Question about 2003 Mitsubishi Outlander

Open Question

Replace the fuel pump in mitsubishi outlander 2003

The fuel pump is located under the back seat but is exposed and its not covered so the screws that hold it are part of the tank and are rusted. When we lose them all of them broke now we put new screws from bottom and gas is leaking because the originals are part of the tank. This is defenatly a manufacture mistake.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 35 Answers

SOURCE: mitsubishi outlander cooling fans not operating

there is a recall on the cooling fan controller you can call a local mitsu dealer tell them your vin to see if you are covered under the recall

Posted on Jul 02, 2009

Ad
mcgyver468
  • 710 Answers

SOURCE: 2004 mitsubishi outlander cooling fans not operating

TAKE A PEEK UNDER THE HOOD IN THE FUSE PANEL FOR THE FUSE AND RELAY FOR THE COOLING FAN. IF THE FUSE IS BLOWN THEN REPLACE IT. IF YOU SUSPECT THE RELAY TO BE BAD THEN TEST IT BY SWAPPING THE FAN RELAY WITH ANOTHER ONE WITH THE SAME PINS ON THE BOTTOM. MAKE SURE IT IS THE SAME SIZE AS WELL. HOPE THIS HELPS.. PLEASE KEEP ME POSTED. THANKS FOR AN HONEST RATING AND FOR USING FIX-YA. GOOD LUCK

Posted on May 16, 2009

  • 4088 Answers

SOURCE: 2003 mitsubishi outlander won't start. It has gas

If that is the problem, then the engine is in serious need of weather-proofing. Is the 'check engine' light lit? If so, have the problem code(s) read out with a scanner. That will give you the clues needed to find your problem.

Posted on Aug 01, 2009

  • 85 Answers

SOURCE: Can I purchase and have fitted the extra seats for

yes I would look in a salvage yard for the seat maybe ebay.com all the bolt holes should already be in the car body so unless you are picky about exact matching seat you could do this your self around $200.00-300.00

Posted on Oct 12, 2009

jlisagearhea
  • 412 Answers

SOURCE: remove rear brake drum 2004 Mitsubishi Outlander

Dear Brake Drum Remover,
I'm gonna tell you how to pull this drum off, ya ready?First off, get the rear of the vehicle up in the air safely, Then pull the rear tires off.After those are off then take a gander at the face of the drums, are there shiny brass looking screws installed on the face of that drum?Ifso remove those counterclockwise, then, take a hammer a shock the face off the drum firmly about three times.Now, go to the opposite side on the face of the drum and do that again, keep on doin that until you can wiggle the drum off by hand...easy as that, any other questions get back to me. I'M HERE TO HELP!!!

Posted on Nov 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The outlander has no fuel filter and its a part of the fuel pump. When do I need to replace the fuel pump on my 2003 Mitsubishi Outlander?


Fuel pumps are not a regular maintenance item that needs to be changed at a certain time. Replace it only when it fails. The designers built that fuel filter into the tank with the reasoning that it will last as long as the fuel pump itself.

Jul 05, 2011 | 2003 Mitsubishi Outlander

2 Answers

How do I replace the Fuel Pump on a 2004 Outlander


The tank has to be dropped. So think long before you try this on you own.

Feb 03, 2011 | 2004 Mitsubishi Outlander

1 Answer

Fuel pump replacement


Hello dorina_jorge: My name is Roger and I will help you. The fuel pump is located in the fuel tank. You can access the pump by removing the rear seat cushion. After removal locate the pump cover plate. Should be in the middle of the floor pan. Remove the screws. There are 4 of them. Unplug the wire harness and lift the cover up. Remove the fuel lines. ( be careful as they may be under pressure ). Remove the lock ring this screws down and lift out the fuel meter assembly. Make sure to replace the gasket when you reinstall the pump. Reverse procedure when done. Should you need further help please just ask. Please rate the answer. This way I know it was helpful. Thank You for using Fix Ya. Roger

Mar 04, 2010 | 2000 Mitsubishi Eclipse

1 Answer

Can you please tell me where is the fuel pump on a mitsubishi lancer 2001 model its not under the back seat


The fuel filter is located WITH the fuel pump AKA fuel module is what Mitsubishi calls this bundle, to access remove rear seats where you will find the cover to the assembly. The Fuel pump and Fuel Filter are intergrated to each other to save weight.

