Question about Jeep Liberty

1 Answer

Check engine cruise control light abs

Check engine light is on, code has something to do with cruise control emergency brake. I don't have cruise control and the speedometer isn't working. Suggestions? Need to pass safety.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Renaissance:

    An user who is expert in 3 categories / brands.

  • Jeep Master
  • 803 Answers

Try going to a local Checker, Autozone or O'Rielys for a code pull. Sounds like a " vehicle speed sensor" problem.

Posted on Dec 25, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: abs and hand brake light

Check your master cylinder switch in the res. is not stuck down. When started is the light off until you go over 15 mph? If so check your abs relay. Good luck

Posted on Aug 03, 2008

  • 1 Answer

SOURCE: My check engine light is

Had same problem with mine. First would not show speed until reached about 25 MPH and then was intermittent. Starts with ABS and Brake Light on and no speed. Checked another website and suggested pulling sensor out of top of rear differential. About $30 part but in hard to reach area. be careful when reinstalling. Do not tighten bolt too fast as this may break the part. Allow it to slowly slide into place. Takes 30-60 minutes to replace. Works fine now.

Posted on Oct 27, 2008

  • 1 Answer

SOURCE: my speedometer's not working neither is my cruise control

It's your ETCBM ( Electronic Traction Control Brake Module ). Had the same problem . This will cause your speedometer , ABS brakes and check engine light to come on.You'll even notice your stering is a little stif. I had my mechanic remove it and sent it out to Module Masters for rebuild ( 5 year warranty ) Works like a charm now. Those guys are really great .Cost me with freight $160 plus mechanic to R & R it.
www.modulemasters.com

I found this info online . Most mechanics will say it is a Speed sensor, but after many hours and going that route you'll see what I mean.

PS: You can still drive the car ( carefully ) while you wait for the rebuilt unit to be returned.

Ron

Posted on May 15, 2009

  • 1608 Answers

SOURCE: ABS, Service Engine Light

This is normal for your anti-lock brakes to quit when the abs light is on.What you will need to do is retrieve the codes and then you can find out what part of the abs system is giving you the problem.This will also cause the check engine light to come on.You can post back and I can help you with the code or codes that are in the brake control module.Hope this helps.

Posted on Dec 14, 2009

dmsr63
  • 2050 Answers

SOURCE: ABS/brake lights on, check engine on, speedometer

1st step is to get it scanned to see what issue the computer has found, it may be related, but you need to know what the code (s) is to move forward.

Posted on May 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

5 Answers

How come my cruise control won't even light up, much less work? 2004 trailblazer


has a fuse and an actuator motor or
the set resume switch could be faulty

May 31, 2016 | 2004 Chevrolet TrailBlazer

1 Answer

Esp bas light abs


get the brakes serviced first.
neither of those work with bad brakes.
check fuses 1st.
then scan it, scan the ABS. see DTC codes,
if it says a sensor is dead. well it is..
each code has different meanings and further tests.
but we check that the brakes work.first.

imagine if you will, trying to fix cruise control with a dead engine.
see?

Jul 09, 2014 | 2007 Jeep Liberty Sport

1 Answer

Why would engine light,cruise control and abs light come on?


hello,do post your DTC'S,(diagnostic trouble codes) and may be i can help.many modern vehicles spring up a multitude of warning icon's on the dashboard,much to the alarm of it's owner,however,often it can be as simple as a dirty wheel speed sensor,which fails to provide the necessary information to the main (ABS/TRACTION control unit) and so then will inhibit the cruise control,as naturally it's unable to ascertain road wheel speed,and also throw up the engine management light,as the braking/traction control systems unable to supply correct information to the main engine computer(ECU,OR PCM) electronic control unit/power control module. hope this helps,but please supply any further information that you can,regarding your DTC'S, that are read out,try to get a full print off,if at all possible, cheers.

Jun 25, 2014 | 2006 Subaru B9 Tribeca

1 Answer

Cruise control stopped working when abs and flashing auto and check engine lights came on 2007 suzuki sx4


have the vehicle scanned for trouble codes[s] and when you have check engine codes remote start and some vehicles cruise will not work

Aug 15, 2017 | Suzuki SX4 Cars & Trucks

2 Answers

My brake pads have been replaced, however the dash brake warning light still appears. In addition, the cruise control is not working. This has reset a few times and the light has gonen out adn the cruise...


