Question about 1995 Chevrolet Camaro

1 Answer

Need to find a replacement convertable power top switch for a 95

Camaro. OEM or not. 4-wires on the switch

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert
  • 95 Answers

Stick with oem so you dont have to screw with power ratio settings.. Nor nasty fabrications...And not he Pntiac wont work.... you spend more moeny for harnesses and spec bolts, though it will fit just need to be customized...

Posted on May 18, 2009

  • Mysticole_20 May 19, 2009

    or are you asking if the switch is oem, clarify plz.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Just replaced plugs and wires on a 95 chevy camaro v6 now has no power


Sounds like you may crossed up some plug wires? use the diagram below to check this out as the poss problem. Match the numbers on the coil pack to the cylinder numbers. Cross wiring plug wires is the most common thing that home mechs do that they get wrong.


2_16_2012_4_57_59_pm.gif

Feb 16, 2012 | 1995 Chevrolet Camaro

1 Answer

The power windows in my 1996 Z-28 convertible roll up and down very slowly.


hate to tellyou but the motor is on its way out! very common problem with this vehicle, you could try replacing the switches first but thats rarely it, motor cost an average of 60 $ a piece, gotta replace the drivers side in my 95 z coupe, good luck!

Dec 21, 2010 | 1995 Chevrolet Camaro

2 Answers

Where is the ignition switch on a 95 camaro


At the bottom of steering column on key side is the electrical ignition switch.

Aug 10, 2010 | 1995 Chevrolet Camaro

1 Answer

Brake lights on 95 camaro


Check your brake light switch at your brake pedal make sure that you have power coming in and then going out with pedal depressed if that is ok check for a faulty turn signal switch the brake lights run thru the switch on the hazard circuit.

Apr 05, 2010 | 1995 Chevrolet Camaro

2 Answers

95 chevy camaro with pass key will not start. Replaced key and it started. Later it did not start. What's going on? What are some things to try?


If it's the same as the VATS system in my 86 Corvette (resistor pellet in key) the ignition switch might need to be replaced. The contacts on the key wore low, replacing the key helped for a short time but the new contacts wore the switch down faster then it too needed to be replaced. $200!

Nov 16, 2009 | 1995 Chevrolet Camaro

1 Answer

Same problem with the windows, radio, and convertible top on mine


that is because you have an electrical relay that has burned out. this is a high powered relay running different components in the car. check your owners manual and just replace this from auto parts store.

Jul 25, 2009 | 1998 Chevrolet Camaro

1 Answer

2001 camaro convertible top will not lower. When


you could have hydralic malifunction or low fluid level.air in system or you have mechanical binding.

Jul 09, 2009 | 2001 Chevrolet Camaro

1 Answer

Convertable top does not go up


If the motor is only moving top one direction, either the switch is bad or the motor is bad. You can use an ohmmeter or volmmeter to test the switch. Place meter probes on the wiring that attaches to motor. Now press the switch in both directions. See if there is power in both directions from switch. If not the switch is bad. If you do get power both directions, than the motor will need to be replaced.

May 23, 2009 | 1995 Chevrolet Camaro

1 Answer

95 camaro no spark on cylinder 6


Loud popping in the intake means that the unburnt gas exploding in intake.... Check cranks sensor and gear. Gear may dirty or even damage or BAD crank sensor the sensor provides reference for spark signal. So this may be your problem. Contact if you need more help. Thanks for using FIX YA

Jan 23, 2009 | 1995 Chevrolet Camaro

Not finding what you are looking for?
1995 Chevrolet Camaro Logo

Related Topics:

155 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...