Question about Cars & Trucks

1 Answer

Just replaced the fuel pump in my 2000 Pontiac Montana and it will not start. I will say that I had to pull the battery as well and put a new one in(if that has any bearing whatsoever). Any suggestions??

Posted by Anonymous on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 2 Answers

1996 toyota previa brake

Posted on Dec 27, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 24 Answers

SOURCE: Fuel pump not working in 2001 Pontiac Montana

It is always possible that you have a bad pump, it happens. If your sure the pump it not working it could be a number of things. Did you replace the filter (if it has a exterior one)? A clogged filter can trigger premature failure of a fuel pump. It could be a blown fuse or relay. What does the engine do when you turn it over? Does it fire at all?

Posted on Apr 01, 2009

daves944
  • 1050 Answers

SOURCE: 2003 Pontiac Montana Front Wheel Bearings

Remove the wheel, remove the hub nut, remove the brake caliper and rotor, put your socket and extension through the hub flange onto the bearing retainer bolts, undo them, release the abs sensor connector if it has it, remove the bearing and hub flange as an assembly, put the new one on and go backwards from here. Torque the hub nut to 180 ft/lbs, your done.

Posted on Apr 08, 2009

  • 73 Answers

SOURCE: 1999 pontiac montana transport fuel problem

can you jumper the relay or find the red wire by the battery that is nit connected it will have a green connector jump it to positive and see if pump comes on

Posted on Apr 16, 2009

tse22
  • 103 Answers

SOURCE: Changing the starter solenoid on a 2000 Pontiac Montana

On your van the solenoid is attached to the starter. If you can get a solenoid separate (i don't know if you can) then you will need to take the starter off and remove the solenoid (2 screws holding it on) and the wires (on red and one black i believe) pay attention to which wire goes where because you don't want to reverse it on the new solenoid.

Posted on May 12, 2009

  • 240 Answers

SOURCE: how to replace a fuel filter

The fuel filter is located on the drivers side about the mid point of the van inside the frame rail. Loosed the fuel cap to relieve some of the pressure in the fuel system. The filter is held in place by 1 nut (which will probably break off when you try to remove it) and held to the fuel lines on each end by a plastic clip. Pull out these plastic clips with needle nose pliers and pull the fuel lines off. It is easier to understand if you already have the new filter in your hand so you have some idea what these plastic clips look like. Like I said, you will get fuel on you as the lines have fuel in them and well as the filter will be full of fuel.

Posted on Jul 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replaced fuel pump,car won't start


use a code reader to reset the CPU program as replacing the battery sometimes corrupts the program. When you use the code reader see i9f there are any faults recorded and fix what shows up

Dec 27, 2013 | Cars & Trucks

1 Answer

2005 pontiac montana replaced the battery turns over but will not start


It sounds like your fuel pump. Advance auto has a free battery and alternator test.

Feb 27, 2013 | 2005 Pontiac Montana

1 Answer

I replace the crank shaft sensor a 2002 Pontiac Montana it cranked up and ram fine. I did this twice each time letting the van rum 3-5 minutes. the 3rd time it would not crank at all so I put a new


Sounds like an electrical issue likely in the harness that runs from the body to the gas tank or close to the ECM and the wiring may be rubbing against the body close to the ECM and shorting out. Look for lumps in the wires or green corroded connectors.

Nov 24, 2017 | 2000 Pontiac Montana

1 Answer

Is there a fuel pump reset switch for 1999 pontiac montana?and where is it?


It is a very well know fact, that only Ford
Products, have ever had a Fuel Safety Shut Off Switch

Jul 03, 2012 | 1999 Pontiac Montana

1 Answer

How to reset fuel shut off 2000 pontiac montana


There is not a resetable fuel cut off switch on your vehicle. Ford is the only manufacturer that uses these.

If you do not think you have any fuel pressure that you will need to check for power to the fuel pump. If you hit the dog on the drivers side you may have damaged the wireing harness to the fuel pump.

Feb 18, 2012 | 2000 Pontiac Montana

1 Answer

How to change fuel pump 2000 montana


frist you need to empty the gas tank. then place the car on Jack stands.

there is going to be a hose that connected to the gas gas tank near the back of the tank you will have to disconnect that.
I placed a floor jack under the gas tank with a peice of wood between the tank and the jack for support. there are 3 straps that hold the tank up you will need to remove them.

then lower the tank to the floor. there are two hoes that are connect to the fuel pump that need to be disconnected but mark them so that you remember where they go. now disconnect the fuel pump electical plug.

silde the tank from under the car, and unsrew the fuel pump ring and pull the fuel pump out.

place the new fuel pump back in the same way you took it out and reverse the steps that you did to remove it.

you may want to replace the fuel filter also at the same time.

Nov 16, 2011 | 2000 Pontiac Montana

1 Answer

Van won't start


There is a port on your fuel rail,Its like a tire valve push on it a see if fuel is coming out.If it isn't you will need to replace fuel filter first, If you still don't have pressure you are going to have to replace fuel pump.If you can hear the pump it doesn't mean that it is working.It does mean you have elec to it.you need at least 35lbs pressure to fire injectors.You will need to check for spark at spark plugs to.after these test repost and we can solve this problem

Feb 17, 2010 | 2000 Pontiac Montana

1 Answer

My 2000 pontiac montana will start up then immediately die, if i give it gas to try and keep it running it sounds like it backfires through the fuel system


I smell a bad fuel pump.. Easiest way to check this is have someone turn the key but not actually start the car and you stand near the tank to listen for the humming sound a pump usually makes as it pressurizes the system. If you hear the humming sound then check the pumps PSI and see if it holds. Good luck

Dec 07, 2009 | 2000 Pontiac Montana

2 Answers

1999 pontiac montana transport fuel problem


can you jumper the relay or find the red wire by the battery that is nit connected it will have a green connector jump it to positive and see if pump comes on

Apr 16, 2009 | 1999 Pontiac Montana

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...