Question about 2005 Ford Expedition

1 Answer

P1206 code is shown on a 2005 F150

My son' struck has this code with the check engine light. Just wondering what this issue is and how to resolve it? Throttle control actuator? Thanks in advance Dave

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Ford Master
  • 3,103 Answers

Or position sensor.. its what tells the fuel pump/injector system how much fuel to add while driving..these are on the opposite side of the throttle body from the linkage for the pedal..on the same shaft.. normally..

Posted on Dec 26, 2013


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 5537 Answers

SOURCE: My 2005 F150 with 5.4 goes to Idle while driving.

For this problem, I looked at the Code results. There are a few parts which can cause it, and in some cases the Dealer will need to install a Data Logger if microwave signals are suspected.

Ford has made modifications to this Throttle body, and parts were backordered for a redesigned throttle body. This may be covered under a Silent warranty and a one on one request for factory assistance.

Or you may try to replace the cheapest part, the throttle position sensor, Several people on the F150 forum changed out that part and it worked. Myself, even changing the sensor, I would want the best throttle body made for my truck. So rather than a patch, if a free factory replacement were offered, I'd take that.

Contact your favorite Dealer and see what they will do for you.

Posted on Jan 12, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Anti lock brake light on

Check for OBD Codes & diagnose them

Aug 13, 2014 | Cars & Trucks

1 Answer

2005 Altima auto zone code po725 poor connection between pcm and tcm what does this mean , check engine light is on how can I resolve this issues?

Google any codes you get

Nissan PO725

There are lots of sites with more info
than could ever read or understand

You have gotten the codes & now know you have
transmission issues,so you should stop using any
vehicle with any transmission problem immediately
& not drive one mile until resolved

You can ruin a trans in less than ten miles, if you use it
not knowing the problem

Aug 31, 2013 | 2005 Nissan Altima

1 Answer

P1206 fault code for 04 f150 5.4L

some fault codes stored in your car,
this tool can diagnostic your car and clear the fault codes.

Apr 26, 2012 | 2005 Ford F-150 Regular

1 Answer

My check engine light is on and I am wondering why.

Your check engine light is on because the PCM has detected an emissions related issue. If you want to find out the diagnostic codes the PCM has identified, go to Auto Zone - they will read the codes for free. Remember though, their main job is selling parts - so don't take their recommendations at face value - they don't have the ability to do a full diagnostic scan on your vehicle like your local trusty automotive repair facility.

May 31, 2011 | 2005 Chevrolet Impala

4 Answers

How do i turn off my check engine light on my f150 '02

It will have to be done with a code reader for obd2 system.

Apr 28, 2010 | 2002 Ford F150 Regular Cab

1 Answer

I have a 2005 F150, that has been running a little rough and the check engine light came on. Checked the code and it read 0305. I'm not sure what I should do next.

trouble code 0305 is for cylinder misfire. misfire code for cylinder #5 which is what a P0305 code represents. There will have leaking valve cover gaskets allowing oil to contact the boots of the ignition wires and short the high voltage to ground causing the this case check whether plug wires, sparkplugs and valve cover gaskets are in good shape .this will help you to determine the cause of your check engine light on. This will help. Thanks please keep updated.please do rate the solution positively .thank you for using fixya

Mar 17, 2010 | 2004 Ford F150

2 Answers

On my 2005 Tahoe how do I reset the check engine light?

the check engine light is indicating a problem with a control system. The resulting codes need to be fixed, then the light will be reset or go out by itself. If the problem resolves itself, or is intermittent, the light may go out by itself

Mar 05, 2010 | 2005 Chevrolet Tahoe

1 Answer

Emission light

map sensor. check your spark plugs, wires, etc. maybe a loose wire plug. did u mention check engine light, i wonder can you tell me what diagnostic code came up. go to ur nearest auto parts if u dont have a scanner. and pull them codes out.

Feb 25, 2009 | 2005 Ford F-150

1 Answer

2004 F150 4.6 won't start

Did anyone have a soluction to the above problems?

I have the same issue on 2005 F150 with 5.4L engine.

Nov 23, 2008 | 2005 Ford F-150

Not finding what you are looking for?
2005 Ford Expedition Logo

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers


Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides