Question about Chevrolet S 10

1 Answer

My 1995 chevy s10 brake lights reverse lights high mount light all went out and cant find out why

Ive checked all of my fuses with a multimeter and they all checked out fine ive checked out all of the bulbs and they have checked out but still no lights

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Chevrolet Expert
  • 180 Answers

Check connection on frame that operate rear. Do the rear parking lights work, turn signals?

Posted on Dec 26, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
FoRdMaStEr
  • 53 Answers

SOURCE: tail lights 99 jeep grand cherroke limited

have you checked the bulb sockets to see if they are burnt or corroded sometime i see that the plastic melts around the contacts where the socket twists into the housing. if your lucky you might get away with replacing just the socket for the brake/running light bulb. but if it is too melted your most likely going to need a new housing

Posted on Jan 07, 2009

  • 10 Answers

SOURCE: no brake lights

Check the switch which is on the brake pedal it will probably be that

Posted on Jan 07, 2009

  • 14036 Answers

SOURCE: Both 2003 oddyssey brake lights dont work High

clean bulbs socket out using the electronic spray cleaner for electrical connectors.

Posted on May 13, 2009

afarri
  • 1386 Answers

SOURCE: my brake lights are not

Hello and welcome to FixYa!

Try to check the ground of the tail lights. It can be disconnected or worn out. It's a black colored wire that needs to be attached on the car's body. This can do the trick.

Hope this helps and thank you for using FixYa! Have a good one!

Posted on May 03, 2011

redds55
  • 2620 Answers

SOURCE: 2003 Chevy S10 Brake lights

OK try this, push and hold brake then push on the hazard switch if brake lights come on then replace the turn signal switch.

Posted on May 14, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is going on with my brake lights?


did he clean the fuse box contacts

Mar 01, 2015 | 2001 Jeep Grand Cherokee

1 Answer

1995 Buick Riviera, brake lights won't come on except for the one in back window


I am thinking that the brake lamps in the rear taillamps went through the turn signal/hazzard switch. Play with your hazzard switch and see if they start working. If not, check the brake lamp switch with a test light. I believe the high mount stoplamp had a seperate wire than the taillamps for brake lights.

Feb 14, 2014 | 1995 Buick Riviera

1 Answer

1995 chevy s-10 pickup can't get brake lights to work.


have you checked the fuse box and both brake light bulbs?
check the microswitch on the brake pedal also. once the pedal moves downwards the switch should activate.

if you can check the resistance of the switch with a multimeter then you would expect to see low resistance once you press down on the switch.

Mar 09, 2012 | 1993 Chevrolet S-10

1 Answer

Why do my chevy lumina idle high in park and in drive. and why wont my brake lights work.


You either have a vacuum leak or the idle air control valve is defective.This may set a check engine light but you did not a check engine light being on.As far as your brake lights if the high mount is working and the regular brake lights not working then it is your multifunction switch.This is part of the turn signal switch.Under the steering wheel.I am assuming that you have checked your fuses.Hope this helps.Good luck.

Dec 28, 2009 | 1995 Chevrolet Lumina

1 Answer

Where is the relay for the hi mount brake light ona 1996 chevy s10? Brake lights work but hi mount does not. Checked the bulbs, and fuse is good. Manual says there is a relay.


the magic one does all relay or the hiding multipurpose magic relay ,think you will find that the light runs off a loop from one of the back lights .

Dec 23, 2009 | 1996 Chevrolet K1500

1 Answer

I have a 1990 chevy s10,all my lights work except my brake lights


Do you have power with a test light in and out of the switch? Do the turn signals work? Will the brake lights work if you play with the turn signal handle?

May 06, 2009 | 1990 Chevrolet S 10 4WD

2 Answers

No tail lights


Try checking the headlight switch it may have broken contacts in it. Easy fix go to a salvage yard find same make and model truck, swap headlight switches.

Dec 27, 2008 | 1997 Chevrolet S-10 Pickup

1 Answer

Reversing lights


Could be the reverse light switch itself, usually mounted on the gearbox with 2 wires coming from it. If you had a multimeter (set to resistance / ohms) you could check that the switch changes from open to closed by disconnecting the plug on those wires and putting the multimeter across the two terminals. The resistance will be very low with the gear lever in reverse, and very high/open circuit with it not in reverse. Also check that there is battery voltage to one of the terminals.

Oct 21, 2008 | Hyundai Motor 1995 Accent

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

89 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77544 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...