Question about Cars & Trucks

1 Answer

Po123 po221 Wash truck no thottler response engine ran fine let idail for

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 3,103 Answers

You washed it how .. with a pressure washer??you either floded key electrical components with too much water..or it blew some water into certain places it wasnt supposed to go..may be able to clear it up by spraying in there with wd40 on wires and connectors to draw moisture out..also coat the coil wires to the plugs..

Posted on Dec 25, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 Chrysler 300 codes po300 and po123


The P0123 means Throttle/Pedal Position Sensor/Switch A Circuit High Input.
The P0300 means Random/Multiple Cylinder Misfire Detected
Clear the code with OBD2 code scanner. If it comes back on, you
still have an issue.

Aug 22, 2012 | 2005 Chrysler 300

1 Answer

2004 jeep grand cherokee laredo, po162, po123


P0123 is a TPS/Pedal Position Sensor A Circuit High Input code. P0162is an 02 Sensor Circuit Malfunctoin (Bank 2 Sensor 3) problem.

Jul 01, 2012 | 2000 Jeep Cherokee

1 Answer

2004 intrepid replaced MAP sensor and cleared codes. about 100 miles later drove to work, 8hrs later started it and engine started intermittently revving at idle and in gear. had to keep heavy on throttle...


TPS wears in spots and can cause intermittent problems like you described. Try turning off the car and unpluging the TPS. Start the car and see if smooths out the idle/reving problem while the TPS is unplugged. If yes replace the TPS.

Aug 12, 2017 | 2004 Dodge Intrepid

1 Answer

I have a 2004 Cadillac CTS V6 In the last month when at a stop while the car is running fine we go to take off and the car does not want to go any faster then 40 mph. If you push on the gas the RPM's...


CODE PO221 IS THROTTLE POSITION SENSOR 1 - 2 RANGE CORRRELATION CONDITIONS. POSSIBLE CAUSES TPS SENSOR 1 CIRCUIT IS OPEN SHORTED TO GROUND OR HAS A HIGH RESISTANCE CONDITION, THROTTLE BODY ASSEMBLY IS DAMAGED OR IT HAS FAILED. ECM IS DAMAGED.

May 07, 2011 | Cadillac CTS Cars & Trucks

1 Answer

Has a new tune-up, but still stalls idail low


Mine did that.. Cleaned throttle body with carb cleaner.
Darn new Bosch plugs were junk so I replaced them with AC Delco. Idle speed picked up and it's been fine since then...Bosch plugs showed a slight mis-fire at idle every so often on the scanner.

Jan 12, 2011 | 2003 Chevrolet Silverado 1500

1 Answer

94 pickup, 2.4lL engine ran fine, was


get it hot and leave the hood up,hopefully the heat will dry it out.
NEVER pressure wash a modern car its full of electronics(its like putting a t.v. in the sink.....)

Jul 30, 2010 | 1994 Nissan Pickup

1 Answer

1997 F-250 7.3diesel DTC po221


Throttle/Pedal Position Sensor/Switch "B" Circuit Range/Performance

Jul 02, 2009 | 1997 Ford F350 Crew Cab

1 Answer

Check engine light


Please be advise that if you drive this and the check engine light is flash on and off. you should not drive it any more till you find the problem because you can cause more damage to the truck if the light is flash. there are many things that could cause this running condition: TPS, EGR, Bad injector, Idle air control and more would need to know codes that are in the computer, engine size 2 or 4 wheel drive, does it have A/C, Cruise, traction control, ABS brakes, then I maybe able to help you

Nov 01, 2008 | 1999 Jeep Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

80407 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15273 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...