Question about Cars & Trucks

1 Answer

Problems with 1995 Intrepd

Electrical problems on 1995 Dodge Intrepid

Posted by on

  • David Mays
    David Mays Dec 25, 2013

    All at once from 1 driving cycle to the next.....the fuel guage won't work, the automatic climate control is erratic with the vents and the fan speed, the wipers wont work on intermittent or low and high but will work by pushing the washer. It will swipe once or will swipe 3 times if you hold it in and wash, the door locks wont work from inside but will work off the key fob. I tested the key switch and it is working properly. I have read numerous articles on the BCM. Is it a different module than the ECM?



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 3,103 Answers


Posted on Dec 26, 2013


3 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 4 Answers

SOURCE: front cv axle 1995 dodge intrepid

Naturally you need to remove the tire then the brake caliper. After the brake caliper is removed then you need to remove the 34mm axle nut that is inside the hub. After that is removed then you can remove the hub. Becareful not to damage the hub seal on the back or you will have to buy a new hub (100 or more). Then you need to remove the strut knuckle assembly. Once the knuckle assembly is removed then you can pull the CV axle. Take care the inner CV housing is held in place by an inner snap ring. You will probably have to pry off the inner housing. Once the axle is off then install the new axle (if you buy complete axle). Make sure if you are doing both that you take care which side you are installing. I made that mistake and double the work. Slide the new axle on the spline and make sure it is seated completely. Then put back together the reverse of removal.

Posted on Mar 24, 2009

  • 412 Answers

SOURCE: 99 intrepid electrical problems

i have seen an ignition switch cause exact same problems you are having on 1 of these vehicles..needs to be replaced

Posted on May 19, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Hard cold start for 99 intrepd w2.7l/ ok hot/set check eng lite

Check your Fuel Filter, especially if your in a cold climate that has already reached freezing temps. If you have any moisture in your fuel system and the freezing temps have arrived the filter and injectors can freeze up slightly causing this type of problem. If this was happening in warmer temperatures check the fuel system for pin hole leaks that could be allowing the air into the system.

Nov 23, 2011 | 1999 Dodge Intrepid

1 Answer

My 1995 dodge intrepid is leaking oil from underneath the car. what is wrong

it could be numerous problems. First need to find out what are under the car is leaking and where it may be leaking from. You have a oil pan that could be leaking, the valve cover could be leaking and the oil running down making it look as if it;s from under the car. Is this oil or transmission fluid?

Jun 23, 2010 | 1995 Dodge Intrepid

1 Answer

Can you give me a spark plug wiring diagram for a 1995 Dodge Intrepid?

1995 Dodge Intrepid 3.3 liter V-6 VIN "T"


1995 Dodge Intrepid 3.5 liter SOHC V-6 VIN "F"


Hope this help (remember comment and rated this).

Apr 08, 2010 | 1995 Dodge Intrepid

1 Answer

Replace fuel pump on 1995 dodge intrepid but not

where is the asd relay located in a 1995 dodge intrepid?

Jan 03, 2010 | 1995 Dodge Intrepid

1 Answer

What does the code 1255 mean in a 1995 Intrepid?

That's probably code 12 & 55 which means 12-battery has been disconnected recently, and 55 is end of codes. In other words, nothing to worry about. Are you having any problems?

Jul 06, 2009 | 1995 Dodge Intrepid

3 Answers

Turn signal problems

Turn signal flasher should be plugged in on fuse panel.

Jun 02, 2009 | 1995 Dodge Intrepid

1 Answer

99 intrepid electrical problems

i have seen an ignition switch cause exact same problems you are having on 1 of these vehicles..needs to be replaced

May 14, 2009 | 1999 Dodge Intrepid

1 Answer


I finally solved the problem to my 1995 dodge intrepid. The problem was the ignition coil and wireset. I changed them and the car is like new.

Sep 17, 2008 | 1995 Dodge Intrepid

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides