Question about Cars & Trucks

Open Question

B4000 problems rattling noise from front end mazda b-4000 4x4

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
sledge1863
  • 149 Answers

SOURCE: Front End Noise, Chev Cavalier

It sounds like you have a bad c v or constant velocity joint. Look under the car next to the wheel look for a rubber accordian type unit, if the rubber is torn or lose the grease has escaped and damaged the joint. You can replace it yourself, but if your not mechanically inclined would say take it to a shop.

Posted on Mar 05, 2009

Ad
  • 1 Answer

SOURCE: changing rear brakes on 1998 mazda B4000

make sure your brake adjuster is backed all the way off then gently tap all the way around the back to remove

Posted on Apr 10, 2009

  • 2 Answers

SOURCE: front end rattle

It's a loose steering column. Remove the black plastic shield under the steering wheel. Lossen the bolt that holds the two shafts together, slide them together as far as they'll go, and re-tighten the bolt. It's that simple... to stop that annoying rattle.

Posted on May 15, 2009

  • 180 Answers

SOURCE: rattle noise in front end over bumps , have heard

sounds a bit like a ball joint. is it more a slight knocking?

Posted on Mar 16, 2010

SOURCE: Where is the fuel filter on a 1994 Mazda b4000 pickup?

Driver side frame rail right where the door is. It's held in by a large hose clamp. It has 2 white plastic clips . 1 on each hose of the filter. When removing have a container that can hold gas ready because about a pint of gas will come out. Make sure new filter comes with new clips. I don't recommend using old ones. After new one in place turn key on and leave in run position for 20 seconds so filter can gill with fuel before starting and inspect fir leaks.

Posted on Apr 08, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My truck started making a bump noise driving home from work today and I could feel it underneath in the middle of the truck. It did it every one-two minutes. It has never done it before. What is it?


look under truck and see if anything is wrapped around drive shaft also if looks good u joints may be going bad also check the center bearing and bracket its a support hanger bearing for driveshaft

May 23, 2016 | 2000 Mazda B-Series

1 Answer

Where fuel filter located on a Mazda b4000 1994?


1994, most cars its in front of fuel tank
did you even look first? there?
some cars its on fire wall, (old cars)
following the fuel line, always works on all cars.
gas or diesel.
my comments are all gas (petrol)

now ill post the 1st line in the FSM (safety)_
If the fuel filter is being serviced with the rear of the vehicle higher than the front, or if the tank is pressurized, fuel leakage or siphoning from the tank fuel lines could occur. to prevent this condition, maintain the vehicle front end at or above the level of the rear of vehicle. also, relieve tank pressure by loosening the fuel fill cap. cap should be tightened after pressure is relieved.


is car stalled.> or is this a service , question, tune up.?

i logged in and bingo there it is by gas tank..
sure you didnt want to look and want us to .sure.

Jul 18, 2014 | Mazda Cars & Trucks

1 Answer

2000 Mazda B4000 4x4 rattling noise from front of vehicle


Check all the plastic cowlings and air dams to make sure they are not loose and rattling in the wind when you drive down the road. Check the exhaust system for any broken or loose hangers. Hope this helps.

Jan 02, 2014 | Cars & Trucks

1 Answer

Mazda b4000


Check differential for fluid. Check level and condition of trans fluid for starters.

Sep 07, 2013 | Cars & Trucks

1 Answer

2001 mazda b4000


The calipers are overloading and not fully releasing the rotors. Have you changed the proportioning valve in the brake system? You may want to start there.

Oct 16, 2012 | Chevrolet Malibu Cars & Trucks

1 Answer

2007 Mazda B4000 Fuel Pump Noise


sounds like he's trying to wait till the warrenty expires.... be on record as complaining about it during the warrenty period...
the only recall i could find was on the fuel tank itself and my search was in someways imcomplete.
this is about all i can find on your vehicle in regards to recalls
http://www.lemonauto.com/complaints/mazda/mazda_b_series.htm

Nov 19, 2008 | 2007 Mazda B4000

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...