Question about 1994 Dodge Caravan

1 Answer

1997 dodge ram 2500 van need to remove rear door latch linkage

It looks like the four rods should pop out of the seats, but are not coming out.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 396 Answers

Assuming you are reffering to the push rods. When engine is operating these rods spin around. They ar stuck, spray some liquid lock wrench into the rods, wait a couple days then try turning them by hand.

Posted on Jul 13, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does the rear door not open?


If neither handle works, then it is the latch. There is a rod that is held to the latch with a plastic clip. It could've broke or just opened up, releasing the rod. You have to remove the rear seat, it pops up. Then remove the door panel. Be careful, it can break. Remove the plastic sound barrier. shine a light towards the latch, look for the yellow clip. Pull/push up on it and the door will open. Repair what is needed.

Aug 11, 2014 | 2007 Chevrolet Impala

1 Answer

Manual door lock linkage repair 2005 dodge 1500 the rod has broken louse and fell need to know how to recorect


remove the door trim and you will find a rod that is held in place in the door latch by a plastic (what remains of it) clip. There may be replacement clips available from the dealer spares otherwise cruise the wreckers and get some spares . They go brittle and break off. There are steel one that will do the same job

Jul 21, 2014 | 2005 Dodge Ram 1500

1 Answer

Sounds like my shift linkage in my ram van 1997 might be bad


What does bad shift linkage sound like? What, exactly is your question?

Apr 14, 2012 | 1997 Dodge Ram 2500 Club Cab

1 Answer

I need help on removing door panel on 2000 Dodge Caravan - window fell in dorr and I can not seem to get the panel off. Any suggestions?


Answer
FRONT DOOR TRIM PANEL
REMOVAL
Using a trim stick (available from parts stores), pry courtesy lamp from door trim.
Disconnect wire connector from courtesy lamp.
If equipped, remove screws attaching door assist handle to inner door panel.
If equipped, remove screw attaching door pull cup to inner door panel.
If equipped, remove screws attaching trim panel to door from below map pocket.
If equipped, remove window crank.
Using a trim stick, remove screw cover from switch panel.
Remove screws attaching switch panel to door trim.
Remove power accessary switch from door trim Front Door Switch Panel
Disconnect power switch from wire connector.
If equipped, using a small, flat bladed pry tool, remove memory seat/mirror switch and disconnect wire connector Memory Seat/Mirror Switch
If equipped, remove screw holding door trim to door panel from behind inside latch release handle.
Disengage clips attaching door trim to door frame around perimeter of panel Front Door Trim Panel
Lift trim panel upward to disengage flange from inner belt molding at top of door.
Tilt top of trim panel away from door to gain access to latch linkage.
Disengage clip attaching linkage rod to inside latch release handle Inside Door Handle Linkage
Separate linkage rod from latch handle.
Remove front door trim panel from vehicle.
INSTALLATION
Hold top of trim panel away from door to gain access to latch linkage.
Place linkage rod in position on latch handle.
Engage clip to hold linkage rod to inside latch release handle.
Place front door trim panel in position on door.
Install trim panel into inner belt molding at top of door.
Install clips to attach door trim to door frame around perimeter of panel.
If equipped, install screw to attach door trim to door panel behind inside latch release handle.
If equipped, connect power switch into wire connector.
Place power accessary switch in position on door trim.
Connect wire connector into memory seat/mirror switch and install switch into trim panel.
Install screws to attach accessary switch panel to door trim.
Install screw cover into switch panel.
If equipped, install window crank.
If equipped, install screws to attach trim panel to door inside map pocket.
If equipped, install screw to attach door pull cup to inner door panel.
If equipped, install screws to attach door assist handle to inner door panel.
Connect wire connector into courtesy lamp.
Install lamp in door trim.

Feb 02, 2012 | 2000 Dodge Caravan

1 Answer

How to remove the inside door panel from a dodge 2005 2500 pick up


FRONT DOOR TRIM PANEL - REMOVAL
Release door latch and open door.
Roll window down.
Remove window crank Window Crank - Typical , if equipped.
Remove screws attaching trim panel to door Door Trim Panel and Trim Panel Screw
CAUTION: Do not forcibly pull trim panel from door, damage to trim panel may occur.

Simultaneously lift upward and outward to release retainer steps from inner door panel Trim Panel Retainer
Disengage inside handle linkage rod from inside handle.
Disconnect speaker harness wire connector Speaker And Power Mirror Connector
Disengage power mirror wire connector, if equipped (driver's side only) Speaker And Power Mirror Connector
Disengage clips attaching power window/lock switch panel to door trim panel. Disengage wire connector from switch panel, if equipped Power Door Lock/Window Connector
Separate door trim panel from vehicle.
INSTALLATION
Position trim panel at door.
Engage wire connector for window/lock switch panel, if equipped. Engage clips attaching power window/lock switch panel to door trim panel.
Engage power mirror wire connector, if equipped.
Connect speaker harness wire connector.
Engage inside handle linkage rod to inside handle.
Align trim panel retainer steps with inner door panel and slide trim panel into place.
Install screws attaching trim panel to door.
Install window crank, if equipped.

Hope helped with this; remember rated this help. Good luck.

Nov 12, 2009 | 2005 Dodge Ram 2500 Truck

2 Answers

Removing/installing 2000 dodge grand caravan window glass


after u remove the bolts that hold it to the window regulator tip the window towards the front of the door and the top rear corner of the window should pop out and then u just lift hte window out,hope this helps

Sep 05, 2009 | 2004 Dodge Caravan

3 Answers

ELECTRIC DOOR LOCKS ONLY LOCK SOME TIMES


if you hit the lock button a couple times, will it finally lock?

If so, then you will need to take door cover off and lube up the connectors as they probably got corroded.

Aug 14, 2009 | 2000 Ford F350 Super Duty Super Cab

1 Answer

2000 dodge dakota door panel


There are five screws to be removed, two of which are Torx bit. One is in the center of the door panel towards the top. One is behind the door latch handle. One adjacent to the side view mirror, and two along the bottom. There is an access panel along side the door latch handle you need to pop off with a screw driver. It is triangular in shape and about 5 inches long. Once that is removed you will see the door latch linkage to latch handle. Disconnect the linkage by unsnapping the plastic retainer off of the linkag rod and swing it so the rod can be lifted out of the hole. The window crank handle is a *****, you will need a dentist's pick or similar to remove a retaining clip just behind the handle but in front of the panel. The it is just an upward and outward movement on the panel and it should come right out.

Feb 28, 2009 | 1999 Dodge Dakota

1 Answer

1999 2500 quad cab rear door won't open


Linkage has come off inside the door. You must remove the inner door panel and reattach or replace if broken.

Jan 03, 2009 | 1999 Dodge Ram 2500 4WD

1 Answer

Courtesy lights won't come on dodge 2500 ram van 1997


Turn the headlight switch anti clockwise until you hear a click

There is a feature to disable the interior lights when the doors are open for camping. (Turn the switch fully clockwise).

Dec 26, 2008 | 1997 Dodge Ram 2500 Club Cab

Not finding what you are looking for?
1994 Dodge Caravan Logo

155 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...