Question about Cars & Trucks

1 Answer

Clean throttle body on 2008 town and country 4.0 Liter

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 3,103 Answers

Use stp carb and throttle body spray.. its a red white and black spray can with a small red hose attatched that is inserted in the spray nozzle to reach all the orfices and such..

Posted on Dec 27, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76846 Answers

SOURCE: where is the body control module located on a 1997 town & country

It is located on the back side of the underdash fuse box (junction block). You remove the lower steering column cover and knee blocker reinforcement. Then remove two plugs from the bottom of the BCM.
Remove the bolts holding the junction block to dash panel mounting bracket. Remove the junction block from the bracket. Remove screws holding the BCM to the junction block. Slide the BCM downward to disengage guide studs on jb from channels on BCM mounting bracket

Posted on Mar 23, 2009

hunterd777
  • 14 Answers

SOURCE: Early wear on front brakes /rotors for 2008 Town and Country

I work for a brake repair shop and trust me you are not alone.Enterprise and alot of other people bought the same van and had the same trouble.I hate to say but it doesnt stop there.About every 14 to 15 thousand miles you have to replace the front pads.As of now they dont have an upgrade,for instance ceramic pads, but I am sure they will very soon

Posted on May 01, 2009

autotherapis
  • 501 Answers

SOURCE: Where is the neutral safety switch located on 1998 Town & Country

It is built into the valve body of the transmission. It can be replaced, but it should be done by a pro. What are the symtoms that make you ask>

Posted on Aug 16, 2009

RonPark
  • 855 Answers

SOURCE: Two more cases of 2008 town and country brake wear

Depending on driving habits and where you drive premature pad wear can and is caused alot by improperly adjusted rear brakes and parking brake cables. With the rear brakes out of adjustment or not working properly the front brakes end up doing more up to 90% of the stopping of the car. Now a days people forget about the rear brakes be cause of the use of so-called self adjusters. I can tell you from over 22 years experience 90% of the time the self adjusters ether don't work at all or very poorly. So for you and your friend keep that in mind and have your rear brakes checked and adjusted every other oil change and the premature wear of your front pads will end.

Posted on Sep 28, 2009

bschilz
  • 2049 Answers

SOURCE: need info on a shift solenoid for 97 3.8 liter

The shift solenoid is a valve that controls shift timing.
The solenoid pack is located inside the transmission on top of the valve body.

It looks like this...

a5567fa.jpg

Posted on Oct 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2003 3.8L town and country. It has an intermittent miss but it has not thrown a code. The miss seems to happen at certain weather conditions. Dry no miss, damp it begins to miss randomly.


Sound like electrical problem.
Get a water spray bottle. Go to the car at night and dampen all electric wires ( plugs, coils etc.) Start the engine in the dark and hopefully see what is putting out little blue sparks.

Feb 12, 2015 | 2003 Chrysler Town & Country

1 Answer

Will the alarm system stop my 1999 town and country van from starting


Probably needs the fuel safety shutoff switch resset. I am not sure where it is on a Town and Country van.

Nov 29, 2014 | 1999 Chrysler Town & Country

1 Answer

2000 shakes when at a stop but feels like it is going to turn off why


Take the snorkel off at air cleaner to the throttle body, look into the throttle body,open the blade and look for black crusty tarnish, this needs to be cleaned out with a good throttle body cleaner.

Mar 14, 2014 | 2000 Chrysler Town & Country

1 Answer

Clean throttle body on 2008 town and country


SPRAY IN STUFF AFTER REMOVING AIR CLEANER

Dec 27, 2013 | 2008 Chrysler Town & Country

1 Answer

My 2002 town and country was stalling often and idling rough. i replaced the spark plugs, plug wires and the coil. it is still doing it. it has the 3.8 liter engine. i also tried to clean the throttle...


I helped a friend with a similar problem on his T&C. No check engine code. It was a dirty MAF sensor.
You can get special MAF spray cleaner at your local auto parts store.
As I recall, the sensor is located between the air fliter and the throttle body.
Remove the sensor from the air inlet.
Spray the sensor, soak, spray, soak, etc. Take your time. But, do NOT scrub it with a brush or cloth. Spray only.

Aug 07, 2011 | 2002 Chrysler Town & Country

2 Answers

Where to locate and clean throttle body


Hi!!
TBI is the part where the plastic duct coming from the air filter housing mates the engine. The part where the clamp attaches on the engine side is the TBI. The TBI has attached the Throttle Position Sensor TPS and the Air Intake Control Valve AIC,
A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa.

Nov 09, 2010 | 2008 Mercury Mariner

1 Answer

My 2003 Chrysler Town and Country misses very badly when I take off. It hesitates a few times and then moves forward.It soes not do it all the time. I have replaced the plugs and wires.


Easiest next step would be to replace your air filter and clean your throttle body.
Use a "throttle body cleaner" available at any parts store for about 5 bucks.
Make sure you take off the air inlet system and clean it all the way to the intake. Use a clean rag to wipe off the grime and be especially careful not to get anything foreign into your intake.
This is the cheapest fix. If you have an electrical short there should be a code stored in your vhehicles system. If so step 2 would be to take it to a mechanic with a reader to ID any issue.
That's only if step 1 doesn't solve your issue. (it will at the very least make it run smoother).

Sep 05, 2010 | 2003 Chrysler Town & Country

1 Answer

Gas pedal sticks.


DETACH CABLE FROM THROTTLE LINKAGE..MOVE CABLE IN AND OUT OF CABLE HOUSING..IF IT MOVES FREELY,YOUR PROBLEM IS MOST LIKELY IN THROTTLE BODY/PLATE..YOU CAN REMOVE THROTTLE BODY..FIRST REMOVE AIR CLEANER,UNPLUG TPS,IDLE MOTOR AND INTAKE TEMP SENSOR..USE BRAKE CLEANER OR THROTTLE BODY CLEANER AVAILABLE AUTO PARTS STORES..DO NOT LET AND CLEANER GET IN TPS..YOU CAN USE A PLASTIC OR WOOD SCRAPER..SO YOU DON'T SCRATCH THROTTLE BORE AND CLEAN DEPOSITS FROM THROTTLE BODY/PLATE..HAVE SEEN THIS CAUSE STICKING OF GAS PEDAL..I HOPE THIS HELPS..WHEN DONE CLEANING,REINSTALL THROTTLE BODY AND RELATED PARTS

Dec 28, 2009 | 2005 Chrysler Town & Country

1 Answer

Finding the egr to replace it in the 2006 chrsyler van 3.3 liter engine send diagram also please


You dont know where it is,or how to check it, but you know its bad????? Its just behind and below the throttle body.

Dec 11, 2009 | 2006 Chrysler Town & Country

1 Answer

Tune up on cown and country (chrysler)


I just changed the rear spark plugs on my 1997 Chrysler Town & Country this weekend. It took me about 7 hours to do everything. When you replace the rear spark plugs, its a good item to replace everything i have listed below. Listed below are the items i changed while i was in there:

Valve Cover Gaskets
All 6 sparks (the rear are the hardest) I used the Bosch Plat. +4
Intake manifold gasket (only cost $3-4)
Throttle body gasket.
Air filter
Spark Plug Wires

I also bought some throttle body cleaner and sprayed the throttle body to clean it out. When the throttle body is dirty your van can stall.
I took pictures of everything i took apart, which i can email you to help you out.

Thank You,
Nip
Highhrider@aol.com

Sep 14, 2008 | 1998 Chrysler Town & Country

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...