Question about Chevrolet Express

Open Question

2008 cargo van 2500 door ajar sensor

Door ajar light on

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
468 Chevelle
  • 81 Answers

SOURCE: how to change fuel pump in 97 chevy 2500 (cargo

You have to drop the fuel tank. It is inside. Hope the tank is near empty, remove the 2 fuel fill hoses, you have two straps, lower tank, remove 3 wire connectors, and several more lines. Please use an ac delco fuel pump module. It may come updated with a new wiring connector to fix the old ones problem. If it does, you have to rewire the van following the directions.

Posted on Mar 27, 2009

Ad
  • 17 Answers

SOURCE: how to replace brake light in 2008 chevy express cargo van

You have to remove the upper applique to remove the tail lamp, it is the trim panel above the lamp. I think it is held in place by two nuts/bolts but not sure. You have to have the rear doors open to remove it

Posted on May 23, 2010

  • 28 Answers

SOURCE: 2008 GMC 2500 Cargo Van Dash keeps sayin lr door is open and it is not!!! Driving me crazy!!

the latch in the left rear door is either bad or stuck, open door, then with a screwdriver, rock latches in door to simulate closed. release with exterior handle. spray lubricant (WD40) into latches and continue to exercise the latch. if this quick fix does not work, then a new latch for this door may be needed.

DW Mylin

Posted on Nov 29, 2012

  • 5 Answers

SOURCE: can't fine crank sensor on 5.7 gmc 2500 cargo van

its in the timing cover at the front bottom of the engine near the crank shaft

Posted on Mar 26, 2013

  • 786 Answers

SOURCE: I have a 2005 4.8 Chevy 2500 cargo van it is

Ok you have given very little detail. It can be any number of things wrong, from electrical to fuel. If you have a code reader, plug it in. If not then go to and advanced or autozone and ask them to read it for you with theirs, it's free for this service. Once the code it read it will be alot easier to figure out your problem.

Posted on Oct 25, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cargo light not working


Could be a bad door switch does the door ajar light stay on all the time or not come on at all?

Jul 06, 2014 | 2005 Chevrolet Silverado 2500HD 2WD

1 Answer

Cargo light stays on after car is off and door ajar light it's on when car is on.check all doors they're all close


Depending on the make model and year, it could be a sensor in one of the door latches.

Jul 27, 2013 | Cars & Trucks

1 Answer

2008 GMC 2500 Cargo Van Dash keeps sayin lr door is open and it is not!!! Driving me crazy!!


the latch in the left rear door is either bad or stuck, open door, then with a screwdriver, rock latches in door to simulate closed. release with exterior handle. spray lubricant (WD40) into latches and continue to exercise the latch. if this quick fix does not work, then a new latch for this door may be needed.

DW Mylin

Nov 28, 2012 | 2008 GMC Savana

2 Answers

How to replace brake light in 2008 chevy express cargo van


You have to remove the upper applique to remove the tail lamp, it is the trim panel above the lamp. I think it is held in place by two nuts/bolts but not sure. You have to have the rear doors open to remove it

May 23, 2010 | 2008 Chevrolet Express

1 Answer

Door adjar warning light stays on. Dome and cargo light stays on.


You need to remove the door ajar sensors from the doors and clean and lube them. You must remove the interior door panel then remove the door latch. Then twist the switch out of the latch to work on it.

Mar 19, 2010 | 1997 Ford F150 Regular Cab

1 Answer

Annoying alarm dinging until van reaches 17mph


This means one of the door ajar sensors is stuck. You need to remove the door trim panel and then the latch and then the sensor. Once out clean and lube it. There is a sensor inside every door.

Mar 16, 2010 | 1998 Ford Windstar

3 Answers

How do I remove the door panel on a Ford F250 Supercab. I'm trying to find the switch for the ''doors adjar' light which won't go off and subsequently keeps my dome and outside bed light on and draws down...


the door adjar switch is the problem. the cargo light stays on until 35mph, as well as the overhead dome light. i just took the bulb out of the dome light and dont worry about the cargo light. it stays on for 30 min after the truck is turned off if the switch didnt trip properly. it shouldnt cause any problems as long as your batteries are good. i havent replaced the switch yet but it should be on the part of the door by the latch. get the replacement part and do a visual I.D. when you get the panel off. then replace it. the sensor is only 14$

Mar 03, 2010 | 2003 Ford F250 Super Duty Crew Cab

2 Answers

My interior light and cargo light will not go off, even when my door is shut.


If the door ajar indicator on the cluster is also on, might want to soak the door latch with WD-40.
The door ajar and interior lights are turned on when the door latch is open. Some times the switch gets stuck, and a good soaking of WD-40 will release it. The door latch and the switch for the door are the same unit.

Jan 07, 2010 | 2002 Ford F150 Regular Cab

1 Answer

How to change fuel pump in 97 chevy 2500 (cargo


You have to drop the fuel tank. It is inside. Hope the tank is near empty, remove the 2 fuel fill hoses, you have two straps, lower tank, remove 3 wire connectors, and several more lines. Please use an ac delco fuel pump module. It may come updated with a new wiring connector to fix the old ones problem. If it does, you have to rewire the van following the directions.

Mar 27, 2009 | 1997 Chevrolet Cargo Van

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...