Question about Nissan Stanza

1 Answer

I need an accelerator cable for a Nissan Pintara 1990 2.4 ltr. manual

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Nissan Master
  • 42,133 Answers

After market shop will be the cheapest or genuine from a dealer spares department.

Posted on Dec 27, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

stormbrewin
  • 426 Answers

SOURCE: i have a 1990 nissan

If you have the original owners manual that previous owner has written the code in you will not need to replace radio otherwise you will need to replace it.Some times the code can be written on the outer case of the radio but not usualy.Vehicle is too old for that code to have been retained by manufacturer/dealership.Without that four digit code therse very little you can do but replace.

Posted on Nov 03, 2008

  • 42 Answers

SOURCE: adjust clutch

That's probably because of the fact that they didn't make enough of that model of cars that they would put it on their website. That's what I would say. Just google clutch for australian Nissan Pintara and see what happens.

Posted on Jul 10, 2009

  • 1986 Answers

SOURCE: Removal of Front Door Handle Pintara Nissan

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge.

Posted on Sep 21, 2009

  • 104 Answers

SOURCE: Nissan 1991 model .dash warning light

Its your Over Drive switched to "OFF", check your OD switch on/near the shift lever!! If its placed in "on" have the switch checked!!

Posted on May 24, 2010

dttech
  • 4803 Answers

SOURCE: I have a 1990 Nissan pintara 2.4liter I can start

The place to start with this problem would be to scan your onboard engine computer for fault codes. If there are no fault codes present, then see if it will stay running if the throttle is opened slightly. If it does, then the problem is most likely caused by a bad Idle Speed Control (ISC). These fail sometimes without setting any codes.

Posted on Jun 21, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need a diagram of everything on a motor for a Nissan pintara 1992 there a part missing on mine and I have no idea what it is


Go on the internet, and look up your model of Nissan Pintara, or look up the schamatics will provide you with a picture of the part you need. Schamatics for your engine.

Jul 26, 2014 | Cars & Trucks

1 Answer

Differental ratio for 1990 nissan pintara


turn shaft 1 turn count other shaft turns

Jul 08, 2014 | 1970 Nissan Skyline

1 Answer

Throttle body located


you can buy that from your nissan auto parts

Dec 26, 2013 | Nissan Stanza Cars & Trucks

1 Answer

I have a 1990 Nissan pintara 2.4liter I can start it then stop straight away I've replaced coil dizzie cap and leads do u think it could be fuel pump or dizzie any help would help thanks francis


The place to start with this problem would be to scan your onboard engine computer for fault codes. If there are no fault codes present, then see if it will stay running if the throttle is opened slightly. If it does, then the problem is most likely caused by a bad Idle Speed Control (ISC). These fail sometimes without setting any codes.

Jun 21, 2011 | 1990 Nissan Pulsar

1 Answer

My dad owns a 1990 Nissan Pintara we have the code for the radio but are unsure on how to put the code in. can anyone help?


when you are at the -C- display (you may have to wait up to 3 mins) press program button 5.

Use Up or Down buttons for first digit - Press 5 to store
Repeat for digits 2 3 & 4

Job done.

Now, can anyone advise me how to get the stock Cassette/ Radio out of the dash (replacing with CD player)?
lynnrb6430@yahoo.com

Aug 05, 2010 | Nissan Z Cars & Trucks

1 Answer

No fwd or reverse in a 1991 2.4 ltr nissan pintara model U12


Now that depends on weather its auto or manual type g/box
Auto box now this depends on its either ...ie no trans oil/auto pan filter cloged up/body valves in g/box have sticking pistons/or pistons in pumps not working due to body valve or forward and reverse bands worn also due to above. plus it could be the torque convertor problems.
BUT a Manual box
Lack of oil/ clutch centre plate or pressure plate worn or broken springs /input shaft bearing/gear selectors ball and spring on selector indent jamed etc.
Let me know which box you have. Ron

Oct 17, 2009 | Nissan Stanza Cars & Trucks

1 Answer

Removal of Front Door Handle Pintara Nissan


On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge.

Sep 21, 2009 | 1983 Nissan Pulsar

1 Answer

Adjust clutch on nissan pintara (it dosn't give me the pintara option in the choose a category) 2 lt, 1990


That's probably because of the fact that they didn't make enough of that model of cars that they would put it on their website. That's what I would say. Just google clutch for australian Nissan Pintara and see what happens.

Jul 10, 2009 | Nissan Pulsar Cars & Trucks

1 Answer

I have a 1990 nissan pintara and when i turn the radio on its say code required, does anyone have an idea??????


If you have the original owners manual that previous owner has written the code in you will not need to replace radio otherwise you will need to replace it.Some times the code can be written on the outer case of the radio but not usualy.Vehicle is too old for that code to have been retained by manufacturer/dealership.Without that four digit code therse very little you can do but replace.

Nov 03, 2008 | Nissan Pulsar Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

723 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...