Question about Cars & Trucks

Open Question

2008 chrysler aspen check engine codes p3425 and p3441

Where is the multi displacement system unit located

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

miket756
  • 2702 Answers

SOURCE: where is oil sending unit location on 1999 chrysler cirrus 2.4 ?

most likley place is on the engine block look for it there

Posted on Oct 24, 2009

greezy_je208
  • 237 Answers

SOURCE: WHERE IS THE FUSE FOR THE BACK UP SENSOR, LOCATED

under the hood.

Posted on Dec 16, 2009

localwonder
  • 6784 Answers

SOURCE: trying to locate the button to turn off my check

HI. There is no such button present in your vehicle. There are only two ways to shutdown the check engine light. These options will only shutdown the light, temporally. The first option will be to power off your cabin radio, and pull the positive battery cable for 10 minutes. This will reset the CPU, thus , resetting the Memory. The code will be stored, and the light will shutdown for a short time. The second option will be to plug a diagnostic CPU into the diagnostic port, under the dash. This CPU will pull the codes, and give you the option to clear the alert. You must know that once the codes are clear, the CPU will notice the issue once more, during highway driving. Once this is noticed, the Check engine light will illuminate again.

In order to solve the issue, it is recommend to have the codes pulled. Once you have the codes, you will be able to isolate the problem area and have it repaired. This will permanently shutdown the check engine light, until the next error is discovered.

Posted on Jan 02, 2010

  • 197 Answers

SOURCE: What does a Fault code of P0456 mean on a 2007

I would ask the Chrysler dealer, probably quicker than asking anyone else.

Posted on Sep 11, 2010

  • 869 Answers

SOURCE: Problem getting tire off of

make sure u r using the right tire and rim on your chrysler aspen. they should have 18x8 wheels with steel spare wheel and P265/60R18 109S tires all terrain tires.

Posted on May 02, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

WHERE IS THE FUEL PUMP ON/OFF SWITCH FOR 2008 CHRYSLER ASPEN SUV


The on/off switch is where you insert the key in. Have the codes read and check fuel pressure. have never replaced an inertia switch..

Sep 24, 2016 | 2008 Chrysler Aspen

1 Answer

Whats the answer for U1120 engine diagnostic on 2008 Chrysler Aspen?


Lizzie, U1120 means the PCM doesn't receive a vehicle speed signal from the Anti-lock brake Module over the CAN C bus. You may have to have a good tech. diagnose and estimate repair. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
U1120 Engine Diagnostic Code For 2008 Chrysler Aspen
Error Code U1110 and U1120 Chrysler Forum Chrysler Enthusiast Forums
HELP Codes U1120 U0121

Aug 11, 2016 | Chrysler Cars & Trucks

1 Answer

Where is the air idle control on the 2008 Chrysler aspen?


They did away with them when they started using the drive by wire system. Electronic throttle.

Apr 13, 2016 | 2008 Chrysler Aspen

1 Answer

What are the probable causes of DTC P0440?


Code 440 is for a general failure of the EVAP system which is the vent system for the gas tank.
The engine computer checks the system every few minutes and if it detects a leak the check engine light comes on. The light tells the driver there is a problem and to get it checked out.
You would need a shop manual to get all of the testing procedures for the system and you would need to check for leaks.

Apr 01, 2016 | 2008 Chrysler Aspen

1 Answer

How can troubleshoot the Code P3425, there is a warnig let in the screen


Definition of Diagnostic Trouble Code P3425 Category: Powertrain Definition: Cylinder 4 Deactivation/Intake Valve Control Circuit/OpenNote: This definition of P3425 is applied to all manufacturers

Jul 15, 2015 | 2007 Chrysler Aspen

1 Answer

E vap system


Where is the EVAP System at under the body of a 2008 Chrysler Aspen ??meed to check the lins for small leak???

Aug 13, 2013 | 2008 Chrysler Aspen

1 Answer

I had to get my aspen jumped and now I have a yellow enqine light on


The check engine light may be on from low volts from your battery... Try disconnecting your NEG battery cable for a few (about 5) minutes to reset the computer and see what that leads to...If your check engine light comes back on take it and have it scanned to see what codes it is throwing..

Sep 15, 2011 | 2008 Chrysler Aspen

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

334 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...