Question about Dodge Stratus

Open Question

Ac heating blower control motor relay wiring diagram

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: The heater / ac blower

It is the blower resister. I purchasted one at auto zone for $18.00. It is located under the passenger side dash. You need to remove the glove box and the plastic cover under the dash to expose the blower motor. the blower motor resister is right next to the motor. Simply unplug the resister remove the two screws and replace. I did this and now my fan works on all speeds.

Posted on Sep 17, 2008

Ad
emissionwiz
  • 76630 Answers

SOURCE: I'm looking for a diagram

The blower motor resistor on a 2002 Wrangler is behind the glove box, on the passenger side

Posted on Sep 26, 2008

  • 2 Answers

SOURCE: new climate control unit but when on blower not working for heat or ac

I'm assuming the problem is the blower motor isn't coming on or working. 1st, check the fuse. 2nd, remove the glove box or pull the 2 tabs that act like stops when it's open ( the glove box will open out further) and you'll see the power plug connector for the blower unit. Turn on the blower through the climate control (heat, A/C, or whatever) and wiggle the connector to see if the blower turns on. If starts working, then an easy solution is pull the connector off and gently press the prongs together or inward. Then carefully reconnect with damaging the prongs. This worked for 96 Mark VIII due to the fact the prongs were not "seating" correctly in the female connector. It's been about 2 years since I did this and the connection is still good. If wiggling the plug doesn't work, pull the plug, turn on the climate control (heat, A/C), and check for voltage to the plug. That's about all I can help with.

Posted on May 28, 2009

co7196
  • 3433 Answers

SOURCE: 2002 Lincoln Town Car AC Blower Motor Relay Location

Relays are normally located under the hood in a protective plastic box. Good Luck Ned

Posted on Oct 06, 2009

wracefans24
  • 1985 Answers

SOURCE: How to replace a heat/ac blower motor in a 2001 blazer

it is under dash ,behind glove box,not a hard job at all

Posted on Dec 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Heat not blowing in the front of a 2009 Ford flex


Something wrong with blower motor , controller or wiring or relay . Do you know what a wiring diagram is . Free wiring diagrams at http://bbbind.com/free_tsb.html . Check componets . electrical testing . Videos on youtube for testing blower motor electrical circuits

Dec 30, 2016 | 2009 Ford Flex

1 Answer

Only the fan climate control is not working. The display climate control is working but only the fan.


That is the heater / AC blower motor ! There are electrical circuits and relays and blower motor resistor , blower motor etc... Electrical testing is the way to diagnose blower motor circuit . Looking at a wiring diagram to see what controls the blower motor on your particular vehicle would be the first step in diagnosing your problem . Do you know how to do automotive electrical testing , how to read or follow a wiring diagram ? Videos on youtube show how to test blower motor and related parts and wiring . Blower Motor and Resistor Diagnostics by Wells

Dec 29, 2016 | Cars & Trucks

1 Answer

Heat/ac not blowing it was working for a couple days and just stopped I changed the blower motor and its still not working any assistance is appreciated!


You should have checked for voltage at the blower motor connector before replacing the motor .Could have a bad blower motor resistor, this part controls the different speeds . Have you checked for blown fuses ? There could be a bad blower motor relay ! Need to know year an make an model to check out wiring diagram to see what is involved in this circuit !

Feb 25, 2015 | Cars & Trucks

1 Answer

Type your problem for a solution..HEAT NOT BLOWING FUSE OK.


REMOVE HEATER BLOWER MOTOR AND HOT WIRE IT.IF HEATER BLOWER MOTOR WORKS WHEN HOT WIRED EITHER BLOWER RELAY BAD OR AC AND HEATER CONTROL SWITCH NOT WORKING.IF BLOWER DONT WORK WHEN HOT WIRED BLOWER MOTOR IS BAD.

Oct 25, 2011 | 1997 Nissan Quest

1 Answer

The fan isnt blowing so no heat no defrost etc..


CHECK SEE IF POWER GOING TO BLOWER MOTOR IF YES BLOWER MOTOR EITHER BAD OR HAS POOR GROUND SHORT IN WIRING CONNECTOR GOING TO BLOWER MOTOR AND RESISTOR.IF NO POWER GOING TO BLOWER MOTOR CHECK BLOWER MOTOR 30 AMP FUSE OR RELAY.IF BLOWER MOTOR OKAY AND FUSE RELAY OKAY THE AC AND HEATER CONTROL SWITCH COULD BE BAD.

Oct 22, 2011 | 2003 Pontiac Montana

1 Answer

Wiring diagram for 2005 Dodge Caravan, rear blower for heating /AC


The most common problem would be a bad blower at which you can test for power at the motor connector with a testlight, the other most common problem is the resisitor ,theres one for the front blower and one for the rear blower, you may have a bad resisitor for the rear blower this resistor is located next to blower.theres also arelay in the fuse/relay box next to the battery under the hood,the best thing is to start testing for ower at the switch and work your way to resistor, i think you will find a bad resistor to rear blower motor.heres a complete wiring diagram of the whole front and rear heat and ac unit, everything is labeled good luck.johnjohn2_51.gif

Jan 01, 2011 | Dodge Caravan Cars & Trucks

1 Answer

99 olds heater heats,but doesnt come on


CHECK HEATER AND AC IGNITION 10 AMP FUSE UNDER HOOD JUNCTION BOX.IF ALL IS GOOD CHECK BLOWER MOTOR FUSE AND RELAY.IF ALL LOOKS GOOD. TURN ON CONTROL SWITCH TO CHECK TO SEE IF POWER GOING TO BLOWER MOTOR IF YES BLOWER MOTOR BAD.IF NO POWER GOING TO BLOWER MOTOR FUSE AND RELAY GOOD.YOU HAVE BROKE WIRE BETWEEN SWITCH AND BLOWER MOTOR OR CONTROL SWITCH FAULTY. TO GET TO BLOWER MOTOR ITS LOCATED UNDER THE DASH ON PASSENGER BEHIND GLOVE COMPARTMONT YOU DONT HAVE TO REMOVE GLOVE BOX ITS JUST BELOW IT FAR BACK.YOU NEED TURN OFF RADIO FIRST THEN DISCONNECT NEGATIVE BATTERY CABLE WAIT 20 MINUTES THIS DISABLE AIRBAGS AND THE BCM.REMOVE BLOWER MOTOR HOTWIRE IT TO SEE IF ITS WORKS. IF NO BLOWER MOTOR NO GOOD.IF BLOWER MOTOR GOOD THE AC AND HTR CONTROL SWITCH IS BAD DEALERSHIP FIX.

Dec 30, 2010 | 1999 Oldsmobile Alero

3 Answers

'94 Cadillac DeVille Concourse. My winsdhield


Follow the wires from the blower motor back to the blower motor resistor, normally only a few inches away and held in by a 7 mm screw. Replace it

May 13, 2010 | 1998 Cadillac DeVille

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...