Question about 1993 Chevrolet C1500

1 Answer

Pickup coil i don't know were it is what it looks like and how to replace it

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 3,103 Answers

Pickup coil is under the cap(distributor) and under the rotor..once the rotor is gone you take the star wheel off and the pickup is held in by small screws.. parts store can give exact intructions with pictures..

Posted on Dec 26, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1988 Ford Bronco II How to change Distributor Pickup Coil


how do you remove the gear on the end of distributor shaft so the pickup coil can be replaced

Nov 20, 2011 | 1988 Ford Bronco II

2 Answers

Need help Toyota 87 pickup wont start I replace the the ignition coil and distributor it wont start


fuel filter might be plugged if it turns over if it don't its ur starter if that don't work see if ur fuel pump is working

Jun 27, 2011 | 1987 Toyota Pickup

1 Answer

I replaced fuel pump , coil, pickup coil, rotor, distribitor cap, fuel filter, and fuel lines. why does it keep shuting down? had the same problem before,and the last thing i put in was the pickup coil.


I need to know if it has a carb or fuel injected. When it shuts down do you have spark check it with an old spark plug hooked to the wire and grounded to the engine. When it shuts down does it squirt gas down the carb when you move the linkage Or when you crank the engine can you see fuel going down the throttle body

Feb 16, 2011 | 1988 Dodge D-Series Pickups

1 Answer

Getting no fir to coil,changed coil and igniter,still no fire,can't afford much more. stab in fuses have been replaced under dash and under hood except larger amp fuses w/clear tops,visually look fine


Are you getting power to the coil from the ignition switch? Use a 12 volt test light with the clip attached to engine ground. Turn the key on and backprobe the connector terminal with the black wire/red stripe. If there is no power to the coil, trace the wire back to the ignition switch to see if it is broken, or replace the ignition switch.
If there is power to the coil, open the distributor and check the components there for excessive wear or broken wires on the pickup coil.
Please let me know if you have more questions.

jturcotte_241.gif

Nov 21, 2010 | 1991 Toyota Pickup

1 Answer

94 toyota camery 4 cyl wont start Ichecked the fuel injectors there ok checked fuel pump works fine replace distributor cap and the ignitor but I dont get a spark at the sparkplugs.henrys


check all efi and ign fuses first...then check pickup coil and ignition coil in distributor w/ ohm meter...since you already replace the ignitor, then mostly likely it's the pickup coil or ignition coil...buy the whole

Aug 22, 2010 | 1994 Toyota Camry

1 Answer

No spark replace ignition coil cap rotor no luck


IF I REMEMBER CORRECTLY THERE IS A PICKUP SENSOR ON THESE THAT LIKES TO GO BAD ON THE TOP OF THE DISTRIBUTOR, UNDER THE CAP. HOPES THIS HELPS. BEST OF LUCK.

May 07, 2009 | 1993 Toyota Pickup

2 Answers

1985 Dodge W-150 4x4 5.9 (360) has no spark at the plugs. I have replaced the plugs, wires, cap, rotor, coil, distributor, resistor and had the ignition module checked. I have plenty of fuel but no fire at...


got to be ignition module ,check for feed to it and if you have a feed then check the earths and if ok just change it ,these thing can just stop when you turn engine off ,never seen one go whilst being driven .

Dec 14, 2008 | Dodge W150 Cars & Trucks

1 Answer

Door handle replacement for 1997 Chevy pickup


Are you looking for a replacement procedure or the replacement handle?

Nov 20, 2008 | 1997 Chevrolet K1500

Not finding what you are looking for?
1993 Chevrolet C1500 Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...