Question about Cars & Trucks

Open Question

Nordica exp 25 tech manual

Adjusting bindings

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why or what are posiabilitys for raideator hoses calapsingon 1996toyta avlon


radiator hoses are know to collapse especially the bottom hose when the radiator cores become blocked or the spring in the hose rusts away and no longer supports the hose.
Hoses should be replaced when they are larger than the hose clip holding them on as this an indication of the binding fabric in the rubber is rotting away and no longer doing the job.

Jan 04, 2015 | 1996 Toyota Avalon

2 Answers

Adjusting hand brake


there is a cable adjuster under the center console if its got a rear ashtray just pull that out and look there.but you should remove the rear brake drums and check the shoes. and the handbrake fulcrum levers, they can sieze up. also make sure the levers return to the stops with handbrake off and the auto adjusters are working ok before adjusting the handbrake cable! it helps brake performance if you give the auto adjusters a bit of a tweak before putting the drums back on. manually adjust 3-4 clicks or until the drum goes back without binding.

May 29, 2013 | 2005 MG ZR

1 Answer

My emergency brake is having trouble releasing on my 2001 chevy blazer s10. it releases only by when i pull the lever and when i push the pedal back into position for it be released. im worried of thi


i would check the pedal itself, then pull the drums and try adjusting the brakes, if you havent done this in a while to clean and adjust them you might be better off replacing the shoes, all springs and adjusting them till the drum just starts to drag and rechecking the ebrake, if this doesn't help you will probably need e brake cables and possibly a pedal assembly if it is binding

Jan 15, 2013 | 2001 Chevrolet Blazer

1 Answer

Where is the number 6 coil pack on a 02 ford f150 located


2nd cylinder from yhe back onrighrside if its a v8 v6 is last cylinder on r. dise either way the nuber of cylinder is on intake manifold above each cyl. GOOD LUCK B.HARRIS A.S.E. CIRTIFIED 25 YRS. EXP.

Apr 30, 2011 | 2002 Ford F150 Regular Cab

1 Answer

My '93 Charade does not start sometimes. Jag it a little and it will. I suspect the 'Starter' is the problem. Pls. help. TYIA


ANY TIME YOU TAP ON A STARTER AND IT STARTS IT MEANS THE BUSHINGS ARE BAD IN STARTER.IF YOU ARE PULLING OUT THE STARTER HAVE IT BENCHED TESTED FOR AMP DRAW TO CONFIRM ITS BAD B.HARRIS Q.S.E. CIRTIFIED 25 TRS.EXP.

Apr 28, 2011 | Daihatsu Charade Cars & Trucks

1 Answer

What does (Exp) stand for or mean?


Exp stands for export. On cars sold outside the US instead of a written message on the message center on the dashboard it would say exp and a number. The owner can look up the number in their owners manual written in their language to read the message. GM did this instead of making the dashboard display in different languages. A dealer may be able to reprogram your car so it just displays the message. Hope that helps.

Mar 06, 2011 | 1997 Cadillac DeVille

1 Answer

My transmisson is slippin around 25 mph.


if it is an automatic then its time for a service on the transmission because the bands are probably loose. if its a manual then your clutch could need adjusting or you may need a new clutch. hope that helps. let me know how you go.

Feb 09, 2011 | 1997 Buick Century

1 Answer

Loose steering gear box needs adjusting


There should be a adjusting screw with a lock nut on it on the steering gear box. With the wheels straight ahead, loosen the lock nut and turn the screw in until it stops the back it out about a 1/8 of a turn. Try the steering check it for binding, it should turn free in both directions. If there is still too much play you can try turning it tighter but make sure it does not bind up. You may have to replace the steering gear box, you can probably get a rebuilt one, or go to; car-parts.com and check the salvage yards in your area for used.

Mar 05, 2010 | 1981 Ford F 100

2 Answers

How do I adjust the handbrake?


The parking brake on most vehicles are self adjusting. If the parking brake is not self adjusting you will to remove the brake drum/rotor and check to see which part is binding. If you wan to simply adjust the parking brake lever to make it tighter there should be an adjusting nut on the cable under the vehicle.

Oct 25, 2009 | 2002 GMC Envoy

1 Answer

97 S-10, manual trans, 4WD, V6. wehn I engage


The gears are binding, and the vehicle is new enough the the computer can say hell no, and pop it back out. That or the mechanical portion won't hold it in place because the gears are binding. If you need 4WD, take it in to get repaired, The techs will try it out, and test it to make sure what is wrong, trust me when they are stumped, thy get 3 or 4 other techs thinking about it. They can fix it for you. A friend of mine had this issue, except in a 98 silvarado, and when he engaged his, it did the same thing. I never asked how they fixed it, but I know he went to a dealership to do it.

Sep 27, 2009 | 1997 Chevrolet S-10 Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

364 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...