Question about 2006 Ford F-250 Super Duty

Open Question

Tow haul light is flashing and truck is stalling

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
leetamara
  • 702 Answers

SOURCE: Towing an F-150 behind a U-haul Truck

If you're using a tow bar, make sure that the driveline(s) are disconnected and removed or tied up. If you don't disconnect the driveline(s) you really run a huge risk of transmission damage whether it's auto or manual.

Posted on Jun 24, 2008

Ad
cj2176
  • 520 Answers

SOURCE: 03 f-350 trans hot

I would begin by checking the transmission fluid level. If it's ok, then that means that your transmission has overheated. Have it checked for overheating damage by a professional transmission shop. If everything checks out ok have them add a secondary transmission cooler. This will allow the transmission to cool down faster under heavy hauling conditions. Hope this helps, good luck!

Posted on May 08, 2009

  • 1 Answer

SOURCE: Want to know the towing capacity for our truck

First off the 1997 F-250 HD with a 4.10 rear end will haul 14,900 lbs. The real question is do you have a receiver hitch or the rear bumper hitch. If you have the rear bumper hitch buy a receiver hitch that mounts to the frame a class 5 is usually put on these trucks. However a class 4 will work just fine for 6,000 lbs. The receiver hitch will have the capacity stated right on the hitch you just bend over and read it. It will give you two ratings one with weight distribution device and one without. You will be looking at the one without. That will fall somewhere between 6,000 and 12,000 lbs depending on the hitch manufacturer and the class. Hope this helps.

Posted on May 28, 2009

  • 122 Answers

SOURCE: my f250 check gauge light is on, the tow/haul

check the bulk connector for for dirt, bent pins, water, corrosion and a good solid connection

Posted on Aug 20, 2009

  • 49 Answers

SOURCE: tow/haul light comes on gauge shows HOT

Does the trans fluid have a burnt smell and is it brown or dark brown as opposed to a red wine color? If this is the case then you may have a service issue caused by a clogged trans filter which is what this sounds a great deal like and the sooner you get the truck to the dealer or your mechanic the better as the trans in these are not cheap to rebuild or replace.

Posted on Aug 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 jeep commander tow/haul flashing on off why?


lost the oper guide on this?
its free from 2004 to NOW.

posted now 100s of time,

http://www.jeep.com/en/owners/manuals/

read page 181 pd.
its right there all the time in the glove box.
hint
HAUL button

Apr 10, 2016 | 2007 Jeep Commander 5.7

1 Answer

What would cause my TAHOE TOW/HAUL mode to engage on its own?


You need to have a diagnostic scan tool hooked up ,glitch in one of the control modules or a wire in the circuit shorting to ground ! probably something simple but hard to find ! With a factory scan tool they can check the input signal to the BCM ,PCM .
Tow/Haul mode enables the operator to achieve enhanced shift performance when towing or hauling a load. When tow/haul mode is selected, the tow/haul switch input signal to the body control module (BCM) is momentarily toggled to zero volts. This signals the powertrain control module (PCM) or transmission control module (TCM) to extend the length of time between upshifts and increase transmission line pressure. Cycling the tow/haul switch again, or cycling the ignition switch disables tow/haul mode and returns the transmission to a normal shift pattern.

Sep 23, 2015 | Cars & Trucks

1 Answer

2004 ford f250 superduty 6.0L dsl tow haul light flashing and doesnt want to go into reverse


That light means that the shift points have changed on the transmission. This is to get better economy when hauling. If it wont stop flashing then there is a valve in the transmission that is bad or sticking. You will have to have it removed and overhauled..

Dec 12, 2013 | 2003 Ford F350 Super Duty DRW SuperCab

1 Answer

TOW/HAUL Indicator Light jeep cherokee 2005


Th e tow haul button is so if your towing a heavy trailer its easier on the tranny when you hit the button you generally dont need to use it for everyday regular driving.

Apr 15, 2013 | 2005 Jeep Grand Cherokee

1 Answer

I have a 2004 tahoe and this light came on i don't


That is the Tow/Haul indicator. Button on the end of shift selector was most likely depressed during shift or possibly a malfunction with the tow/haul mode selection system. (IE: Tow/Haul button)

Jan 14, 2013 | Cars & Trucks

1 Answer

Tow haul flashing,shifts like the tow haul buttons been pushed,but shift hard


If that light is flashing that means there is a problem with the trany. If you continue to drive it, it will damage the trany. I suggest you get it into a trany shop as soon as possible. I guess, I would take it to a private shop, that specializes in automatic transmissions, instead of taking it to a dealer.

Jan 24, 2010 | 2003 Ford F350 Super Duty DRW SuperCab

1 Answer

2004 f350 6.0 diesel- tow haul light flashing sets stuck in tow haul and wont shift to overdrive


climb under the truck! on the drivers side of the trans in the neutral safty swith unplug it and look for rotted connectors! if so repair damage! second go to passengerside near the rear of the trans ull see a plate that s being held by 2 7 or 8 mm bolts remove plate ! behind the plate there will b another plug do the same! inspect for corrosion

Dec 24, 2009 | 2004 Ford F350

2 Answers

Transmission tow/haul mode


Hi, the problem is when you are tilting the steering wheel all the way up it's putting to much tenstion on the wires that come outof your shifter that run to the tow/haul button. i am 99% sure your wires are disconected. rewire them and add some extra wire so next time there will be more slack in your wires.

Jul 20, 2008 | 2001 Chevrolet Silverado 2500HD

Not finding what you are looking for?
2006 Ford F-250 Super Duty Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...