Question about Cars & Trucks

1 Answer

Won't go into park with selector rod off on a gm truck

Removed gear shifter rod won't go back into park now

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 3,103 Answers

Did the vehicle roll at all once taken out of park before??should have taken the load off and blocked the wheels..try moving it a bit forward or backward..

Posted on Dec 26, 2013

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 295 Answers

SOURCE: The gear selector will not shift from park i've been told that one of the linkages is broken

The gear shifter has a switch inside of it. The shifter has to be replaced.

Posted on May 04, 2009

TwinTurboZ
  • 78 Answers

SOURCE: Wont shift out of park unless I stick a screw driver in a small hole above gear shifter.

You must remove the console yes, and you need to replace the shift lock solenoid.

Posted on May 15, 2009

  • 274 Answers

SOURCE: 97 chevy truck 1500 gear shift gets stuck in park

You can remove the interlock off the gear shift or maybe spray some crc on it otherwise probably a loose wire or switch

Posted on Jul 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why wont gear shifter go into gears


probably a bent or damaged cable/selector rod, not travelling like it did, have u scraped the bottom of the car on anything lately.

Aug 18, 2014 | Dodge Intrepid Cars & Trucks

1 Answer

How to adjust gear selecter indicater


The bushings in the rod that goes from shifter to transmission need to be replaced.

Apr 24, 2014 | Ford F-150 Cars & Trucks

1 Answer

Gear selector won't shift from park to reverse


Could be the brake switch or the solenoid that locks the shifter in park.
That circuit would need to be tested.

Sep 30, 2012 | 2002 Buick LeSabre

2 Answers

Ignition switch won't release key when it is put in park. But when I removed switch and key tumbler, the key tumbler/cylinder releases key. Why won't the key release when it is in park?


Most newer models have a safety feature called
shift interlock. This prevents the key from being turned back
to the lock position if you forget to place the gear selector in park.
Depending on the model,
If it uses a cable, it may be sticking or needs adjusting.
If it uses an electrical solenoid. may be blown fuse or park switch.
Tap, shake, and pull up on the shifter and make sure it's in park.

May 25, 2012 | 1993 Jeep Grand Cherokee

1 Answer

Why does the gear shifter lock up


gearbox selector out of adjustment at the gearbox
needs to be lined up in neutral position and rest should work

internal park locking pal worn

an engine/gearbox mount broken or sagging

Apr 30, 2012 | 1997 Pontiac Grand Prix

2 Answers

Went to start my car, wouldn't start, key was stuck, wouldn't shift, battery wasn't working, heard a clicking noise in the door, radio flashed once, console light up several times. Help! ...


The most commonly diagnosed component is the shifter and/or shifter solenoid on your Impala.
GM issued a bulletin on this problem. Contact your dealer, they are aware of the problem and you could be covered under warranty. Below is a copy of the bulletin.

#08-07-30-007A: EI08045 - Key Cannot be Removed from Ignition with Gear Selector in Park, Shifter Cannot be Moved From Park Position (Engineering Information) - (Apr 8, 2008)
999999995.gif
Subject: EI08045 -- Key Cannot Be Removed from Ignition with Gear Selector in Park, Shifter Cannot Be Moved From Park Position (Engineering Information)

Models: 2007-2008 Chevrolet Impala
Good luck, i hope this helps.

Jun 28, 2011 | 2008 Chevrolet Impala

1 Answer

Locked Ignition but steering wheel free


Push gear selector up past park and it should loosen up, or press hard on the brake pedal. Shifter up past park usually loosens it up. Common GM problem.

Nov 19, 2009 | 2004 Chevrolet Silverado 2500HD

1 Answer

My 1999 Chevy Blazer wont go into park


secure vehicle with chocks and set parking brake under vehicle check on drivers side of transmission selector control look at cable for binding or damage the cable snaps into place if looks good remove cable and try to put selector shifter into park[ if it goes in and stays than look back under vehicle and try to match up selector and cable.not reaching and trans selector in park adjust cable and reconnect try shifter for park] -if shifter doesnt go into park than check on dash plastic selector lock may b worn or damaged, if above is fine and selector/shifter is not problem than problem is internal inside transmission park rod damaged or broke good luck and thanks for using fixya

Oct 13, 2009 | 1999 Chevrolet Blazer

1 Answer

I believe the transmission linkage on my 2001 tahoe has somehow become disconnected. I'm looking for a diagram of this linkage. It is in park and when I go to change gears, the shifter just about...


look under the truck on the drivers side.you will see the shifter rod on the tranny. if the cable end is not connected to the ball reconnect it if its connected have some one move the gear selector while you watchit. if the cable doesnt move its broken and will need to be replaced. if the sector moves on the tranny and its not going into gear the tranny will need to come apart to find the problem. PS MAKE SURE THE TRUCK IS NOT RUNNING AND THE PERSON MOVING THE SELECTOR KEEPS THEIR FOOT ON THE BRAKE!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Jul 12, 2009 | 2001 Chevrolet Tahoe

1 Answer

The gear selector will not shift from park i've been told that one of the linkages is broken


The gear shifter has a switch inside of it. The shifter has to be replaced.

May 04, 2009 | 1999 Saab 9-5

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...