2006 jeep commander replacing starter 3.7l - 2004 Jeep Liberty

SOURCE: Jeep Commander Rear Brake Pad Installation

Per Chilton Auto repair manual:

Removal & Installation

1. Raise and safely support the vehicle.
   
2. Remove the rear wheel.
   
3. Siphon a small amount of brake fluid from the master cylinder reservoir.
   
4. Insert a small prybar through the caliper opening and pry the caliper cover (using the outboard brake pad) to bottom the piston in the caliper bore.
   
5. Remove the caliper slide bolts.
   
6. Remove the caliper from the anchor.
   
   WARNING Support the brake caliper with mechanics wire. Do not let the caliper hang by the brake hose.
   
7. Remove the brake pads from the caliper.
   

1. Install the brake pads onto the caliper.
   
2. Lubricate the slide pin bolts with grease provided with the brake pads, or suitable silicon grease equivalent.
   
3. Install the caliper on the anchor and tighten the slide pin bolts to 18 ft. lbs. (25 Nm).
   
4. Install the rear wheel.
   
5. Lower the vehicle.
   
6. Pump the brake pedal several times until a firm pedal is obtained in order to properly seat the pads.
   
7. Refill the brake fluid reservoir to the proper level.
   

SOURCE: ac/heater fan switch problem on a 2006 jeep commander

next to the fan motor there should be a connector that has three or four wires that attached to the blower resistor. it should have two screws holding it to heater case, just pull it out and replace.

Testimonial: "This info was very helpful but need a little more info of where the fan motor is located. I will post another question to find that info."

Johnny Brown

• 5763 Answers
• Posted on Mar 16, 2010

SOURCE: 2006 Jeep Commander...cant find the starter???

iTS LOCATED AT THE BOTTOM OF THE ENGINE,AT THE REAR ON DRIVERSIDE,IN FRONT OF TRANY, HRERS A DIAGRAM TO SHOW YOU. HOPE THIS HELPS.

Mike Raatz

• 435 Answers
• Posted on May 21, 2010

SOURCE: install a altenator for a 2006 jeep commander

I would rate this a 5 in difficulty. If you have a metric socket set, basic hand tools and a supertine belt tool it's fairly easy repair. You can rent a surpentine belt tool at Autozone.

Disconnect the battery
remove the cowling
remove the supertine belt from the altenator pully
disconnect the red wire on the back of the altenator
disconnect the harness plug from the altenator
remove the bolts holding the altenator to the mounting brackets.
Reverse the process with the new altenator and it it's done.
Make sure your battery is charged before you start the engine a low battery can cause damage to your new altenator.

ZJ Limited

• 17989 Answers
• Posted on Jul 07, 2010

SOURCE: starter repair estimate

Check here for parts replacement and "How to": Jeep/Commander/Replacement/Starter

Hope helps (remember rated this).