Question about 1997 Mercury Tracer

Open Question

Remove back seat from 1997 tracer mercury - 1997 Mercury Tracer

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
shaggyrat
  • 1224 Answers

SOURCE: Rear seat removal 2000 merc Villager

fold top seat down first
then there is seat clip push seat forward with upward motion
this releases back floor clamps once released pull seat back this releases the front clamps then pull seat out of back door

Posted on Jul 07, 2008

Ad
Mike258
  • 1498 Answers

SOURCE: serpentine belt for 1998 mercury tracer

Hey there MSM,

  • Get a 14mm or 9/16" socket and a long handled ratchet or breaker bar.
  • Get the belt around all the pulleys except the A/C compressor or Alternator. The routing diagram is on one of the radiator supports.
  • The tensioner pulley is near the Alternator toward the center of the engine. It's on a spring loaded arm. Get your socket on the center nut of this pulley.
  • Slowly pull the ratchet toward the center of the engine. The pulley will pivot on the arm allowing you to get the belt on the final pulley.
  • Slowly release the tension.
  • You're done
Mike

Posted on Dec 14, 2008

  • 187 Answers

SOURCE: rear brake drum removal 1992 mercury tracer

Yes. and than the drum will come off. You will find that it will not move at first so take a hammer and tap, not slam, around the edge of the drum to brake the rust. It you have difficulty removing the 2 screws don't strip the heads. Take your screw driver and put it in the slot than tip it at an angle and hit the end with a hammer to apply force sideways to the screw. This will, in most cases, brake the rust and permit the screw to turn.

Posted on May 07, 2009

  • 55 Answers

SOURCE: How do you remove the fuel pump from the fuel

only two things it can be. one would be that the ground strap is still atached, the other thing is the gasket under the pump has welded the two together. in this case, if your sure you have the retaining ring all the way loose, tap pump with a brass hammer(only!) then work it loose. good luck.

Posted on Jul 17, 2009

emissionwiz
  • 76848 Answers

SOURCE: Where is the starter in a 1997 Mercury Tracer?

bottom rear of the engine at the transmission bell housing, the starter is removed from under the car.

Posted on Oct 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to put timing belt on 1997 mercury tracer


1.9 l and 2.0 l are the same remove fan belt and remove belt tensioner remove timing cover (2) 10 mm nuts rotate to TDC a small "o" on lower gear and round hole with a point in it for the cam gear that lines up with "o" on cylinder head check with a mirror. loosen tensioner bolt 13 mm and slide to loosen belt remove crank shaft pulley to get belt off crank shaft and reassemble in reverse.

Apr 19, 2014 | 1997 Mercury Tracer

1 Answer

1997 mercury tracer o2 sensor removal


Replacement of oxygen sensors on a 1997 Mercury Tracer LS. Sell the Tracer and buy a Ford Focus, or 2010 Chevy Cobalt, or a new Chevy Cruze, or a Ford Fiesta. This solution is best if your Tracer has over 130,000 miles on it.

Feb 16, 2012 | 1997 Mercury Tracer

1 Answer

I have a 1993 Mercury Topaz that I just bought, and the drivers side seat will not move forward, it will go in all other directions, but won't move forward...any suggestions?


There are 3 electric motors on the seat. One is forward and back, one is front up and down, and one is rear up and down. The switch changes the polarity back and forth to achieve the proper movement. I think the wire color for the forward and back motor is yellow with a white tracer and red with a white tracer. so if the switch gives the motor positive voltage to the yellow with a white tracer and grounds the red with a white tracer the seat moves forward. If the switch gives the red with a white tracer positive and the yellow with a white tracer ground the seat moves back. (or the other way around). So we can safely say it is in the switch.
Good luck and God Bless

Jun 06, 2011 | 1993 Mercury Topaz

1 Answer

Where is the pcm located on a 1997 mercury tracer?


Hello Rippgut.
The PCM is mounted in the console.
The park brake and shifter console needs to be removed to access it.
Also the 4 screws that hold down the shifter need to be removed.

I hope your repair goes well.
Thank you for using FixYa.
KL

Mar 01, 2011 | 1997 Mercury Tracer

1 Answer

How do you change a tail light bulb on a 1997 mercury tracer?


is there a special tool needed to remove clamps they wont come out

Sep 24, 2010 | 1997 Mercury Tracer

1 Answer

Where is the starter in a 1997 Mercury Tracer?


bottom rear of the engine at the transmission bell housing, the starter is removed from under the car.

Oct 28, 2009 | 1994 Mercury Tracer

2 Answers

Broken odometer 97 Mercury Tracer


It is easier to contact your Mercury dealership to ask this question but I have changed many odometers out throughout the years and sometimes the dealerships frown on having to give you a new one because of the fact you could lie about your mileage and actually set back the miles which is against the law in many states. Sometimes the dealerships don't have a problem at all and will send off for a new one at a cost between $200. to $400.00 on the average.

Jul 28, 2009 | 1994 Mercury Cougar

Not finding what you are looking for?
1997 Mercury Tracer Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

fordexpert

Level 3 Expert

5546 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...