Jan 17, 2010 | 2002 Mitsubishi Lancer

3 Answers

Location of fuel pump on 2003 mitsubishi diamante?


bs it is in the back under the seat dont comment if you dont know
remove four screws pop plate off and there it is it took me 25 mins to change fuel pump beat that

Dec 20, 2009 | 2003 Mitsubishi Diamante

2 Answers

Where is the water pump located on a mitsubishi 2.4L engine? I have a 2003 mitsubishi outlander


While I understand this answer may be overkill, follow this link to an article about the engine cooling system. Look midway down the article for this sentence "More information about 2003 Mitsubishi Outlander Engine Cooling System service and troubleshooting, find here – 32 pages of PDF filetype" Click on the "find here" link which will prompt you to download a file 14_rar. Open it with any decompressing software (Winzip, WinRar) to find 14.pdf. Go to page 14-23 to see a diagram of where water pump is. It will also give you instructions on removing and replacing it. Good luck!

http://www.fixautopartz.com/2009/03/20/2003-mitsubishi-outlander-engine-cooling-system

Sep 19, 2009 | 2003 Mitsubishi Outlander

2 Answers

I am not getting fuel to my engine


Removal
  1. Relieve the Fuel System Pressure . Refer to the procedure in this section.
Cushion Cover and Pad, Rear Seat — One-Piece and 50/50 Split Fold Removal
  1. Remove the two rear seat cushion bolts.
  1. Fold the rear seat back cover and cushion (60084) forward.
  1. Carefully pull the rear seat cushion and cover (60030) out from under the rear seat back cover and cushion and remove the rear seat cushion and cover from the vehicle
  1. Remove the rear seat cushion and cover (60030). Refer to Section 01-10 for the removal procedure.
  1. Remove the three luggage compartment floor cover hold-down pins and fold the luggage compartment floor cover (45455) forward until the fuel pump assembly access plate is visible.
  1. Remove the four fuel pump assembly access plate screws, the ground lead, and the fuel pump assembly access plate from the chassis.




  1. Disconnect the fuel pump assembly electrical connector.




  1. On 4-door vehicles, remove the fuel vapor tube shutoff valve bolt and the evaporative emission tube shut off valve (9G332) from the bracket on the fuel pump assembly housing.




  1. Loosen the two hose clamps and disconnect the two fuel pump hoses from the fuel pump hose fittings on the fuel pump assembly housing.




  1. Remove the four screws (2-door) or eight screws (4-door) and lift the fuel pump assembly housing from the fuel tank (9002).




  1. Disconnect the fuel level sensor electrical connector.
  1. Remove the two fuel level sensor washers and fuel level sensor nuts and the fuel level sensor.



-------------------------------------------------------------------------------------
Section 10-01: Fuel Tank, Filters, Lines and Electric Fuel Pump 1996 Aspire Workshop Manual
REMOVAL AND INSTALLATION Fuel Pump Removal
  1. Remove the fuel level sensor. Refer to the Fuel Level Sensor removal procedure in this section.
  1. Remove the fuel pump screw, fuel pump grommet and the fuel pump bracket from the bottom of the fuel pump (9350).




  1. Remove the fuel tank sender filter bracket, fuel tank sender filter (9A011) and the fuel tank sender filter retainer from the fuel pump.
  1. Disconnect the fuel pump electrical connector.
  1. Remove the clamp and the fuel pump from the fuel pump assembly housing.

Apr 19, 2009 | 1995 Ford Aspire

4 Answers

Where is the fuel filter located in the 2001 mitsubishi galant?


can you tell me where the fuel filter is located on a 01 mitsubishi galant?

Mar 14, 2009 | 2001 Mitsubishi Galant

3 Answers

Replacing fuel pump need to remove rear seat need to know how


First you will need to releave fuel pressure......

next remove the rear seat cushion to gain access to fuel pump access panel.....

Removing Fuel Pump....

Jan 29, 2009 | 2003 Mitsubishi Outlander

Not finding what you are looking for?
2003 Mitsubishi Outlander Logo

Related Topics:

382 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8743 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...