Question about Cars & Trucks

1 Answer

Hyundai getz starting problem

Starting problem at cold start spark plugs all wet with petrol

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 3,103 Answers

Auto shutoff relay not energizing ignition circuits..needs replaced..

Posted on Dec 25, 2013

6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 53 Answers

SOURCE: hyundai getz

if the speedo still works then it will need a spedo unit if the speedo doesn't work it is either the cable or the gear in the trans to check the cable unthread from trans and attach a drill to the cable innereds spin the drill if the speedo does not move replace the speedo cable

Posted on Oct 18, 2008

  • 776 Answers

SOURCE: from cold start engine warms to quater temp then

Does the Check Engine light come ON when this happens? Whenever the "Check Engine" light comes on, there is always a DTC (Diagnostic Trouble Code) stored in the ECM (Engine Control Module). You'll need an OBDII (On-Board-Diagnostics) scanner to retrieve any codes recorded/set in ECM. Otherwise, guesswork. I have MANY ideas that could send you on a wild goose chase. I strongly suspect EMS (Engine Management System) sensor beginning to malfunction as it warms up. First strong suspicion is the crank position sensor (CKP) - however,usually always sets a DTC (i.e., P0335, P0336). The next suspicion is the Engine Coolant Temperature sensor. The ECM uses this sensor's signal to adjust fuel, timing, engine RPM, etc based on engine temp. If malfunctioning at a particuar point during engine warm up, it could be telling the ECM the temperature is LOWER or HIGHER than it ACTUALLY is, resulting in the ECM to increase fuel (flood it) or give it LESS fuel (starve it). If this malfunction lasts long enough, the ECM will usually set a DTC for that sensor circuit, either a Range/Performance code, or a "LOW Input" or "HIGH Input" code.

Posted on Jun 07, 2009

  • 58 Answers

SOURCE: ford fiesta,1996,petrol,fails to start.

either your fuel pump relay or the safety shut off switch

Posted on Jul 05, 2009

  • 108 Answers

SOURCE: 2008 hyundai getz wont start

I just worked on a different model Hundai with the same sounding problem. I discovered that the starter was drawing to much voltage and starving the ignition system not allowing it to fire. I ran an amperage draw test and when it was discovered that it was the starter that was the culprit we replaced the starter with a rebuilt starter and it cured the intermitant starting problem. I hope this helps solve your problem.


Posted on Jul 28, 2009

SOURCE: 2002 Hyundai Accent GL will turn over, but it won't start

i dont really have a solution but i have a 2002 Hyundai accent gs that wont start when it gets cold if its below 50 degrees out the car will crank but not start we have replaced everything the alternator,starter,battery,both coil pack,transmission,crank censor,oxygen censor,fuel pump relay, computer, and 100 amp alternator relay none of these things has fixed the car does any one know what else it could be

Posted on Feb 24, 2012

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why and what must I do. Spark plugs are wet of petrol. Mechanics take me for a ride every time.

Could be many things, but start with the basics. Use fuel pressure test gauge to check for leak down after shutting engine off. Could be leaky injectors. Could also be weak spark preventing fuel from complete burn--bad coil or ignition module. More likely bad coolant temp sensor making ECU think engine is still cold after it is warmed up. Another possibility is clogged exhaust.

Sep 13, 2016 | 2002 Opel Corsa

1 Answer

Cant start the car the starting motor is fine

Could be several things, check for spark at the spark plugs, if ok check fuel pressure and flow if ok, back probe injectors with a led test light, the light should flash while the motor is trying to start. if not check engine fuse.

Apr 19, 2015 | 2010 Hyundai Getz 1.5

1 Answer

Hyundai getz starting problem

run the fault codes and find exactly which sensor should have been fitted

Mar 08, 2014 | Cars & Trucks

1 Answer


Some info about the car can be found
The Korean Car Guide Hyundai Getz Part II Engine

The failure to start could be due to the Crank Timing Sensor. The sensor not working will stop the computer from knowing when the spark should be activated and the injection of the fuel should take place.
I hope this is the problem. and that you can find
This is only my opinion and It seems to fit the problem posted

Jan 13, 2014 | Cars & Trucks

1 Answer

Hyundai getz starting problem

If the battery is exhausted, four years is a good age, then yes, the engine will have difficulty turning against compression.

Jun 16, 2017 | 2007 Hyundai Getz 1.6

1 Answer

Engine not starting after engine overhaul no spark and fuel injectors not putting petrol

Sounds like a immobilisor fault ,was battery left connected with the key in the ignition and the drivers door open??

Dec 10, 2012 | Hyundai Motor 1998 Sonata

1 Answer

How to change the spark plugs in a 2008 getz

To get too my 2008 Getz spark plugs. I used my socket set with an extension on the plug spanner provided with the inexpensive kit !

Jan 19, 2012 | 2008 Hyundai Getz 1.4

1 Answer

Spark plugs for my 2001 nissan altima is always wet with oils and there is no spark, what's the problem?

The spark plugs are probably wet with petrol, rather than oil.

This happens because they are not firing, and the petrol is not being burnt.

This is mostly likely caused by a faulty ignition system.

Does the car start at all? Does it run roughly?

May 24, 2009 | 2002 Nissan Altima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides