Question about Chevrolet C1500

1 Answer

1996 chevy vortec stops for days after rain,just installed new cap rotot plugs wires and sa cran position sensor,no fire no codes,occasional backfire hard turning over...thx

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chevrolet Master
  • 40,764 Answers

Check ignition timing and firing order of the HT leads . There may be moisture in the distributor ignition pack

Posted on Dec 27, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Jeep GCL Backfires Stalls

Aaron, I had the same problem. It is the most expensive part of course the computer. I replaced everything as well till I replaced it. They are remanufactured and have had problems with them as well. I am on my third one now at 200k miles. Oh and by the way it does not show up on the diagnostic check. Good luck

Frank

Posted on Dec 01, 2008

  • 1 Answer

SOURCE: Only when it rains, I get an engine misfire and the check

i had the same problem with my truck...(i have a 99 silverado 4.3L also) i took off the cap, cleaned all of the electrical areas on the inside of the cap and rotor....and put a small thin layor of die electric grease on it all....then before i put the cap back on...i ran a bead of silicone around the cap surface that seats to the distributor...and i havent had a problem for the month that i have done that......hope this helps!

Posted on Nov 01, 2009

arauzvictor1
  • 466 Answers

SOURCE: What is the firing order for spark plug wires 1996 Chevy Cavalier

Ok Gary I sent you two figures of a 2.2L and 2.4L engine I hope to serve you. Thanks4b0b09e.jpgc5349b5.jpg

Posted on Feb 28, 2010

  • 1 Answer

SOURCE: 93' chevy 4.3 V6 vortec. engine problem

fuel lines inside the intake plhenum may be cracked and leaking inside the plhenum. same thing happened to my 1992.sonoma. they are made of a plastic material and tend to crack right in the bend of these lines.

Posted on Mar 19, 2010

  • 1 Answer

SOURCE: 4.3 L vortec firing orcer and wiring diagram

need firing order for a 95 chevy 4.3 vortic engine thank you

Posted on Mar 05, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 chevy blazer not starting


Check the plug wire from the ignition coil to the distributor cap.
If you haven't already, replace the distributor cap and rotor.
The GM Vortec's have issues with moisture getting inside the cap and rotor and causing problems.

Apr 24, 2012 | 1999 Chevrolet Blazer

1 Answer

Will a throttle position sensor cause my 96 model Chevy blazer 4.3L vortec get bad gas mileage I'm only getting 225 miles to a full tank


I would replace both o2 sensors and take the mass air flow sensor off and clean it with a non-chlroated brake cleaner.Also a tune-up sure won't hurt sparkplugs,plug wires,distributor cap and rotor.Your fuel milage should increase.

Jan 13, 2012 | 1996 Chevrolet Blazer

1 Answer

93' chevy 4.3 V6 vortec. engine problem


fuel lines inside the intake plhenum may be cracked and leaking inside the plhenum. same thing happened to my 1992.sonoma. they are made of a plastic material and tend to crack right in the bend of these lines.

Mar 18, 2010 | Chevrolet S 10 Cars & Trucks

1 Answer

Plug wires


Firing order is 1,8,4,3,6,5,7,2. cap should show cylinder numbers.

Apr 21, 2009 | 1996 Chevrolet K1500

3 Answers

4.3 L vortec firing orcer and wiring diagram


you need the firing order?? it is 1, 6, 5, 4, 3, 2 clockwise. Number one on cap is forward position, or 6 o'clock position, just left of the hold down bolt.

Jan 22, 2009 | 1995 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

132 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...