Question about Cars & Trucks

Open Question



Posted by Anonymous on


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I'm looking for a code identifier

Definition of check engine code P1792:
TRANS EEPROM Checksum Error
Battery power was disconnected since last power down
Barometer Pressure Circuit Malfunction
Barometer Pressure Circuit Malfunction
Transmission Control Module Reprogrammable Memory
Problem in Engine Coolant Temperature (ECT) Sensor Circuit
Trans EEPROM Checksum Error
Ignition Supply Malfunction
Ignition Supply Malfunction
Barometer Pressure Circuit
CAN data bus,ECMITCM communication - malfunction detected
Transmission Range Display Circ. Short to B +
Transmission Range Display Circ. Short to B +

Dec 13, 2015 | Cars & Trucks

1 Answer

Check engine light is on and diagnatics show the error codes, P0722 and U2108

Definition of Diagnostic Trouble Code U2108 Buick: CAN Bus Error ABS Cadillac: CAN Bus Error ABS Chevrolet: CAN Bus Error ABS GMC: CAN Bus Error ABS Oldsmobile: CAN Bus Error ABS Pontiac: CAN Bus Error ABS Saturn: CAN Bus Error ABS

Definition of Diagnostic Trouble Code P0722 Category: Powertrain Definition: Output Speed Sensor Circuit No SignalNote: This definition of P0722 is applied to all manufacturers

Jun 27, 2015 | Cars & Trucks

1 Answer

How do I obtain a list of the ABS fault codes/ definition and diagnostic procedures

Try this: But there is not a lot of information on brake systems because of the liability and royalties that are involved.

Feb 25, 2015 | Cars & Trucks

1 Answer

Dtc c1073

depends on the car im guessing that the chrysler one is the one ur looking forChrysler:ABS Pump Motor Control CircuitDodge:ABS Pump Motor Control CircuitJeep:ABS Pump Motor Control CircuitFord:LR ABS Valve coil short to ground.Mercury:LR ABS Valve coil short to ground.Lincoln:LR ABS Valve coil short to ground.Mazda:LR ABS Valve coil short to ground

Nov 18, 2012 | Mitsubishi Cars & Trucks

1 Answer

97 chevy silverado Z71 5.7 abs lite came on after son did the brakes how do i fix it?

last time I replaced a wheel cylinder on one of those I had to pressure bleed the air out 12 times ( a record i must say) and no my normal method of vac bleeding fluid did not work at all , Im guessing it's got to do with gm's abs "motor" this all arrumes that son did not dammage wheel speed sensor too
a code ck will tell all

Jun 21, 2012 | Cars & Trucks

2 Answers

Replaced Wheel Speed Sensors ABS light still comes on

Yes you can you jump[ terminal A and B and count the number of flashes this will be the code You are a OBD 1 two ways of doing this is a analog voltmeter (count the sweeps) or count the light flashes and match it with the code

Mar 12, 2012 | 1992 Pontiac Sunbird

1 Answer

1998 528i how to fix code po733 and abs light is on also it came on when this code came up to

P0733 definition is incorrect 3rd gear ratio. when this code comes on or any CK engine light. ABS, TRAC,( if equipt) are disabled, You mainly have a transmission failure. Your solution is a good transmission.

Feb 26, 2012 | 1998 BMW 5 Series

1 Answer

Im looking for the definition to code U0100.

U0100 - Lost Communication With Engine Control Module (ECM)

Jan 30, 2011 | Chevrolet Aveo Cars & Trucks

2 Answers

I have a 1989 s-10.The parking brake light blinks six times,pauses then flashes again.I was wondering what trouble code that would be???Thanks.

RWAL Fault codes
Codes for Dodge RWAL, Ford RABS and GM RWAL applications are similar but have a few differences:
  1. Should not occur (replace the controller if it does)
  2. Open isolation valve circuit or defective ABS module
  3. Open dump valve circuit or defective ABS module
  4. Grounded or closed RABS or RWAL valve switch
  5. Excessive actuations of dump valve during ABS braking
  6. Erratic speed sensor signal
  7. Shorted isolation valve or defective ABS module
  8. Shorter dump valve or defective ABS module
  9. High resistance or open speed sensor circuit (resistance should be 1000 to 2500 ohms)
  10. Low speed sensor resistance (Dodge & Ford only)
  11. Open speed sensor circuit (GM only)
  12. Stop lamp switch circuit (Dodge & Ford)
  13. ABS module speed processor (Dodge & Ford only)
  14. ABS module program (Dodge & Ford only)
  15. ABS module RAM memory failure (Dodge & Ford)
To manually clear a stored fault code on GM and some Dodge trucks with RWAL, remove the ABS fuse or disconnect the battery for 5 seconds. Ford RABS codes will automatically clear when the ignition is turned to the off position.

Aug 26, 2008 | Chevrolet S 10 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

659 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

80407 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15273 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides