Question about Chrysler Cars & Trucks

Open Question

POWER MIRRORS NOT WORKING IN2010 SEBRING CONVERTABLE

NEITHER POWER SIDE VIEW MIRROR IN MY CONVERTABLE WILL WORK

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

pal03246
  • 713 Answers

SOURCE: power mirror nissan murano 2004

Remove door panel and check if mirror is plugged in. Wiggle connection and recheck operation. If still inop, replace mirror.

Posted on Jul 21, 2008

  • 76 Answers

SOURCE: How to replace the Passenger side Rear View Mirror on door.

there should be a plastic cover on the inside of the car where the mirror is take this off and there will be a connector block unplug this and there should be screws undo them and the whole thing should come off themn and you should be able to seperate them then.

Posted on Jul 30, 2008

  • 490 Answers

SOURCE: I need wiring diagram for a 1999 Ford f250 side

make your self a jumper set of wires to test with. Find out what makes what move on the old unit,write down the color wire,then apply power and ground to the new unit onw wire at a time.Mark down the color and what function it did.after testing both units then match your research and put the wires together.I wished I were there.Good Luck!

Posted on Jul 24, 2009

  • 205 Answers

SOURCE: driver side view mirror need to replace not power

chek your local auto parts store you can usually buy the replacement glass with adhesive tabs already on it fairly cheap

Posted on Oct 14, 2009

  • 1 Answer

SOURCE: both side power mirrors won't work on 2000 silverado

Silverado power mirror/s do not work.
Assuming you have power to the switch, the switch contacts are bad. Each contact may go bad at different times.Pry the switch panel from the door, disconnect the plug to the switch, a small screwdriver may help. Remove the switch by pushing the retaining lugs in & pry out.
Now take it to a clean workbench along with 2 small thin screwdrivers.
Insert 1 driver in beside one of the keeper lugs & pry slightly, continue to the next until the switch comes apart. No springs will fly out.
You will see a control knob & housing, A blue vinyl like cover, Lift the blue cover off, now you will see the contacts on the board.
Take a cotton swab with carb cleaner & scrub the contacts, even a piece of 320 sandpaper.
Next, on the under side of the blue vinyl like cover there brass like contacts fixed to the cover, they need cleaning.
I cut a few 1/8'''x1/8'' # 320 sandpaper,A 1/8'' dowel & hot glued a piece of s-paper on the 1/8'' x6'' dowel.
I then carefully slowly spun the s-paper on the contact. then to the next contact with a new piece of sandpaper & so on.
Lastly cleaning with carb cleaner & blowing dry.
Reassemble, hookup & test Walla! both mirrors work. Time, 20 to 30 min.

Posted on Oct 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i replace a 2008 chrysler sebring convertible drivers side mirror?


remve teh black plastic cover from the door then remove the door panal undo the conector if its power mirror remove 3 10mm nuts revers for instolaton

Feb 13, 2014 | 2008 Chrysler 300

4 Answers

Replace the review mirror


You need to remove the plastic plate that cover the mirror joint from the inside and undo the three bolts.

Oct 30, 2008 | 2006 Chrysler Town & Country

2 Answers

Where to add side mirrors on a 58 ford Fairlane


I've had the same quandary with my 59 Ford Custom 300 and the more of them I've looked at, the more I've noticed it seems to be personal preference. Mine are currently positioned just to the side of dead center on the top and directly across from the hood cowl side to side. I've seen some positioned on the fender just ahead of the doors or even on the doors to about a third of the way down the fender. I'm getting ready to move mine rearward, I like the look. It's all your vision, my friend. Good luck!

Nov 23, 2012 | Cars & Trucks

1 Answer

How to replace passenger door side mirror 2012 ford flex


The related help links are mentioned below.Click the link below:---
---------How to remove rear view mirror metal foot?

http://schematicsdiagram.blogspot.com/2011/12/how-to-remove-rear-view-mirror-metal.html


----------

power locks, power window and power mirror on the passenger side not working on Ford Windstar
http://howtobyme.blogspot.com/2011/09/power-locks-power-window-and-power.html


----How to Remove Outside Mirrors on Acura Integra?

http://repairhelpcenter.blogspot.com/2011/11/how-to-remove-outside-mirrors-on-acura.html


-------Passenger side Folding Mirror is not operating? http://schematicsdiagram.blogspot.com/2011/12/passenger-side-folding-mirror-is-not.html

--------
These will help.
Thanks.



