Question about 2007 Ford Fusion 1.4

1 Answer

Where is the fuse on a 2007 ford fusion for the heater fan?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 3,103 Answers

In the fuseblock..it should be around 30 amp..

Posted on Dec 26, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

warlock61
  • 659 Answers

SOURCE: No transmission fluid Dipstick on my 2007 Ford Fusion

depending on which trans it is there is a small dipstick on the trans at the front on the bottom these transmissions take a specific fluid so be careful

Posted on Nov 22, 2008

  • 12104 Answers

SOURCE: Failed emissions What fuse for OBD port on 2006 Ford Fusion?

check the out put from the computer to the obd ll port if good need to check the wiring harness ,connections and pin contacts from computer to obd ll port connections possible short,frayed or broken wire

Posted on Feb 14, 2010

  • 3 Answers

SOURCE: where is the fuse box on an 03 ford fusion,looked

its behind the glove compartment

Posted on Apr 15, 2010

  • 55 Answers

SOURCE: I have a 2007 Ford Fusion. If I try to turn on

Probability is that the variable relay is burned only allowing partial power to the blower motor.

Posted on Apr 28, 2010

  • 2309 Answers

SOURCE: Ford fusion 2007, blown blower fuse, replaced

hte blower resistor is shot, near the blower motor, have the blower motor checked my guess is that it requiring too much power to run, hence the blown fuse

Posted on May 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 ford fusion heater fan not working.it was working sometimes but now it wont work at all.


Probably the blower motor is bad , worn brushes , armature commutator . They get worn spot on the commutator . You mite try hitting on the bottom of the blower motor housing to see if that makes it work . If it starts working the motor is bad .

Dec 21, 2016 | 2007 Ford Fusion

1 Answer

Key stuck in ignition in park. Check charging system comes on. Dealership says it might be a fuse.


Key Stuck in Ford Fusion (2006 model) - YouTube

? 1:21
https://www.youtube.com/watch?v=3LVQttFOzGA
Jun 18, 2014 - Uploaded by Jessica East
#Ford #Fusion #Key #ignition #Stuck #FordFusion2006. ... i have a 2006 mercury milan and my key got stuck in there last night,... it to park with a little bit of force. will see what happens next time. good video, nice to know.

Key Stuck in Ignition While in Park

www.2carpros.com/.../2007-ford-fusion-key-stuck-ignition-while-park
Dec 16, 2012 - KEY STUCK IN IGNITION / SHIFTER BINDING CONDITION FORD:2006-2007 Fusion LINCOLN: 2006 Zephyr MERCURY: 2006-2007 Milan

Nov 06, 2015 | 2006 Mercury Milan

1 Answer

My heater fan in my 2007 f-250 heater fan stopped working


Check blower motor electrical connection on back of blower and vacuum leak. Have you checked the fuses???

Jan 03, 2014 | 2007 Ford F-250 Super Duty Lariat

1 Answer

Relay and fuse identification 2007 ford fusion 3.0l


If you suspect you have a blown fuse, then you can find it in less than thirty seconds using my method. Instead of wasting time searching for the exact location, why not just remove each fuse 1 by 1, and keep putting them back (if good) as you go so you don't mix them up. If you have any blown fuses, you will find it! If you don't know the difference between a good vs blown fuse, ill post a picture to help you identify.

b8e8ddc0-8f9f-4da3-8213-71fdd5ac5af2.jpg

Dec 11, 2013 | 2007 Ford Fusion I4 SEL Sedan

1 Answer

Why did my 2005 Ford fusion ac/heat fan just stopped blowing. It was working great and then I made a quick stop and when I got back into the car and started it the AC fan stopped blowing?


you probably blew a fuse that fan has its own fuse believe it or not. look under driver side dash or left side of dash for the fuze box the fuses should be labled

Jul 08, 2012 | 2005 Ford Fusion

2 Answers

Ford fusion 2007, blown blower fuse, replaced fuse, works at highest speed only (highest of 4) the other three setings don't work.


hte blower resistor is shot, near the blower motor, have the blower motor checked my guess is that it requiring too much power to run, hence the blown fuse

May 06, 2010 | 2006 Ford Fusion

1 Answer

I have a 2007 Ford Fusion. If I try to turn on


Probability is that the variable relay is burned only allowing partial power to the blower motor.

Apr 27, 2010 | 2006 Ford Fusion

1 Answer

2007 ford fusion sunroof wont open what would be the cause of this


CHECK FUSE IF OKAY.CHECK TO SEE IF POWER GOING TO SUNROOF MOTOR SWITCH IF YES SUNROOF MOTOR COULD BE FAULTY OR IT NEED ADJUSTMENT.SWITCH COULD BE BAD.IF SWITCH IS GETTING NO POWER FUSE IS GOOD THERE IS A BROKEN WIRE FROM FUSE TO SWITCH.

Feb 22, 2010 | 2007 Ford Fusion I4 SEL Sedan

Not finding what you are looking for?
2007 Ford Fusion 1.4 Logo

Related Topics:

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...