Question about 1987 Nissan Pulsar

1 Answer

Car turns over but doesn't fire nissan pulsar 2001

Change fuel pump just checked if there was a spark there was no spark

Posted by on

  • tggirl4
    tggirl4 Dec 26, 2013

    it not the fuel pump I have put a new one in it


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    A rookie expert who has answered 20 questions on their first day.


    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 109 Answers

Do all related fuses check good? Fuse box location and layout is in owners manual.

Posted on Dec 26, 2013

4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 22 Answers

SOURCE: fuel filter location on a

your car's fuel filter is located inside the gas tank near the floater.remove the back seat. you can see the fuel pump wires.remove the screws.pull it then you can see the fuel filter.

Posted on Aug 12, 2008

  • 720 Answers

SOURCE: how do i get to the fuel pump in a nissan pulsar

Hi there,

The fuel pump is mounted "inside" the fuel tank. You'll need to remove the rear seat (bottom portion) to gain access to the pump assembly.

If fuel is pouring out, then there is an obvious leak from either the hoses (attached to the fuel pump) or from the pump seal in the tank.

Here is the diagram:


Hope this helps...

** If the has helped you in any way, please rate this solution **

Posted on Nov 14, 2009

  • 1 Answer

SOURCE: i have a 99 nissan pulsar LX N15 having problems

I have same/similar problem.... if this problem happens off and on... runs well one day and next day is jerky-stalling then it's more than likely your airflow meter

Posted on Feb 26, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1987 Nissan pulsar It stopped on me while driving I change the fuel pump & fuel filter it started one time drove around the block came back turn the car off then tried to start it but got nothing

is there spark at plugs , check the coil packs as these older cars are prone to coil pack failure and at random times , if coil pack ok is the battery holding enough charge to firstly start engine and then alternator charging enough to keep it running , hope this gives you a starting place

Sep 10, 2015 | Nissan Cars & Trucks

1 Answer

91 pulsar n13 has spark has fuel wont start

If spark and fuel ok, the only other thing needed will be compression. Make sure the timing belt has not broken or jumped

May 17, 2015 | Nissan Pulsar Cars & Trucks

1 Answer

2001 Nissan Pathfinder won't start, fuel pressure ok, spark plugs not firing

make sure you have fire at the coil if not there will be no fire to the plugs

Feb 08, 2013 | 2001 Nissan Pathfinder

2 Answers

Have a Nissan Pulsar 1999 - 1.6L. Was running fine, stopped at an interesection, went splutter, splutter, stop. Plenty of fuel in tank. Have since changed the fuel filter, checked there is fuel being...

Okay Im confused it says a 1999 nissan pulsar 1.6 Then it says a 1995 licoln continental. HMMM HMM . Okay lets begin a nissan 1999 pulsar (by the way pulsar was stopped in 1989) 80 psi is more that enough feul pressure for either vehicle. Fuel filter is change food. There is spark okay. 5 short and 5 long alright 5long 5 short in nissan it means no problem system pass. 5 short 5 long in Ford means ECM internal failure. For the Ford the Harmonic balancer need to be look at there is a crank sensor but the crank sensor is dependant on the signal ring on the Harmonis balancer if you put you hand on it are you able to move it either way if you can then you found the problem and that can set off 5 long and 5 short. Now for the nissan, spark and fuel look on the air cleaner youll see a long black duct is it torn up or did it come apart if that came out it sputter and sputter then stall. and that will give a 5 short and 5 long.

Apr 22, 2011 | 1995 Lincoln Continental

1 Answer

Konked out still cranks wont fire 99 pulsar 1.6 auto replaced pump

Always check for the basics before replacing stuff to avoid time wasted and costs.
Check for spark at plugs while cranking,use a plug with a gap stretched out wide to work coil and module.It should be a healthy crack when it sparks.
Check for lack of fuel by spraying a carb or brake cleaner into open aircleaner while engine is being cranked.If it starts you will need to test fuel pump and power to it.
Check compression,nil or very low indicates broken timing chain/belt/keyway or internal damage.
I hope this helps,let me know your findings and we can work towards a fix.

Apr 01, 2011 | 1990 Nissan Pulsar

3 Answers

Engine cranks over but no fuel being pumped plus no power to fuel pump. No spark to the spark plug. I put new crank positioning sensor, new cam sensor, changed computer, checked fuel pump relays. Car...

Did you check your coil pac? This supplys power to all parts of your auto. I would check and see if your getting fire comming from your coil , Good luck to you.

Mar 31, 2011 | 2001 Nissan Sentra

2 Answers

My nissan pulsar 89 model won't start turns over fine but just won't start

There are only two problems but many solutions. Check if there is fire to the plugs. If there is fire check if there is gas going to the cylinder. Once you determine which of these you can address the specific problem.

May 16, 2010 | 1989 Nissan Pulsar

1 Answer

No spark from 1988 nissan pulsar


Jul 22, 2009 | 1988 Nissan Pulsar

1 Answer

Engine on my nissan vector wont spark.

If it is trying to fire up, then it is a fuel problem, not spark. Chk to make sure you are getting fuel

Jul 04, 2009 | 1988 Nissan Pulsar

1 Answer

Nissan pulsar wont start

Replace the sparks plugs, if the car is failing on one cylinder it will be hard to start.
Check the air intake and the air filter, if air filter is dirty replaced, only to test the car try starting with intake open and no air filter, if it starts it is an air intake problem.
Check the fuel filter and check that fuel have pressure, if fuel has no pressure it is either a faulty pump or an obstructed pipe.

Common cause for car not starting is distribution, with distribution rotor you often have to replace distributor cap or coil.
If it is electronic distribution you have to scan distribution module.

If you have an anti theft system, this can also cause the car not to start, usually you unlock anti theft with car key.

If it is none of the above, it can be a car computer problem, the car computer module (ECU) can be scanned using a code reader at any good garage, in this case the mechanic will get error codes from car ECU and be able to troubleshoot further the problem.

Aug 28, 2008 | 1990 Nissan Pulsar

Not finding what you are looking for?
Cars & Trucks Logo

323 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts


Level 3 Expert

75822 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides