Question about Cars & Trucks

Open Question

Fault code TE501 - Cars & Trucks

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I fix code 13 engine speed sensor Above 1000 rpm


Clearing the codes is simple that is done by removing the fuse of the EFI from junction box 2 for 10 seconds. Make sure to remove the jumper wire and switch the key off before clearing the codes.

Here are some common Lexus vehicles 1990-1995 codes:

Code 12 and Code 13 Rpm signal circuit fault
Code 14 Igniter signal circuit fault
Code 16 ECT control signal fault
Code 21 and Code 28 Main oxygen sensor fault (for ES300; SC300 & GS300 models)
Code 22 Coolant temperature circuit fault
Code 24 Intake temperature sensor circuit fault
Code 25 and Code 26 Air fuel ratio fault (for ES300 & SC300 models)
Code 27 Sub-oxygen sensor circuit fault (for ES300 CA & GS300 models)
Code 31 Low airflow meter voltage (for ES300 and GS300 models)
Code 32 High airflow meter voltage (for ES300 model)
Code 35 Barometric pressure sensor circuit fault (for GS300 & SC300 models)
Code 41 and Code 47 Throttle position sensor circuit fault
Code 42 Vehicle speed sensor circuit fault
Code 43 Starter signal
Code 51 Switch condition signal fault (for ES300; GS300 & SC300 models)
Code 52 Code 52 and Code 55 Knock sensor circuit fault
Code 71 EGR system circuit fault (for ES300; GS300 & SC300 models)
Code 78 Fuel pump control circuit fault (for GS300 & SC300 models)

Nov 18, 2014 | 1990 Lexus LS 400

Tip

?JCB FAULT CODES LIST


P0087 (flashing code 227) shared sump low pressure fault (for pump without pressure supply)
The main fault symptoms
• Engine severe vibration.
• idling unstable
• Output Fall
• exhaust smoke
• It may be too large output
P0088 (flashing code 118) shared the tank pressure is abnormally high (first or second stage)
The main fault symptoms
• Engine severe vibration
• idle instability
• Output Fall
• channeling gas engine failure
• exhaust smoke
• It may be too large output
P0089 (flashing code 151) shared the tank pressure failure (for pump pressure supply is too large)
The main fault symptoms
• Engine severe vibration
• idle instability
• Output Fall
• channeling gas engine failure
• exhaust smoke
• It may be too large output
P0090 (flashing code 247) SCV drive system open, + B short circuit or shorted to ground
The main fault symptoms
• Depending on the open / short situations, there may be an engine stall and / or launch
Machine channeling gas.
• exhaust smoke
• Output is too large
P0107 (flashing code 71) atmospheric pressure sensor circuit input low (open or shorted to ground)
The main fault symptoms
Due to spare the equivalent altitude 2000 m (6562 ft)
• exhaust smoke at high altitude.
• insufficient output at low altitude
P0108 (flashing code 71) atmospheric pressure sensor circuit input high (+ 5V shorted)
The main fault symptoms
Due to spare the equivalent altitude 2000 m (6562 ft)
• The high altitude exhaust smoke
• lack of low altitude output
P0112 (flashing code 22) intake air temperature sensor fault (low voltage fault, earth fault, short circuit)
The main fault symptoms
• When cold starting, may exhaust white smoke.

More here http://truckmanual.weebly.com/jcb-fault-codes.html

on Dec 20, 2016 | Cars & Trucks

1 Answer

Fault codes 01423 and 01425 and fault code 17664


all the code need a latter In front. all of my books and scan tool
and my mitchell1 ondemand call for a latter

Aug 29, 2013 | 2000 Volkswagen Passat 4Motion

1 Answer

I have audi Q5 2010 model i have a fault code to the transmission i dont know what is this P1f68


HI,
Strongly suggest taking to the dealer as it should still be under warranty.

Code info I googled:

OBD II Fault Code P1F68 :Description of OBD II Fault code P1F68

TH2TNK Sensor Value Offset Shifting
Possible failuer of OBD II Fault code P1F68

  • Hydrogen Tank Internal Temperature Sensor (TH2TNK) offset shifting
  • Inlet Air Temperature Sensor (TA) offset shifting
  • Offset shifting of both Teperature Sensor (TH2TNK) and Inlet Air Temperature Sensor (TA) in Hydrogen Tank
  • RTC function error (Miscalculated Soak Time)
  • FSVSCM failure
  • FCCM failure
Diagnostic Procedure using AutoHex auto Scan tool tester
  • The rear average wheel speed > 15km/h and vehicle speed on the meter<1km/h
  • If the rear average wheel speed > 15km/h and VSP<1km/h lasts for 0.3 seconds, the malfunction is determined.
Test Conditions using AutoHex Scan tool tester
  • Vehicle speed / wheel speed is normal
  • Brake is out of action
  • The automatic brake is out of action
Clear Fault codes Conditions
  • The rear average wheel speed > 15km/h and vehicle speed on the meter<1km/h
  • If the rear average wheel speed > 15km/h and VSP<1km/h lasts for 0.3 seconds, the malfunction is determined.
MIL Status
  • Glow ON


Note:
  • AutoHex is a professional OBD /OBD II diagnostic scanner / scan tool tester.
  • This fault code is a GERENRIC fault code, some cars may change the meaning of this fault code.
    To get the accurate fault code description you may use AutoHex OBD scanner

