Question about 2005 Honda Accord

Open Question

Honda Accord 2005 need to remove cent. console non ashtray lid

I have a quarter stuck under the spring lid of the nonashtray in the center console. It is preventing the lid from closing. How do I remove the lid and/or the whole little storage tray so I can get at the quarter? Help........

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: 2005 Honda Accord headlight replacement.

For the driver's side headlight, yes, the battery must be removed to change the headlight. There are three screws but they don't have to be removed, just loosened enough to where the bulb can rotate ninety degrees to pull out. Be prepared to reenter the radio code as disconnecting the battery will cause the radio to electronically lock out. The radio code can be found on the security card or inside the user's manual if you're lucky.

Posted on Nov 27, 2008

Ad
  • 1 Answer

SOURCE: cannot open top drawer in center console

A guy at Lexus helped. The console pops up and then there are two screws to undo. Took him about 5 minutes.

Posted on Mar 07, 2009

  • 1 Answer

SOURCE: Rear lid (houses top), opens only 1/4, stops, hums, and prevents roof from retracting in storage beneath lid.

As noted in one of the earlier questions on the topic, it appears (will verify for certain after the pump is removed) the plastic resevoir tank has cracked and the hydraulic fluid was lost. Leakage was visible in trunk once spare tire removed.
Audi also noted this is not unusual for a vehicle this age, and the replacement tank is a $100 kit.

Posted on May 20, 2009

c17hydro
  • 2984 Answers

SOURCE: 1996 Honda Accord Timing Belt Installation. I need help.

You didn't post the size of motor so please use the one that is for you:

2.2L (F22A1) ENGINES
Install the timing belt, around the pulleys, in the sequence shown


26f5cb1.gif

a9d5be6.gif

Posted on Jun 30, 2009

  • 6 Answers

SOURCE: 2005 Honda Accord Front Bumper cover replacement

easy there is a screw on both sides were bumper and fender meet just pop back fender liner its a phillips head. Then pop hood remove clips on black trim infont of radiator. Underside where bumper goes under car remove those clips and 10mm bolts after all is removed bumper just pulls off ...... may have to give it a hard **** a few times but it will come off. Should only take 15-20min to remove if its your first time

Posted on Jul 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the Bose amp located in a 2010 srx luxury edition


Audio Amplifier
In left rear quarter panel behind trim panel

Aug 12, 2017 | Cadillac SRX Cars & Trucks

1 Answer

How to maneuver the center console out of a 2008 Chrysler Sebring to replace interlock spring?


Take a close look at the shift interlock cable, can repair without removing the console entirely. Might want to contact your local dealer see if there is any open recalls.

Oct 17, 2015 | 2008 Chrysler Sebring

1 Answer

How to remove the center armrest console froma ford escape 2002 model


there are about 8 torx screws (very small) near the hinge of the lid. remove those and the lid will come to remove the entire console, there are bolts on the back of theconsole accesible from back seat, and on the side of the console. easiest way to acces those bolts would be to remove the front two seats. they are held in by two bolts in front and two nuts under plastic covers in the back. raise the emergency brake lever and the console will slide up and be removed.

Nov 04, 2014 | 2002 Ford Escape

1 Answer

How do i remove center console on 1999 blazer?


Try the sides down beside the seats or down under the lid or remove cover over shifter stick they could be covered by it.

Jul 22, 2014 | 1999 Chevrolet Blazer

2 Answers

2010 honda pilot center console removal due to vibration underneath


slide both seats all the way forward remove screws in sides of console if no screws on sides slide seats back and pull center from inside remove two bolts remove side skirt on each side screws under them remove ashtray center pocket screws under it also unplug wire connectors and remove

Jul 29, 2012 | 2010 Honda Pilot

1 Answer

UNABLE TO LOCATE PLUG FOR DIAGNOSIS OF CHECK ENGINE LIGHT


It's located at the front of the center console, directly below the radio, behind the ashtray. Yes, you'll have to remove the ashtray to get to the OBD plug.

Sep 07, 2011 | 1997 Honda Accord

1 Answer

How to replace the rear shocks on a 1998 nissan maxima


REMOVE REAR SEAT AND PACKAGE SHELF TO GAIN ACCESS TO THE UPPER SHOCK ATTACHING NUTS.REMOVE UPPER ATTACHING NUTS. RAISE VECHICLE REMOVE REAR WHEEL AND SUPPORT THE LOWER CONTROL ARM WITH A JACK REMOVE LOWER SHOCK ABSORBER MOUNTING BOLT. REMOVE SHOCK ABSORBER ASSEMBLY FROM THE VECHICLE. COMPRESS THE COIL SPRING WITH THE PROPER SPRING COMPRESSOR TOOL. REMOVE CENTER RETAINING NUT HOLDING THE UPPER MOUNTING INSULATOR. SLOWLY DECOMPRESS THE COIL SPRING.REMOVE THE MOUNTING INSULATOR AND THE COIL SPRING. REMOVE THE COIL SPRING. TO INSTALL COMPRESSED COIL SPRING ONTO THE STRUT ASSEMBLY. BE SURE TO THE END OF THE SPRING IS IN THE NOTCH ON THE LOWER SEAT.INSTALL UPPER MOUNTING INSULATOR. YOU WILL NEW LOCKNUT FOR THE CENTER RETAINING NUT OF THE COIL SPRING. CENTER RETAINING NUT AND TORQUE THE NUT TO 13 TO 17 FT LBS. SLOWLY REMOVE THE SPRING COMPRESSOR TOOL. INSTALL SHOCK ABSORBER ASSEMBLY IN THE VECHICLE AND INSTALL THE MOUNTING FASTERNERS AND TORQUE LOWER MOUNTING BOLTS TO 72 - 87 FT LBS. INSTALL WHEEL.LOWER VECHICLE. WARNING COIL SPRING UNDER EXTREME LOADS WHEN COMPRESSED.BESURE TO PROPERLY ALIGN THE SPRING WITH THE COMPRESSING TOOL TO PREVENT PERSONAL INJURY FROM THE SPRING RELEASING UNEXPECTEDLY.

Feb 02, 2011 | 1998 Nissan Maxima

1 Answer

My jag x type 02 wont open the gas lid and i am stuck coz it need re fueling. can someone please help


Inside the trunk compartment you will have to remove the molded apholstery on the pasenger side starting with the center peice where the latch is. Once you remove the center peice, remove the trunk seal ( of wich you can reinstall very easily) and pull the carpeted aphostery to the side to get a view of the inner quarter panel. You will see a yellow handle marked for the gas door. Just pull on that and that will release the catch for the gas door.

Dec 19, 2010 | 2002 Jaguar X-Type

1 Answer

How to change shifter light on floor center console, ive removed the main bolts from the rear of console and the brass fittings inside the center compartment but can not get it to move, ive also tried the...


The shift indicator light is under the plastic trim panel on the center console.

Open the lid to the console, and the latch location, you will see the separation. Use a plastic trim tool in here, or along the sides.
The silver color where the cup holders are at is all 1 part, and comes out together. The shift indication scale stays with the shifter ( the chrome trim stays with the shifter as well ).
The spring clips can be tough to pop the 1st time. Best to use a plastic trim tool or if you do not have that, a plastic putty knife.

Nov 20, 2010 | 2004 Ford F150

1 Answer

How do I remove the radio on a 1987 Honda Accord LXi


Radio & Tape Player
  1. Disconnect the negative battery cable. If so equipped, disable the Supplemental Restraint System (SRS).
  2. Remove the floor console and the front console panel. On 1984-85 cars, if access to the back of the radio may be gained through other means, such as removing the "pocket" from the console, the console need not be removed.
e4b1a33.gif
Radio mounting on 1986-89 Accords

  1. Remove the ashtray and ashtray holder.
  1. On 1986-89 cars:
  2. Remove the coin box, air vents and ashtray lighting bracket.
  3. Remove the dashboard switches on the left and right of the steering wheel.
  4. Lower the steering wheel to its lowest position. Remove the dash visor. This is a large, one-piece assembly which includes the center dash trim. It's plastic; don't break it.
  5. Remove the two screws holding the radio at the rear of the unit.
  6. Carefully push the unit out the front of the dash. When access is gained, disconnect the multi-pin connector and the antenna cable from the unit. Remove the unit.
  7. Reinstall in the reverse order. Take great care not to damage the dash trim and instrument visor. Make certain the connectors are firmly and squarely installed. If applicable, be sure to enable the SRS.

Dec 07, 2009 | 1987 Honda Accord

Not finding what you are looking for?
2005 Honda Accord Logo

Related Topics:

489 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...