Question about 1991 Honda Accord

Open Question

Missing VECI Label 1991 Honda Accord

Does anyone have a picture of or the information contained on the VECI label for a 1991 Honda Accord?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

MNfisherman
  • 11896 Answers

SOURCE: Honda Removal of factory radio 1991 Accord lx

start by removing the console. there should be four screws that hold it in; two on each side; one in the front and one in the rear. you may have to take the gearshift knob of if the car is manual trans.then, remove the ash tray. there are two screws at the front of the ashtray receiver and one at the back.with the ashtray and slide removed, take the bezel off of the radio. there should be two screws behind or above the air outlet vents on top andn two screws in the under the center dividing rail. you may have to pop out the air outlets to get to the screws. there may also be a screw at the bottom of the bezel in the center.with the bezel removed the only thing that holds the radio in at that point is two screws that come up from underneath where the ashtray receiver was. take out those two screws and the radio should pull out from the front. Be sure to disconnect the antenna lead and the connector from the back of the radio before pulling on it too hard or you'll damage one or the other.hope that helps

Posted on Jan 17, 2009

  • 5 Answers

SOURCE: 1991 Honda Accord brake light probelm.

Check the prones inside the connector that you plug into the brake light module. You may have to squeeze, wiggle, tilt each one to see which one is not connecting all that good. I know it may sound confusing. I tried to explain the best of I could.

Posted on Apr 29, 2009

  • 75 Answers

SOURCE: Owners Manual

Just type in. free copy of owner manual for a 1991 Honda,

Posted on May 24, 2009

philschneide
  • 448 Answers

SOURCE: ac compressor clutch relay 1991 honda accord

Difficult to describe, but I will give it a try.
Inside the driver's side fender, close to the front of the car, there is a bracket that is held in place by one bolt, but which has a short horizontal bar as part of it which has two large clips encircling two cylinderical devices which have wires clipped into them at the bottoms. The one closest to the front (radiator) is the compressor clutch relay. The other one is the condenser fan relay.
Hope this helps you find it.

Posted on Oct 20, 2009

  • 159 Answers

SOURCE: diagram of the 1991 honda accord firing order

What type of diagram?

Posted on Dec 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Spark plug gap 2004 chevrolet venture 3.4


Look on the white label under the hood. That would be the Vehicle Emission Controls Information, or VECI label. The spark gap is given there.

May 30, 2017 | Chevrolet Cars & Trucks

2 Answers

Spark plug gapfor2006envoy


It would give the plug gap on the Vehicle Emission Control Information label (VECI label) that is pasted to the radiator support or under the hood. A long white sticker label, with emissions information for that particular vehicle. The spark plug gap is always listed there.

Oct 23, 2016 | 2006 GMC Envoy

1 Answer

Vacumn line routing for 97 dodge 5.9ltr Cummins diesel 4X4


VACUUM DIAGRAMS


By law, each vehicle is equipped with a Vehicle Emission Control Information (VECI) label which is permanently affixed. On the models covered in this guide, the label will be found in the engine compartment with typical locations being on the underside of the hood, the top of the radiator, the alternator bracket and the air cleaner box.
The VECI label provides a vacuum schematic for the vehicle in question. Because vacuum circuits will vary based on year, various engine and vehicle options, always refer first to the vehicle emission control information label.
VECI labels are designed to be permanently attached to the vehicle and cannot be removed without being destroyed. Absence of the label in your vehicle may indicate undocumented repair work has been performed.
If you wish to obtain a replacement emissions label, most manufacturers make the labels available for purchase.

Feb 14, 2016 | Dodge Cars & Trucks

1 Answer

1995 Toyota camry sedan 4door 1838cc 16v 5speed manual needs timming degree is it 5degree or 4degrees bftdcentre


You won't notice the difference. Generally there is a leeway of plus or minus 2 degrees from that specified. The actual timing figure would be shown on the under hood VECI label or sticker (Vehicle Emission Control Information), the rectangular white label.

Sep 22, 2015 | Toyota Cars & Trucks

1 Answer

Where does the timing mark on the timing cover line up on a 1997 Buick lesabre 3.8 liter?


Look on your VECI label under the hood (Vehicle Emission Control Information) for the base timing spec. When you shine a timing light down there on it with engine running at idle, the mark should be on the correct position on the scale-whether at 8 degrees Before Top Dead Center, or 10 degrees BTDC, whatever the VECI label says.

Apr 11, 2013 | Cars & Trucks

1 Answer

Spark plug gap size for 1991 formula firebird


See if you still have the Vehicle Emission Control Information label (the VECI label) under the hood on some radiator support member, probably. The spark plug gap is listed on it.

Feb 08, 2013 | 1991 Pontiac Firebird

1 Answer

5 an 6 cylinder misfires


Check on the VECI label under the hood, vehicle emission control information, the long rectangular label. It shows tune-up specs and spark plug gaps. And yes, halphin, the wrong gap can cause a misfire, if too far off.

Jan 07, 2013 | Cars & Trucks

1 Answer

Where is the main fuse box of signal lights and stop lights of a 1991 honda accord 4 cilinder.


HI. This vehicle contains a under the hood relay box near the front corner of the battery(which is labeled if not deteriorated), and there is also a fuse container box located below the left side of the instrument panel, as well(inside the vehicle on driver side).

The under-hood fuse box generally contains fuses and relays for engine and major electrical systems such as air conditioning, headlights (left and right respectively), fuel injection components, etc. The in-car fuse-box holds fuses for the cabin circuits such as wipers, cigarette lighter, rear defogger, signal lights etc.

Under hood Relay box:

11_1_2011_2_57_10_pm.jpg

Inside/Driver side panel:

11_1_2011_2_58_57_pm.jpg

Oct 30, 2011 | 1991 Honda Accord

1 Answer

Need a diagram of the vacuum lines 1999 sunfire


f

135c7a8.jpg

Fig. 1: The Vehicle Emission Control Inform
ation or VECI label is usually attached to the passenger side strut tower in the engine compartment


If you wish to obtain a replacement emissions label, most manufacturers make the labels available for purchase. The labels can usually be ordered from a local dealer.


6adf2a9.jpg


Fig. 5: 1996-00 2.4L (VIN T) vacuum diagram



5ccacba.jpg

Fig. 6: 1998-00 2.2L (VIN 4) vacuum diagram



I hope help with this (remember rated and comment this help).

Mar 03, 2010 | 1997 Pontiac Sunfire

Not finding what you are looking for?
1991 Honda Accord Logo

Related Topics:

129 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...