Look at your brake master cylinder, open the top to it, and check your brake fluid. If low, that is why the brake light is on. Or check to see if your emergency brake is pushed in. Check your fuses for the cruise control. Hope this helps, James Booth

May 17, 2011 | 2004 Mercury Mountaineer

1 Answer

I have a 2003 Pontiac Grand Am Track off light and ABS light and Sevice Vehicle Soon light stays on all the time. Sometimes the emerge light comes on.(i, P light). For the Service Vehicle light, I...


the traction control system works off of the abs system so there is a code in the abs module that needs to be pulled so you know were to start to check the system out.the service engine light is a different system all together and there is a code in the ecm that must be pulled so you know were to start to check to repair that system.you don`t say why you jumped to the conclusion that the gas cap set a code.the emergency brake light will come on if the e-brake is not all the way in the off position(something may be holding the lever up just enough to put the light on.the switch could be misadjusted and needs to e readjusted.

Mar 30, 2011 | Pontiac Grand Am Cars & Trucks

2 Answers

My 84 year old dad has a 94 buick century 3.1 litre ,the anti-lock brake light stays on and the cruz doesn't work since the light came on


you have an abs code in the abs module that needs to be checked out and repaired,it could be something simple like a bad connections or broken wire or something more involved.the cruise is disabled as a safety thing.

Mar 09, 2011 | 1994 Buick Century

2 Answers

Fuel Pump Fuse Number for a 1998 audi a4 2.8 quattro


Fuses: Fuse arrangement in fuse panel, behind instrument cluster, left
Fuse Arrangement In Fuse Panel 62624464

1 - Heated washer jets 5A 2 - Turn signals 10A 3 - Headlight washer (relay), illumination for glove
compartment, climate control, Automatic Transmission, instrument cluster 5A 4 - License plate light 5A 5 - Instrument cluster, seat heating, test connection
for cruise control, bulb monitor for auto-check display, Automatic Transmission display, switch
lighting, mirror switches and actuators, airbag
warning light, outside temperature indicator,
climate control 10A 6 - Central locking system 5A 7 - Anti-lock brake system (ABS) 10A 8 - Vacant 9 - Mirror heating 10A 10 - Vacant 11 - Cruise control (Automatic Transmission) 5A 12 - On board diagnostic system 10A 13 - Brake lights 10A 14 - Interior lights, reading lights, anti-theft alarm system, vanity mirror 10A 15 - Instrument cluster, power windows, climate control, automatic transmission 10A 16 - Anti-lock brake system (ABS), Anti-Slip Regulation (ASR) 5A 17 - Heated door locks 10A 18 - High-beam, right 10A 19 - High-beam, left 10A 20 - Low-beam, right 15A 21 - Low-beam, left 15A 22 - Side marker and tail light, right 5A 23 - Side marker and tail light, left 5A 24 - Wiper and washer system 25A 25 - Blower for heating, climate control 30A 26 - Rear window defogger, mirror heating 30A 27 - Rear window wiper 15A 28 - Fuel Pump 15A 29 - Engine timing 30A 30 - Sun roof 20A 31 - Tail lights, cruise control, automatic transmission 15A 32 - Engine timing 20A 33 - Cigarette lighter 15A 34 - Engine timing 15A 35 - Trailer recptacle 30A 36 - Fog lights 15A 37 - Radio 20A 38 - Luggage compartment light, central locking system 15A 39 - Emergency flasher system 15A 40 - Horn 25A 41 - Anti-lock brake system (ABS) 25A 42 - Vacant 43 - Vacant

Apr 05, 2010 | 1998 Audi A4

1 Answer

While driving home from work my ABS light illumintaed then my 4X4 high light began flashing. What do you think the problem might be?


For some year models of Explorers involved in the Cruise Control recall, there were additional wiring problems caused by the modification of the Cruise Control. These problems included yours and Brake lights working independent of the brakes. Contact a dealer about this SECOND service bulletin.

The above problems are more likely if the 4x4 is showing a light and the vehicle is in 2 wheel drive. The ABS indicator light is usually to be trusted without the Cruise problem. It would not hurt to check the brake pad linings, sometimes the lining shifts and drops down off the metal of the pads. Finally if the ABS light is still showing a problem that you can not find, check the Emergency brake pads inside the rear rotors.

Feb 06, 2010 | 2004 Ford Explorer

1 Answer

2003 trailblazer loss of cruise control and ac fan


for parking brake and abs check for parking brake switch operation, for abs check with scan tool for any trouble code, for your cruise control unit check for any broken vacumm hoses on the engine, for the ac fan, check the fan motor, relay or fuse.

Jul 16, 2009 | 2003 Chevrolet TrailBlazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

134 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...