Question about Cars & Trucks

Open Question

Hyundai H100 Headlight with water

My Hyundai H100 front headlight or lamp has water but not sure how to open and replace headlight. Any suggestions?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
motor1258
  • 6674 Answers

SOURCE: need to replace driver's side headlight in 2004 dodge SX2.0

No. Just twist black locking retainer about half turn counterclockwise (left), remove it & wiggle bulb out. replace bulb without touching glass part of it which shortens the life if you do. Add a little vaseline to Orange O ring, to make it pop back in, after you make sure tabs on bulb are aligned with ones in the hole of housing. You may need to wiggle it back in too. Put retaining ring back on, turn clockwise until it locks, plug wire connector back in to back of bulb, until it snapps onto catch on bulb and your good to go.

Posted on Dec 13, 2008

Ad
  • 840 Answers

SOURCE: Adjusting the low beam headlight

its all the same the headlight is a complete unit you adjust both/ look for screws behind the headlight one each side one is for horizontal annd the other is for vertical Please rate my response thank you very much

Posted on Jan 31, 2009

  • 5 Answers

SOURCE: 99 cutlass supreme headlight bulb replacement

Look at the top of the headlight assembly. There is a plastic panel on top of the assembly that is held in place by two plastic pins. Remove those pins by lifting the center of the pin and then pull out the pin. Remove the panel. Then you will find two small plastic levers that will lift about 1/2 inch. They do not come out but they will release two studs that secure the assembly. After the assembly is released, slide it forward to access the bulbs you need to replace. Installation is the reverse of these procedures.

Posted on Mar 08, 2009

USfalcon
  • 175 Answers

SOURCE: How to replace headlight bulb hyundai elantra 2004

yes , you need to remove the headlight cover from the back after u move the bulb conector then there is a holder for the bulb u need to push down then move.
i hope it help ,,,, thanx

Posted on Mar 16, 2009

  • 1 Answer

SOURCE: replace headlight bulb

Actually there are two little black tabs on top of each headlight housing and you simply have to pull them up to release the whole headlamp.

Then follow the rest of emissionwiz's solution.

Posted on May 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Right headlight has been replaced but it is not working 2011 Hyundai Sonata


Hello Jennifer,

Please check the plastic plug connector to the headlight lamp. They can get quite warm and when a poor connection is present.... a lot of heat is generated through the bad connections and this tends to melt the plastic plug. All contacts should be clean and tight to the lamp contact posts.
It is also possible that the new lamp has failed.

Apr 20, 2017 | Hyundai Cars & Trucks

1 Answer

2003 Hyundai Santa Fe. Problem with driver's side headlight; lowbeam works fine under daytime running. When I flip up for night time driving, the driver's side headlight goes out. Dying bulb or....?


The day time running lamps are the high beam lamps , just going through the DRL resistor . Your low beam bulb could be bad (open) . Check voltage with DVOM - digital volt ohm meter , there should be three wires at the headlamp socket , check the orange wire for battery voltage with low beams on .

Jan 15, 2016 | Hyundai Cars & Trucks

1 Answer

Replacing front headlight lens on 1985 Toyota Tercel


    How to change a Toyota Tercel headlight lamp - YouTube

    ? 4:06
    www.youtube.com/watch?v=B9dj0o5KIxc
    Apr 22, 2013 - Uploaded by NewEnglandgardening I replaced both headlight lamps on my 1996 Toyota Tercel. ...How To Install Replace Headlight and Bulb Toyota Corolla 98-02... Rear brake shoe replacement Toyota Tercel 1991-1998 Paseo Drum brakes Install Remove ...

Sep 27, 2015 | Toyota Cars & Trucks

1 Answer

How do you change the headlight


On a Newer Vehicle you'll replace the Headlight Bulb
Open the engine compartment hood.

Locate the back of the headlight to determine the lamp and bulb type.
Decide which bulb you need to replace.
Purchase the correct bulb for your headlamp.
Behind the headlight the lamp the socket is removable.
Remove Socket then replace lamp (bulb).
Carefully re-install the socket


On Older vehicles:


Remove the screws that connect the headlamp frame to the
bracket holding the headlamp. Make certain you turn only
the screws that hold the lamp frame, not the adjusting screws.
Disconnect the electrical connector in the back of the lamp
by pulling the socket away from the headlamp with your hand.
Remove the headlight from the bracelet area and discard it.
Replace with the new headlight, making sure that it is positioned
right side up.
Plug the wire socket into the new headlight, which holding the
headlight securely.
Replace the headlight into the frame.
Place the frame onto the headlight bracket.
Reattach the screws to hold the frame and bracket in place.
Do not adjust the setting screws for the direction the headlight
shines.


At night partk in front of a wall and shine your lights on the wall
so see if the headlight shifted during installation.

