- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Remove the door trim panel and replace the switch. You might be able to push up the switch from the door armrest from the hole below and in front of the armrest. Google the assembly pic. Or buy a Bentley EBahn CD and get access to EBahn Web.
Remove mirror mount cover assembly.
Remove inside door handle cup (22634).
Remove door lock control bezel.
Remove window control bezel.
Remove interior lamp lens.
Remove screw from interior lamp assembly body.
Remove screw from window control bezel opening.
Disconnect mirror, lock switches and memory seat on driver side from bezels and wire harness.
Disconnect window switches from window bezel and wire harness.
Lift front door trim panel (23942) vertically, out of weatherstrip and over lock rod.
Disconnect interior lamp (13776) from wire harness.
Remove front and rear door trim retention hooks into door inner panel.
To install, reverse Removal procedure, paying special attention when inserting inner door trim into weatherstrip. Rock inner door trim into weatherstrip and push downward until lower trim belt character ditch lines up with score mark on inner door panel.
You need to remove the vinel panel from the rear hatch.Peal back plastic from access hole. Remove 4 hexnuts that hold the tag light , hatch switch and window controller assemply in place.Pop loose assembly from hatch, remove 2pl head screws that hold opner switch to assembly didconect wireing conector. install new switch.
Most likely you have left the windows on that side of the car open a bitand water has cased some corrsion on the connections. You need to replace the switch if removing and cleaning connection does not work.
can you hear motor when switch is pressed if not check switch ,the motor sits in a regulator that controls the windows movement,you need to remove the door trim to get to the regulator which holds the motor,if you have very limited skill i wouldnt attempt it through trying to save money,
Remove the front door handle bezel.
Remove the window switch control bezel,snaps in.
Disconnect the window control switch connectors.
Remove the 3 door panel screws,should be 2 at bottom and one where the window control switch bezel was.
Lift the door trim panel by pulling directly upward on the armrest to disengage the panel clips. Unhook the mirror electrical connector.
Remove the 3 mirror nuts and remove the mirror.