Question about Dodge Ram 150

1 Answer

Location of start-run relay on a 1989 D150

Truck flat died on me. Turns over, gets fuel. No spark. Wires cap plugs and coil all good. Thanks.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 3,103 Answers

Should be on the shock tower in the fender assembly drivers side..

Posted on Dec 28, 2013

  • belairrk
    belairrk Dec 28, 2013

    Thanks, but which one? There are 4 there...

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
roedmondson
  • 68 Answers

SOURCE: 1991 gmc sierra wont start

There are so many things that could have caused this problem to occur. Here are some of my suggestions:

1. Blockage in the air supply to mix with the fuel. Throttle body might need cleaning

2. Compression in the cylinders might be low, probably due to large ring gaps. If you can get your hands on a compression tester to check the compression values of each cylinder, so as to ensure they are in operable range. By the way, was the vehicle smoking heavily when in operation?

3. Is your battery giving a good turn over of the engine? A weak battery can cause an engine not to start. The engine would turn over but just won't start. (Is the engine turning over when you try starting, or does the engine not responding when turning the key?)

4. Igniter in the distributor might need electrical checks to ensure proper electrical circuitry. Liaise with an auto-electrican about this.

Posted on Dec 29, 2008

csmock132
  • 4669 Answers

SOURCE: no fuel no spark 1990 k5 blazer 350

Take off the distributor cap. Check the star wheel that is splined to the distributor shaft that the pick-up coil uses. Make sure this wheel is not loose on the distributor shaft. It is right above the pick-up. If it is loose, replace the distributor. This is a common problem. If it needs one, all the part stores stock the distributor.

Posted on Mar 08, 2009

  • 6982 Answers

SOURCE: 89 s10 blazer no spark

There is no test for module in distributor, but they often cause this kind of problem. Also while in there, check the pickup coil wires to make sure they are intact.

Posted on Mar 14, 2009

ourhowse
  • 2007 Answers

SOURCE: 1998 gmc 4x4 350 vortec ::: problem is when it

Change mass air flow sensor.

Posted on Jul 06, 2009

alicantecoli
  • 22219 Answers

SOURCE: I have 1992 Dodge D150 with 318 magnum. It won't

is this vehicle fitted with a chipped key ?? iam thinking factory immobilisor here?? but not sure what year it was introduced in america

Posted on Nov 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

86 4.3 4BC 1500 Chevy Die rolling up to light Started up and ch of fuel and it died 3 times now no start smell fuel and quit yellow spark Have replaced cap rotor plugs wires EGR coil ECM Rebuilt carb


It sounds more like a fuel problem to me then a bad coil or spark ign the spark should be blue but its hard to see in daylight
You say you rebuilt the carb are you sure your main mixture jets are at least 2 to 3 turns out off the stops .
Try pouring fuel down the barrel fill the float bowl if it runs then dies its fuel don't let it catch unfire you should have 45 sec. of run time then adjust the the mixture screws 2 turns is base but when its is running good turn them in 1 at a time and give it 30 sec. to adjust until it starts to stumble then back it out a 1/4 two 1/2 turn then repeat on bank 2

Nov 23, 2016 | Chevrolet Cars & Trucks

2 Answers

I have a code 13 and the truck cranks really well but will not fire its got a holly tbi on it help??


Dont guess on parts. Cud b coil or ignition module But 13 sez a vacuum issue. Bad egr or idleair can causeit...and will cause no starting.

Jan 31, 2016 | 1991 Dodge D150

2 Answers

I have a 1987 ford ranger the engine turns over but it wont start


Spark at plugs? Fuel filter? Pressure on injector delivery line? Pressure relief valve? You may be able to measure fuel pressure at the pressure relief valve location. and return line. If you have spark, I'd say it's a fuel supply problem

Dec 21, 2014 | Ford Cars & Trucks

1 Answer

1989 D150 no spark.


check under the distributor cap for a hall effect switch but also check the bottom of the rotor for a reluctor ring that might of broken off

Dec 28, 2013 | 1989 Dodge D150

1 Answer

No fuel and no spark


fuel pump , fuel pump relay on fire wall, fuel filter, may all need replaced, pump in tank, inspect all wiring in this circuit, especially all grounds,, grounds get overlooked & that is sometimes the problem. I have a 1988 gmc 2500, I 'm talking from experience. can you hear if fuel pump runs for 2 seconds, when you turn key on ? if not, ground problem or pump problem. relay has a fuse in it, check that. check all fuses. NOW, spark ! coil ? plug wires ? distributor cap & rotor ? replace them if you haven't !!!!!!!!!! get to work, see how you do ! good luck !

Mar 05, 2013 | 1989 GMC K1500

1 Answer

1989 dodge d150. truck will run fine for about 15 minutes then dies. I changed the fuel filter and it still dies. both injectors seem to be pumping fuel. so any ideas.


If you are sure right after the engine dies you have fuel I would think it was the coil going bad see if yiou have spark right after it dies. If you have spark squirt gas into the throuttle body and see if it starts

Feb 09, 2011 | 1989 Dodge D150

4 Answers

Truck doesn't want to drive,


iiT SOUNDS TO BE THE maf sensor. test and or replace. 1st swnsor coming out of air filter.

Jun 14, 2009 | 1989 Dodge D150

2 Answers

1987 Ford Ranger that sparks but wont' start


try to replace the coil and all the spark plugs also make sure that the plugs are gapped right. that info will be on the evaporation sticker onthe core support in the front of the truck under hood. I think it is 0.004 not 100% sure on that. I hope that helps

Mar 29, 2009 | 1987 Ford Ranger

1 Answer

Losing spark


there is a little box that i had above the engine to change in our ford f150 1987 ran just fine after or check spark plug relay

Jan 16, 2009 | 1989 Ford F 150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8499 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...