Nov 18, 2012 | 2012 Ford Flex SE Wagon 3.5L V6 6-speed...

1 Answer

Need a diagram for installing a drivers side electric power mirror on a 1995 mercury villager van


here's 1996, all I have. Please rate.

Mirror, Power — Outside Rear View NOTE: This procedure applies to both RH and LH power outside rear view mirrors.

Removal
  1. Remove the front door trim panel (23942). Refer to Section 01-05 for the removal procedure.
  1. Remove the two outside rear view mirror inside mounting hole cover screws and the outside rear view mirror mounting hole cover (17K709) from the front door (20124).




  1. Remove the wire clip.
  1. Disconnect the power outside rear view mirror electrical connector.




  1. Remove the three power outside rear view mirror bolts and the power outside rear view mirror.




Installation
To install, reverse the removal procedure. Tighten the three power outside rear view mirror bolts to 3-4 Nm (27-35 lb-in). Glass, Outside Mirror
Removal and Installation
Refer to the glass replacement procedures in Manual Mirror for power outside rear view mirror glass (17K707) Trim Cover
Removal
  1. Remove the front door trim panel. Refer to Section 01-05 for the removal procedure.
  1. Remove the two outside rear view mirror inside mounting hole cover screws.


    Remove the outside rear view mirror mounting hole cover.
Installation
To install, reverse the removal procedure. Mirror Control
Removal
  1. Use a small flat-blade screwdriver to pry the power outside rear view mirror control switch from the instrument panel (04320).


May 13, 2010 | 1995 Mercury Villager

1 Answer

After this winter, the blower motor on my 2002 sebring convertible is vibrating terribly (shakes the rear view mirror on high) - how do I access and replace this?


Just go on the passengers side under the dash and remove the insulator panel to see the blower motor.What usually happens is when it gets cold out critters from outside will work their way into your car and make a nest in the blower motor fan.This throws the fan out of balance and hence the vibration.Once you can see the blower motor then remove it.There are 3 or 4 screws.Hope this helps.Good luck.

Mar 23, 2010 | 2002 Chrysler Sebring

1 Answer

Fuse or short problem disabling the side view electric mirrors


Check your cigarette lighter port, I had this problem and there was a penny stuck down in the hole of the cigarette lighter.

Jan 12, 2010 | 2001 Chrysler Sebring

1 Answer

2000 GMC Sierra Power mirrors do not work


sounds like a switch as common error oboth sides unlikely

Dec 31, 2009 | GMC Sierra 1500 Cars & Trucks

1 Answer

Rear view mirror for 98 chrysler sebring


Hello Glitterqueen,

I have had the honor of perusing some of the finest
AUTOMOTIVE SWAP MEETS in the nation...
Northern California, Carlisle & several years of Hershey
being the best memories...!!

Before that we amateurs had the option of NEW
DEALER parts... usually abusively expensive
or "junking" (looking through SALVAGE YARDS)...

THE INTERNET... specifically eBay has brought
a whole new world to my finger-tips...
Have a look at the pages below...

Surprising prices on ROCKAUTO ... (in my opinion)
but do know your prices before trying AMAZON,
especially watchful of your shipping methods & COSTS.

NEW FACTORY OEM CHYSLER SEBRING AUTO DIM REAR VIEW MIRROR COMPASS...

http://www.ebay.com/sch/i.html?_from=R40&_trksid=p2050601.m570.l1313.TR0.TRC0.H0.X1998+chrysler+sebring+rearview.TRS0&_nkw=1998+chrysler+sebring+rearview&_sacat=0

Carnac the Magnificent

Apr 01, 2017 | 2000 Chrysler Sebring

1 Answer

2005 Sebring Convert Radio/light off


I am having this same problem with my 99 sebring.. anyone know what we can do to fix this?

Oct 21, 2008 | 2005 Chrysler Sebring Conv

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...