Question about GMC Jimmy
HOW TO REMOVE GRILL 1998 GMC JIMMY
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Gently pop off the horn cap / cover.
There will be a short wire attached, so be careful not to pull it too hard.
You will see the wire going into the metal frame of the steering wheel.
The wire will go into a "sleeve". Push the sleeve in, and turn slightly counter-clockwise to unlock the connector. The horn will beep a few times as you pull the wire out, just to warn you :)
You will now need a steering wheel puller. These can be bought for about $10 at any auto parts store.
Once the wheel itself is off, you will see a black plastic disk. remove it. Now you will see a metal disk with notches in it (this is what locks the steering wheel when you turn the key off). You may want to get someone for assistance for this one, as there is a pretty stiff spring behind the disc, so use caution. You will need to push the disc towards the dash and remove the retainer clip.
Once that is off, you will see the white turn signal switch. Remove the hazard switch button first, then the turn signal lever retaing screw (be careful if it has cruise control, as the wires are thin and delicate), then remove the 3 phillips head screws holding the actual switch on. Let the switch hang out of the way.
Now, you'll see the lock cylinder retaining screw. This is where you may have a problem if you don't have a key.
After removing the screw, you MUST turn the ignition switch to the "run" position and pull out the assembly.
Posted on Jun 19, 2008
u will need a steering wheel puller,u will have to disharm and take airbag off if equip.,i would suggest to get manual it explains step by step procedure!
Posted on Apr 25, 2009
I experienced this problem, intermittant failure to start. This procedure must be done with the truck RUNNING.
Remove the cover off of your ignition switch. On the top there is a small wire connector that, once the truck is running, should be disconnected. This will turn on the 'SECURITY' light. All will be better, except the security light will be on at all times, much cheaper than replacing the ignition switch, however.
Posted on May 10, 2009
You will have to remove the differential cover on the rear end, in the center of the gear cluster you'll have to rotate your axle until it exposes the ends of the axle shafts, push in the axles as far as you can from the brake pad assembly area, then, there this a C clips that slips into a groove on the end of the axle, you'll have to reove the C clip to pull out the axle.
Posted on May 12, 2009
Tips for a great answer:
Aug 31, 2014 | 1998 GMC Jimmy
Nov 25, 2012 | 1998 GMC Jimmy
Jul 17, 2011 | 1998 GMC Jimmy
Feb 06, 2011 | 1999 GMC Jimmy
Dec 13, 2010 | 1998 GMC Jimmy
Jun 15, 2010 | 1998 GMC Jimmy
Jan 26, 2010 | 2001 GMC Jimmy
Jun 22, 2009 | 1998 GMC Jimmy
Jan 30, 2009 | 1999 GMC Jimmy
27 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: