Question about 2001 Ford Taurus

Open Question

Ground strap locations on a 2001 ford taurus

The ground strap locations under the hood of a 2001 Ford Taurus

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

keemo68
  • 1263 Answers

SOURCE: Fuse for the radio on a 2001 Ford Taurus

do you have a owners manual? this will show the location and the purpose of each fuse and relay. the radio fuse should be red in color and be located in the fuse panel on the drivers side it is a 15 amp and is red in color... hope this helps you...please rate this thanks

Posted on Sep 02, 2008

warlock61
  • 659 Answers

SOURCE: need a diagram of the serpentine belt for a 2001 ford taurus

3.0L 2V


8263e1e.gif

Posted on Nov 25, 2008

  • 3 Answers

SOURCE: 2001 ford taurus wont start and anti-theft light is blinking

Either you may be using a key that you had copied from the original or your chip went bad in your original key. Most of cars now a days have the key censor in the key so if it is the incorrect key it will not start your car or if it does not read that chip it will not start

Posted on Feb 05, 2009

  • 84 Answers

SOURCE: need diagram for serpentine belt on 2000 Ford Taurus, 3.0L

http://i28.photobucket.com/albums/c207/jwko/01TaurusBeltDiagram.jpg

Just go to this link and it is there.

Posted on Mar 22, 2009

c17hydro
  • 2984 Answers

SOURCE: how to bleed the brakes for 2001 ford taurus

Please don't forget to rate:


Bleeding The Brake System Bleeding When any part of the hydraulic system has been disconnected for repair or replacement, air enters the lines causing spongy pedal action (because air can be compressed and brake fluid cannot). To correct this condition, it is necessary to bleed the hydraulic system to ensure all air is purged.
Always begin bleeding the brake system from the furthest wheel cylinder or caliper from the master cylinder; the right rear.
NOTE: The right side of the vehicle is the passenger side. The sides of the vehicle are determined from the driver's perspective. This reference is taken from sitting in the driver's seat, facing forward.
Maintain a full reservoir during the bleeding operation. Never use brake fluid that has been drained from the hydraulic system, or from an open container, no matter how clean it is. Always use brake fluid from a new, sealed container. The front and rear reservoir will drain as the front or rear brakes are bled.

  1. Park the vehicle on a level surface. Place the vehicle in PARK (automatic) or REVERSE (manual) with the engine OFF, and apply the parking brake. Chock the rear wheels to prevent vehicle movement. NOTE: Wheel chocks may be purchased at your local auto parts store, or a block of wood cut into wedges may be used.
  2. Loosen the lugnuts from all four wheels, but do not remove the lugnuts until the vehicle is raised and supported properly.
  3. Use an approved jack and raise the vehicle high enough to place jack stands under all four corners of the vehicle. Place the jack stands under the frame or axles of the vehicle. Ensure that the front of the vehicle is raised higher than the rear.
  4. Remove the wheels from the vehicle.
  5. Clean all dirt from around the master cylinder fill cap. Remove the cap and fill the master cylinder with brake fluid until the level is within 1/4 in. (6mm) of the top edge of the reservoir.
  6. Clean the bleeder screws at all four wheels. The bleeder screws are located on the back of the brake backing plate (drum brakes) and at the top of the brake calipers (disc brakes).
  7. Attach a length of rubber hose over the bleeder screw and place the other end of the hose in a plastic jar.
  8. Have an assistant place and hold pressure on the brake pedal.
  9. Open the bleeder screw 1/2 - 3/4 turn. As the bleeder is opened, the brake pedal will travel to the floor. Have the assistant inform you when the pedal has bottomed out. NOTE: Do not remove pressure from the brake pedal once it is bottomed out. No movement to the pedal should occur until the bleeder is closed and the assistant is made aware of the situation. Failure to do this will draw more air into the system.
  10. Close the bleeder screw and tell your assistant remove their foot from the brake pedal. Continue this process to purge all air from the system.
  11. When bubbles cease to appear at the end of the bleeder hose, tighten the bleeder screw and remove the hose.
  12. After bleeding each wheel, check the master cylinder fluid level and add fluid accordingly.
  13. Repeat the bleeding operation at the remaining three wheels, ending with the one closet to the master cylinder. The pattern is, RR, LR, RF, LF.
  14. Fill the master cylinder reservoir to the proper level and install the reservoir cap.

Posted on Jul 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What is the gap for Ford 2001 3 liter Vulcan?


gap is .08 mm or around .050".. Get quality platinum plugs ( dearer) ,fit and forget

Dec 27, 2014 | 2001 Ford Taurus

1 Answer

Where can i locate fuse box for cigarette lighter 2001 Ford Taurus


Hello! The fuse is # 213 (20A) located in the Central Junction Box...The CJB is located under the dash to the right of the brake pedal (between the brake pedal and hood release....Guru...Saailer

Aug 30, 2011 | 2001 Ford Taurus

1 Answer

I got as a bad fuse and i need to know what the fuse is for i have a 2001 ford taurus


Where was the bad fuse located? Under the hood or inside the vehicle?

Mar 27, 2011 | 2001 Ford Taurus

1 Answer

2003 ford Taurus and im trying to locate the fan relay? They don't want to shut off..


UNDER THE HOOD IN THE HARNESS BOX NEXT TO THE BATTERY AND PULL THE COVER OFF ,TURN THE COVER AND IT WILL TELL YOU THE LOCATION OF WHICH ONE

Mar 11, 2011 | 2001 Ford Taurus

1 Answer

Where is the windshield wiper fuse box for 2001 ford taurus


the relay center is located under the hood next to the battery, or jump start post

Mar 01, 2011 | 2001 Ford Taurus

1 Answer

2000 Taurus: Where is the fuse box in my 2000 ford taurus...


The cabin fuse box is located under the dash on the drivers side and the main fuse box is under the hood in the front of the engine above the radiator on the drivers side

May 17, 2010 | 2000 Ford Taurus

1 Answer

Where is the fuse panel on a 2001 ford taurus ?


The fuse panel is located under the drivers side dash, the inside of the cover identifies the fuses in the panel. There are also some fuses in the power distribution box under the hood next to the battery.

Mar 06, 2010 | 2001 Ford Taurus

1 Answer

How do I determine what engine I have for my 2001 Ford Taurus


There should be a white emissions label uder the hood with that information and more look under the hood.

Dec 02, 2009 | 2001 Ford Taurus

1 Answer

Where is the fuse for the fuel pump. Not the reset button but fuse on a 2001 ford Taurus SES. I found the fuse box under the hood but fuses are not labeled.


these are located in the underhood fuse box
Position #16 20A* Fuel Pump Relay
position #30 fuel pump relay fuse.

Nov 13, 2009 | 2001 Ford Taurus

Not finding what you are looking for?
2001 Ford Taurus Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5467 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...