Question about Cars & Trucks

Open Question

Iveco daily bonnet wont open

Bonnet wont open on a iveco daily truck pull the handle in the cab but wont release

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: can't open quad cab door on 1998 dodge ram 1500

just finished tonight with the same problem on my 2000 ram, i cut the studs out with a drimel tool, and also the latch, with this out of the way the door opened easily,, have to replace bottom latch later . total time about 1 hour tigerhunting

Posted on Nov 07, 2008

Ad
  • 1 Answer

SOURCE: reprogramming blank key iveco daily

Unfortunately there is no solution to this except to take it back to Iveco for reprogramming.

I am led to believe from my locksmith that there are two types of transponders generally put into cars and vans.

The first is a simple chip wtih a code which matches a code in the car / Van

The second is a chip which has a set of codes. They are read in order and the car / van remembers which one was used last. If you use the wrong code in the sequence then the car / van will ignore it and not let you start the engine.

The Iveco is unfortunately in the second group. If, like me, you snap your key, you can superglue a new key to the old and it works fine. The chip doesn't need to be "too" close to the barrel. Yes, it looks ugly, but it's much cheaper!

Posted on Apr 19, 2009

  • 1 Answer

SOURCE: extended cab door won't open on 2000 Silverado

Take the door panel off and reset the rod on the bottom latch

Posted on May 10, 2009

  • 2 Answers

SOURCE: renault clio bonnet wont open

Get a second person to pull bonnet catch and you push up and down on the bonnet whilst catch is being pulled. 1, cable possibly stretched, 2, look at bonnet catch under the coloum to see if wire is attached, 3, try and lie under car and look up the back of the bulkhead to see the catch and release it manually. Hope that helps.

Posted on Aug 17, 2009

smartr10U
  • 1305 Answers

SOURCE: engine hood wont open hood pull handle pulls out but wont release

Try pulling on the hood release, while someone else lifts the hood. If this doesn't work. You can access the underside of the hood release by taking the front grille out. If you look closely you'll see the retainer screws that can be removed from the front. Once the grille is out or loosened enougt to get your hand in behind, you can release the hood latch from the underside with a screwdriver and then repair the hood latch after you've opened it.

Posted on Dec 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

PLEASE HELP! MY HOOD WILL NOT OPEN. HOW DO I GET IT OPEN? I HAVE TRIED THE HOOD RELEASE UNDER DASH & IN FRONT GRILLE


do you know were the cable has snapped front or cab ?
cab you need to use a pair of plyers, front snapped.bit more tricky. and its going to cost you a bit more to just get to the cable and you will need to replace parts on the front.

Feb 23, 2014 | Mercedes-Benz S-Class Cars & Trucks

1 Answer

Front bonnet catch wont release fully,i pull lever from inside and it releases bonnet just a couple inch, then when try to lift bonnet up it wont open. regards mike, and thanks in advance


There is another lever at the front of the car that you need to release too. This is to prevent the hood flying open if you accidentally pull the release while driving. After you release the latch inside the car, go to the front of the car, near the Audi rings in the center of the grill there is a small black tab that pops out. Pull up on it and the hood will open. Let us know if that worked.

Oct 23, 2013 | 2002 Audi A4

1 Answer

The battery of my Renault Scenic is flat, I need to open the bonnet to fit a new battery. How do I do that


There should be a bonnet release handle in the vehicle low and almost under the dashboard. Pulling that handle is the first step. After pulling that handle if you go to the front of the vehicle then under the bonnet there should be an additional handle to move right or left to completely release the hood.

Oct 12, 2013 | 2003 Renault Renault Scenic 1.6

1 Answer

How do you open the bonnet of a 320 clk


Pull the bonnet release inside the car. The bonnet will pop slightly. A plastic handle will appear through the grille just next to the center line near the top. Pull this towards you and lift the bonnet.

Apr 12, 2011 | 2000 Mercedes-Benz CLK

1 Answer

I have a 2003 mecedes benz when i pull the handle on the inside the hood only pops up on one side.


HI there are two bonnet latches and a cable that joins the two together that stretches sometimes or doesnt pull hard enough to open the other side to get the bonnet open pull the release handle and get a freind to slap their hand hard on the bonnet in the rough area of the bonnet catch it should pop open when you do get it open check the operation of the catch with the bonnet up by pushing a screwdriver across the catch to lock it the pull the realease and see if it will open the catch plenty of penetrating oil around the catch and grease after that should get it working again

Feb 23, 2011 | 2001 Mercedes-Benz C-Class

1 Answer

I have a bmw320 the bonnet release handle wont open the bonnet, the handle is ok still has the cable on, how do i open the bonnet??


Did you try with 2 people. one guy pushes down on the hood and then pulls up after the other pulls and holds the release.
Grease the latch every so often to prevent this.

Feb 03, 2010 | 2008 BMW 3 Series

1 Answer

1998 honda crv bonnet wont release to open it what


Try pushing down on the hood while someone else pulls the lever to open the hood. Then lift up and release latch as usual.
Could be broken spring in latch.

Feb 02, 2010 | 2004 Honda CR-V

1 Answer

The pass. side bonnet catch will not release and open the bonnet.


Have someone lift on the bonnet while you pull the release handle.

Nov 06, 2009 | 1997 Mercedes-Benz E-Class

3 Answers

Bonnet cable snapped, need advice on how to open bonnet


Most of the time the cable snaps at the release handle. If you remove the handle and get the end of the cable, you can cut off the cable jacket and use needle nose pliers or vise grips to grab the cable and pull to release bonnet.

May 21, 2009 | 2001 Audi A4

2 Answers

Bonnet will not open


sounds like the cable is broken

May 10, 2009 | 2004 Volkswagen Golf

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...