Question about 1996 Land Rover Discovery

1 Answer

The discovery start and idee very well, but i have to wait until the rover reach the normal hotes driving condition

If the rover is running very well, but i drive over water the cold down a little and the problem start over

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 338 Answers

Engine temperature sensor faulty, not supplying correct quantity of fuel to a cooler engine, wrong cold start supply mixture.

Posted on Dec 28, 2013

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 16 Answers

SOURCE: Starts fine when cold, after running dies on idle then wont start

Sounds like the fuel filter is dirty and needing to be changed. It's cheap and easy to swap out.

Posted on Jan 12, 2009

voodoomox
  • 1689 Answers

SOURCE: 1998 Land Rover Discovery Series 1

You can energise the interlock solenoid, by you give a positive (+12V) lead to the RED and a negative (ground) to the black line at the transmission selector's connector.
If it works you should check the positive signal at the red.
It should be there if the ignition is on, brake pedal depressed, and the transfer box is in some gear, and the fuse 1 isn't blown.
At the black cable should be a ground signal if the selector in 'P' position.
If you give me an e-mail address I'll send the wiring.

The ABS problem, you have better to check followings.
- All the wheels bearings' play.
- are the ABS sensors at the deepst position? Knock some to that head (not strong) and they shouldn't move deeper.

-land rover repair

Posted on Jul 26, 2008

  • 1 Answer

SOURCE: my land rover discovery is stuck in 4 wheel drive,

The discovery is as previously mentioned permanent four wheel drive.However the difflock/range lever in most suffers from lack of use and siezes all i had to do when i bought mine was plenty of WD40 and patience as i don't think it had been in low range or difflock from the day it was built.don't try to force it just spray it and let it soak then try keep doing this and it should free up if not it may be the selector grubscrew has worked loose just threadlock it and screw it back in.

Posted on Feb 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have just purchased a 2004 Land Rover Discovery. My Cooling fan continues running after car is turned off. Is this normal?


This is normal. If the coolant is warm, the cooling fan continues to run until it's brought down to an acceptable temperature.

Jul 22, 2017 | Land Rover Cars & Trucks

1 Answer

Suggested Solution 2002 Land Rover Discovery Series II Logo Problem with 2002 Discovery Series II Starts fine when cold, after running dies on idle then wont start 2002 land rover discovery, starts fine...


The ignition system is controlled by the ECM. Check power at fuse box in on right side under dash. Check fuses right side engine compartmentlower dash panel if all OK check power to ECM located right side "A" pillar in alloy box. this unit could be faulty if no spark at coils, assuming they have been connected correctly. may have to get tested for codes at L/R dealer or someone with test tool. Another source of problem may well be flat battery in transponder key. The indicator light on the dash willflash rapidly for 10 seconds if the vehicle has been unlocked with the remote and the drivers door is opened if the battery in remote is getting low

Dec 02, 2012 | 2004 Land Rover Discovery

1 Answer

Good afternoon, i drive a 2003 discovery (108k miles) over the last 2 days it has developed an issue where by when accelerating it splutters, it is like when you are running out of fual, or like the...


Dear Sir,
As you said problem starts after long run , it can cause due to air filter jam please clean it it will become normal, due to dusty condition it ma got jam. not enough air is getting in side for proper combustion , clean air filter if any problem let me know Thanks.

Yogesh

Dec 15, 2010 | 2003 Land Rover Discovery

1 Answer

Wont start after overheting


plugs out again crank over and see if any water comes out of the pots compression test all pots sounds like head gasket bad luck make sure you fix the low water level fault as well leaking rad or split hose

Jun 06, 2010 | Land Rover Discovery Cars & Trucks

1 Answer

Starts fine when cold, after running dies on idle then wont start


Sounds like the fuel filter is dirty and needing to be changed. It's cheap and easy to swap out.

Jan 12, 2009 | 2002 Land Rover Discovery Series II

Not finding what you are looking for?
1996 Land Rover Discovery Logo

96 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76070 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...