BACK THERE TO STRAIGHTEN IT OUT IF NOT HAVE A AUTO TECHNICIAN CHECK IT FOR YOU.
Posted on Dec 27, 2008
SOURCE: DASH AND TAIL LIGHS DONT WORK
Check and see if you have trailer wiring on your truck. If so you do it may have a wire that is rubbed though the isulation and grounding on the body and shorting the circuit blowing the fuse. High resistance in a circuit is what blows fuses.
Posted on Feb 15, 2009
did u look at the fuses under the hood there might be one there other than that sounds like you wiring went bad or the part of your switch is bad replace the switch
Posted on Feb 23, 2009
I found the problem on my Dodge Ram van.. The button for the hazard lights was bad.. I tuned on the hazard lights and only had one side, so i jiggled it and the other side came on. Then I pushed in the hazard button to turn them off and proceeded to check the brake lights, the still did not work so I again jiggled the hazard button and whaaalaaa the brake lights would flicker on and off.. I have a piece of cardboard pushing the button to the side to hold pressure on it keeping my brake light connection until I can get me a new hazzard switch.. Hope this helps..
Posted on Mar 05, 2009
Tips for a great answer:
Apr 01, 2015 | 1994 Toyota Pickup
Feb 16, 2015 | 2000 Saturn Ls 4dr Sedan
Dec 25, 2013 | Cars & Trucks
Jul 24, 2012 | 2007 Toyota Matrix XR
Apr 26, 2010 | 2006 Toyota Corolla
Apr 11, 2009 | 1996 Chevrolet C1500
Dec 11, 2008 | 1997 Mitsubishi Eclipse
Jul 04, 2008 | 1993 Ford Crown Victoria
134 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: