Question about Toyota Sequoia

1 Answer

Beep when locking door

I own a 2002 Sequoia. Today the beep stopped when locking via the key fab. The two beeps still work when unlocking. I've discovered that the passenger rear side door lock will no longer roll to the unlock position. I believe this is the root cause of the problem. What do you think?

Posted by on

  • pdeluca5
    pdeluca5 Dec 25, 2013

    Will do...thanks!

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 3,103 Answers

Its possible .. get that closing relay control checked..or the control module also..

Posted on Dec 25, 2013

  • pdeluca5
    pdeluca5 Dec 25, 2013

    I will have that checked out. Thanks.

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 625 Answers

SOURCE: 2004 tahoe

make sure than you have not split any fluids on the passenger front door most of the times is where the module to control the windows and doors is located, try by unpluging the batterie and the after a minute plug it back and see what happend but if any of your ft doors have been split with liquid or rain has gone inside then most likelly the module got moisture and not working

Posted on May 31, 2008

  • 1 Answer

SOURCE: Ford F150 Pickup 2005 power doors unlock but will not lock

I had almost the identical problem on my 2005 F150 FX4 Extended cab last weekend. The power door locks would not lock using the keypad, remotes, or door buttons. Almost all other functions worked correctly. The doors unlocked, the radio delay functioned, and the interior lights dimmed. When I used the remote the horn would beep twice indicating that a door was open even there was no message on the message center that a door was open. When I used the keypad or remote, I could hear a soft click from behind the seat. I think it was coming from the body security module or body security module - whatever Ford is calling it this year. I pulled the fuse for the Power Door Locks(BSM). As I removed it, I heard a soft click - sort of like a relay resetting. It may have come from the VSM/BSM. It may have possibly been a stuck actuator releasing. I don't think so. It wasn't that load. In any case, everything is functioning correctly now.

Tracy

Posted on Nov 20, 2008

  • 1 Answer

SOURCE: Door Locking Problem

Hi Bgood,
I had the same problem. I locked and unlocked the car with the engine run several time utilizing the dashboard lock button. That fix my problem.

v/r
BM

Posted on Jun 23, 2009

  • 1 Answer

SOURCE: 1998 Toyota Corolla Electric Door Lock Problem

You'll need to replace the solenoid (motor) that doesn't work. Not hard once you get the door panel off. I suggest you buy the correct part, not a universal one.

Posted on Jul 14, 2009

  • 185 Answers

SOURCE: Doors won't lock with remote on my 2002 Lexus GS 300.

are you sure the battery is good in the remote? if so try putting the key in the driver door lock and locking and unlocking the doors three times in a row. if this dosent work i suggest taking it to an experienced lexus shop.

Posted on Oct 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I unlock & open drivers side door, when key & key fab won't work?


Why won't key work in door? Most likely not used? Spray wd-40 in door lock and insert key moving it back and forth in a sawing motion. This will usually free up a sticky lock and you can then turn it. Most lock out companies use a long metal rod. They will pry back the top of the door where it meets the roof and insert a wedge to hold the door slightly ajar and then insert the rod which has a hook to catch the lock and unlock it. A coat hanger unfolded will usually do the trick with a little patience. If not, the only other way is to disassemble the inner door panel ( usually causing damage ) to get the door open

Oct 18, 2015 | 2000 Jaguar Vanden Plas

1 Answer

Beep does not sounds when locking


Very possible. Each lock has to fully complete it's movement in order to send an "all lock" signal to transceiver. If not, you may wake to a dead battery as the alarm retries the last command to lock repeatedly.

Dec 25, 2013 | 2002 Toyota Sequoia

1 Answer

Power door locks will not lock except manually


First of all, check ACC fuse in the driver side junction box. The central controller for power door locks is the body ECU. From your description it may be working only partially. Can the doors be locked using a key? If so, this would indicate the actual locking mechanism is OK. Do the front door lock control switches lock the doors?

Oct 25, 2012 | 2002 Toyota 4Runner

1 Answer

Doors lock when I turn the key in the ignition to on and unlock when I turn it back to off, just started today and unsure of why. How do I stop it from doing this? Mitsiubishi Lancer Cedia Wagon.


usaully this is done by the keyfob when u press it to lock the doors,if u take and hold down the keyfob your horn will beep1 time it will lock your doors keep holding it down it should beep again after this unlock your doors this should reset this.

Apr 05, 2011 | 2002 Mitsubishi Lancer

1 Answer

The driver side door will not lock or unlock using key fab. Only the passenger and trunk will unlock. Cannot lock my car unless i manually lock my drivers side door, shut it then hit the lock on the key...


some how lever to the lock unit came off , need to open the interior panel of the driver door and put back lever to the lock unit. It should work.

Dec 14, 2010 | 2002 Toyota Celica

1 Answer

Keyless entry on my 2004 toyota sequoia won't activate any door locks. Door locks will only work when key is in start & run position when pushing button on drivers door panel. Anyone know whats the...


do you hear the Beep when you press on the remote to lock/unlock? this is to make sure there is communication with system components....
easiest ting you may do is to reset to system defaults... remove Battery -ve cable for a while... then things should return to normal otherwise you need to check with technician

Nov 12, 2010 | 2004 Toyota Sequoia

2 Answers

2002 pontiac grand prix - power door locks


I do believe the 3 beeps are telling you that you are about to lock your doors. Additonally that should signal you that have your keys in hand before you locks your keys inside the car. It's just an aural warning reminder that your doors are about to be locked.

May 06, 2010 | 2002 Pontiac Grand Prix

1 Answer

Strange beeping in my 2003 Alero


hey check the fues frist. then take a light tester aand see if you have power to your switch. . if every thing work out good it will be the switch

Feb 17, 2009 | 2003 Oldsmobile Alero

3 Answers

Ford F150 Pickup 2005 power doors unlock but will not lock


I had almost the identical problem on my 2005 F150 FX4 Extended cab last weekend. The power door locks would not lock using the keypad, remotes, or door buttons. Almost all other functions worked correctly. The doors unlocked, the radio delay functioned, and the interior lights dimmed. When I used the remote the horn would beep twice indicating that a door was open even there was no message on the message center that a door was open. When I used the keypad or remote, I could hear a soft click from behind the seat. I think it was coming from the body security module or body security module - whatever Ford is calling it this year. I pulled the fuse for the Power Door Locks(BSM). As I removed it, I heard a soft click - sort of like a relay resetting. It may have come from the VSM/BSM. It may have possibly been a stuck actuator releasing. I don't think so. It wasn't that load. In any case, everything is functioning correctly now.

Tracy

Oct 29, 2008 | 2005 Ford F-150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

145 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...