Question about 2004 Rolls Royce Phantom

Open Question

Air compressor not working - 2004 Rolls Royce Phantom

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Does air conditioning compressor have sensor for 2001 tahoe that can stop compressor from running


all vehicles have a low pressure sincere, to stop compressor if low on freon

Aug 22, 2015 | Cars & Trucks

1 Answer

Help 2008 ford fusion heater and ac stopped working


1) TEST the fuse+ relar of a/c
see the next steps and fix it. God bless you
If so, the compressor is working and the A/C system probably contains enough refrigerant to make cold air, so the problem is inside the HVAC unit. Replace the motor that controls the blend air door (this is a difficult job and best left to a professional since it involves tearing apart the HVAC unit -- about an 8 to 10 hour job!).
If the compressor does not engage when you turn on the A/C, see if it will run by jumping the compressor clutch wire directly to the battery (use a fused jumper wire). If the compressor works when you jump it, and the A/C blows cold air, the system contains refrigerant and the fault is likely a bad A/C compressor clutch relay or a bad clutch cycling switch or pressure switch.
If the compressor does not engage when you jump it, the problem is a bad compressor clutch.
If the clutch engages but the compressor does not turn (the belt will start to slip and squeal), the compressor is locked up and you need a new compressor.
If the compressor clutch engages and turns the compressor, but the A/C still does not blow cold air, the system is probably low on refrigerant and needs to be recharged

10_5_2012_12_00_24_pm.jpg

Oct 05, 2012 | 2008 Ford Fusion

1 Answer

My air conditioner is blowing warm air on the driver side and cold on the passenger side


see this steps and think with clearly and logically NOT feared. God bless you
checkmark.gif Start with the compressor. Does it engage when you turn on the A/C?
If so, the compressor is working and the A/C system probably contains enough refrigerant to make cold air, so the problem is inside the HVAC unit. Replace the motor that controls the blend air door (this is a difficult job and best left to a professional since it involves tearing apart the HVAC unit -- about an 8 to 10 hour job!).
If the compressor does not engage when you turn on the A/C, see if it will run by jumping the compressor clutch wire directly to the battery (use a fused jumper wire). If the compressor works when you jump it, and the A/C blows cold air, the system contains refrigerant and the fault is likely a bad A/C compressor clutch relay or a bad clutch cycling switch or pressure switch.
If the compressor does not engage when you jump it, the problem is a bad compressor clutch.
If the clutch engages but the compressor does not turn (the belt will start to slip and squeal), the compressor is locked up and you need a new compressor.
If the compressor clutch engages and turns the compressor, but the A/C still does not blow cold air, the system is probably low on refrigerant and needs to be recharged.

7_25_2012_8_45_21_am.jpg

Jul 24, 2012 | 2007 GMC Sierra Classic

1 Answer

My air con is not working.it has gas in the system,relay is ok,air con switch is ok but the air con compressor does not turn on when air con is on.when you direct the compressor or brigde the relay,the...


You may have freon in system but compressor won't engage unless it's full under pressure. By jumping the the relay you're doing damage to compressor by running on low pressure. Have system evacuated and recharged to proper amount of freon - usually 4 lbs of freon

Jan 30, 2011 | 1994 Hyundai Excel

1 Answer

My 2002 Expedition air conditioner will sometimes blow hot air and others cold air


I would check the following possibilities:
1. Is compressor clutch working? - You need to do this when the ac is blowing hot air only - locate compressor drive pulley on engine - rubber belt wraps around it. Start engine and set to max ac. When the ac is blowing hot air, look at the center of the compressor drive pulley using a good flash light - watch it for a while, it should be spinning with the pulley - this means the compressor is engaged. If not, the compressor is not engaged. If your ac is blowing hot air, then the compressor should be engaged and running (trying to cool). If it is not engaged, then your compressor clutch is probably going out. Could be low voltage to clutch, but more likely the clutch is worn out and only working some of the time. Note: if working normally, the compressor clutch will engage and disengage in cycles- but the air should always be cold. If clutch is bad, compressor would need to be replaced (sold as one unit). This is tricky to diagnose and could take some time - you need to do it when ac is blowing hot air but set to max cooling.

2. Low on refrigerant or refrigerant has moisture in it? If your ac blows cold initially after being off for a while, then heats up, and continues to regularly cycle back and forth between hot and cool air, then the system may be low on refrigerant or the refrigerant may have moisture in it that is freezing and restricting refrigerant flow. An a/c shop can check refrigerant level and even replace refrigerant if moisture is suspected.

Could be other issues, but I would start with these.

Good luck

May 07, 2010 | 1999 Ford Expedition

2 Answers

I have 94'crown vic with rear air ride suspension problems. The back end won't rise. Any help is appreciated.


Start by checking the fuses for the air compressor for the rear suspension. these will be listed in your owners manual. Failing this it could be the compressor motor or wiring to the motor, unless you can hear the compressor working. If the compressor is running but not adjusting the back of the car then you have an air leak in one of the shocks or air lines.
if you find it is a fuse, also listen for the compressor motor running and an air leak, if the system is running constantly to make up for a leak , that may be what blew the fuse.

Hope this helps
Ed

Mar 29, 2010 | 1994 Ford Crown Victoria

1 Answer

I have a 99 ford expedition i replaced the air compressor cause the front air shocks were bad and ruined the compressor. and teh rear air bags went flat now that the new compressor is in the rear wont air...


I have a 2001 Expedition, I don't have air bags in the front, the compressor don't work the air shocks. You have rear leveling. When they replaced the (compressor) did they turn the leveling switch back on. you may have air shocks connected to the compressor. Did the rear go down right after or over a couple of days. If the switch is on, turn it off and jack the rear up quiet a bit, make sure both side are quiet equal with each other, like it would be if it where raised by the air bags. Turn your level switch back on with it jacked up or sitting on stands. It may have went down so much that the compressor can't raise them back up.

Jan 04, 2010 | 1999 Ford Expedition

1 Answer

2004 Honda Pilot A/C stop working. No clicking sound or cold air


See if it's the compressor by watching the compressor either spinning ( compressor is working ) or not ( compressor not working ). Compressor will not engage if refrigerant is low. Add R-134a ( 12 oz. can )

Sep 08, 2009 | 2008 Honda Pilot

1 Answer

Suspension air compressor


If your compressor is running all the time, it is almost certain that you have a leak. It could be either in the lines going to the rear air bags, or the air bags themselves. Simplest way to find a leak, is to get a spray bottle with soapy water, make sure the suspension is aired up, and spray the lines starting from the compressor. Work all the way back to the bags, now when you get the bags nice and soapy then bounce the rear of the truck up and down. If their are any leaks the soapy water will bubble up showing you wear the leak it.
That is how i would start.

If its a bigger leak the rear air bags wont stay aired up, if its a small leak, then the air compressor will be running all the time to keep the truck aired up.

Remember, when you are driving, the compressor is constantly working to keep the rear bags at the proper height, even more so on rough roads.

Apr 08, 2009 | 2003 Land Rover Discovery

1 Answer

I have 1999 range rover suspention no work


The compressor just could be damage internally .
I would just loose a line off the compressor . Then put power to the compressor again. You should feel air coming out the line.

So if the air is coming out of the line. The system has check valves through out , or the air suspension shocks are probably leaking . I would then take to the dealer for the repairs or your local shop

Good Luck

Mar 30, 2009 | 1999 Land Rover Range Rover

Not finding what you are looking for?
2004 Rolls Royce Phantom Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Rolls Royce Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

907 Answers

Are you a Rolls Royce Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...