Jul 14, 2012 | Cars & Trucks

1 Answer

My Hyundai sonata 1997 model it has got one of its head lamps so dim and dull then i used to think that its the halogen spot lamp itself that needs replacement then i replaced it with a knew one but there...


check to see if you have seperate fuses for each headlight. Some cars do I have seen a blown fuse make a headlight dim. If not check the wiring harness that goes to that headlight to see if any of the ground wires from that harness to body ground has lost contact, Hope this helps, Leave comment.

Jul 11, 2010 | 1997 Hyundai Sonata

2 Answers

How do I change the back turn signal on my 2001 ford taurus


DIY - 5 Minute Turn Signal Bulb Replacement This is very simple to do. First you will need an 8mm socket and wrench to loosen one bolt. Second a good long flat head screwdriver. There are two black metal folded tabs behind the headlight assembly and one 8mm bolt holding it in plae at the center point of the front of the car. Loosen the bolt and remove. Use the screw driver to pull up the metal straps and then slide forward the entire assembly. This will slide easily unless your front bumper has been bumped! That will make it a little difficult to slide if it is out of alignment. If it was never bumped than this should take all of 5 minutes.

Replacing front parking lamp/turn signal/cornering lamp bulbs
  1. Remove headlight / lens assembly per below steps mentioned later

  2. Rotate the bulb socket of the offending bulb counterclockwise and remove from the lamp assembly.

  3. Carefully pull bulb straight out of the socket and push in the new bulb

  4. Install the bulb socket into the headlight assembly by rotating it clockwise

  5. Re-install headlight assembly - hold snugly into place until the brackets line up and retainer pins can be pushed down

To replace headlight bulb:
  1. Make sure headlight switch is turned OFF.

  2. Remove the bolt at the end of the headlamp housing.

  3. Pull the two black tabs with the L shaped bracket toward the back and then up and pull out(Located at the back of the headlamp) to release the headlamp assembly from the vehicle and pull headlamp assembly forward.

  4. Disconnect the electrical connector from the bulb by pulling it.

  5. Remove the bulb socket retaining ring by rotating it counterclockwise.

  6. Remove the bulb from the lamp assembly by pulling straight back.
    Do not twist, as there are alignment slots built into the lamp assembly socket.
    It may take some effort to remove the lamp because it has a rubber o-ring type seal - try a bit of wiggling side-to-side

  7. Insert new bulb into headlight assembly - don't touch the glass - use gloves, paper towel, or similar
    Make sure that the flat surface of the bulb socket is facing upward, and is firmly seated

  8. Re-attach retainer ring by rotating clockwise

  9. Reconnect the electrical harness

  10. Re-install headlight assembly - hold snugly into place until the brackets line up and retainer pins can be pushed down

NOTES
  • Do not touch the glass of the new halogen bulb - the oils in the skin will shorten the life-span of the new bulb, or possibly cause the bulb to explode when first turned on

    If the bulb is accidentally touched, it should be cleaned with rubbing alcohol before being used.

Additional Information1996-2005 Bulb Numbers:
  • FRONT Turn-signal - 3457 AK (amber)
  • Headlamp - 9007 QL (9007LL optional)
  • Tail lamp/brake/turn lamp 3157
  • Tail lamp/brake lamp (wagon) 3157
  • Rear turn lamp (wagon) 3456K
  • Backup lamp 921
  • Backup lamp (wagon) 3156
  • License plate lamp (2) 168
  • High-mount brake lamp (2) 912
  • Rear side marker lamp (wagon) (2) 168

Feb 24, 2010 | 2001 Ford Taurus

1 Answer

I have replaced the front right headlamp on my 2003 Tiburon and it still does not work. I have heard that each headlight on this car is fused separately. Where is the Fuse for this lamp?


The main fuses for the headlight will be under the hood in a box near the firewall or the fender. There are secondary fuses for the headlights under your dash inside the car

Aug 20, 2009 | 2003 Hyundai Tiburon

1 Answer

Headlight bulb replacement for 2002 Hyundai


open the hood there is a round black or gray cover that twist quarter turn.then the bulb is held on with a wire clamp that is a tick to un snap .you may need to look at a picture to understand.

Apr 23, 2009 | Hyundai Motor 2004 Sonata

1 Answer

Need to know how to remove cover to replace lamp in headlight for 2002 chevy trailblazer


you dont remove the front cover, open the hood look behind the headlight and turn the bulb couter clockwise, and replace the bulb in the headlight.. good luck keith...

Mar 21, 2009 | 2002 Chevrolet TrailBlazer

1 Answer

Difficulty with replacing fog lamp bulb on 2001 Hyundai XG300


Remove the headlight and put it in from the top.

Dec 30, 2008 | 2001 Hyundai XG300

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

208 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...