Oct 24, 2012 | 2010 Audi Q5

1 Answer

Truck will be running fine, then all of a sudden it will completely shut off. After we wait a few minutes and pump the clutch and make sure it is all the way to the floor it will start, sometimes. S


You need the engine computer scanned for fault codes, i thank you have an ignition control problem like a module or distributor pickup coil issue. These parts whenthey fail should leave fault cdes so get them read.
Next, the check engine light will pause shortly followed by the second digit of the trouble code. For example if the check engine light blinks once and pauses followed by six blinks the trouble code number would be 16. If no code is present the check engine light will stay one constantly. To restart code gathering turn the ignition key to the "off" position, wait three minutes and turn the ignition key back "on" again without starting the engine. Remove the jumper wire once code gathering is complete. To clear code after the repairs have been made remove the negative battery cable for one minute and reconnect.
toyota_dianostic_connector.jpg
Toyota Diagnostic Connector
Toyota Code Definition Table
Code 11 Momentary interruption in power supply to ECU (electronic control unit or computer) up to 1991
Code 12 Engine revolution signal missing Code 13 Rpm signal to ecu missing above 1000 rpm
Code 14 Igniter signal to ecu missing
Code 16 A/T control signal missing from ecu
Code 21 Main oxygen sensor signal fault
Code 22 Water temperature sensor circuit fault
Code 23 and 24 Intake air temperature signal fault
Code 25 Air/fuel ratio LEAN
Code 26 Air/fuel ratio RICH
Code 27 Sub-oxygen sensor signal or heater circuit fault
Code 28 No. 2 oxygen sensor/heater signal fault
Code 31 and 32 Air flow meter circuit or Vacuum sensor signal fault Code 34 and 36 Turbo-charging pressure signal fault
Code 35 Altitude compensation sensor signal fault
Code 41 Throttle position circuit fault
Code 42 Vehicle speed sensor circuit
Code 43 No starter signal to the ecu
Code 51 AC signal on; DL contact off (in transmission shifter with diagnostic connector jumped)
Code 52, 53 and 55 Knock sensor fault Code 71 EGR system malfunction
Code 72 Fuel cut solenoid signal fault
Code 78 Fuel pump control signal fault
Code 81, 83, 84 and 85 TCM communication fault

Jun 28, 2012 | Cars & Trucks

1 Answer

Abs fault light, engine management light, parkbrake fault (won't go off) DSC fault light, air suspension fault, 2003 Jaguar 3.5 SC V8, ah also discovered water ingress in boot, quite a lot!!, only fault...


try disconnecting the battery both leads and join them together for 5 mins and see what happens cannot find this fault code in teh jaguar OBD codes so consult with teh code reader manufacturers

Feb 08, 2011 | 2003 Jaguar XJ-Series

1 Answer

1996 jaguar xj6 dtc test code p1178


Fault code P1178Rich Fuelling Trim, Long Term (AMFR)Check for manifold air leaks, rectify as necessary Check for recorded MAFS fault code, rectify as necessary Clear fault code and perform service drive cycle to verify fault cleared Contact Jaguar Service Hotline if fault still present.

Taken from the Jag service manual.

Feb 26, 2010 | 1995 Jaguar XJ6

1 Answer

Trouble Codes


1. VW VAG type 5 digit fault code 19497 = EOBD type P3041 fault code:
Fault location = CAN data bus, instrumentation - implausible Engine Coolant Temperature (ECT) signal
Probable cause = Wiring, matching resistor in Engine Control Module (ECM)

2. VW VAG type 5 digit fault code 18032 = EOBD type P1624 fault code:
Fault location = Malfunction Indicator Lamp (MIL) - request signal active
Probable cause = Trouble code(s) stored in other system(s)

3. VW VAG type 5 digit fault code 01039:
Fault location = Coolant Temperature Sensor (G2)
Probable cause = Open or Short to Plus, Short to Ground - Intermittent

4. VW VAG type 5 digit fault code 01304:
Fault location = Radio
Probable cause = No Communication

5. EOBD type P0761 fault code:
Fault location = Shift Solenoid C
Probable cause = Performance or Stuck OFF

Feb 03, 2010 | 2002 Audi A4

2 Answers

Check engine light on 1998 Z3 BMW


BMW engine light

Comes on if DME engine management system self diagnostic fault detected. Will stay on until codes are called up and memory erased.

With OBD read the code as follows. Turn on ignition key, press accelerator pedal to the floor five times within 5 seconds. The check engine light will remain on for 5 sec , blik off, come on for 2,5 sec, go off for 2,5 sec and fault code will begin to flash. If more than one fault exist 2nd fault code will be separated by 2,5 sec pause. after fault codes there will be a 0.5 sec flash and light will remain off. to read codes again do procedure again.

Canceling of codes. make sure fault code is present (short blink and light goes out for long period), depress throttle pedal for at least 10 sec. read fault codes again and check for code 1444 (no faults stored.)

Check also the following, fuel pump, oxygen sensor, fuel injectors, engine coolant temp sensor, idle speed control valve, mass airflow sensor and too many other things.

Jun 16, 2009 | 1998 BMW Z3 Roadster

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...