Question about 1999 Chevrolet Blazer

1 Answer

Wire splicing I recently had a chipmunk make a nice little home under my hood up on the right side(From sitting in SUV). It ate through the ABS and oil gauge wires and possibly the CD player wires. I am wanting to just splice those wires back together and was curious if anyone knew of the gauge so that I could replace those or if there are issues I might not know of. I am pretty new with car repair.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 187 Answers

In the world of wires the lower the number the heaver the gauge wire, the heaver the wire the greater the load it can carry. To get not only the right size wire but type remove a small piece and take it with you to the auto parts store to match. Also try getting some liquid tape to bend the splices it works far better than traditional tap in weather proofing.

Posted on May 17, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to turn off abs light


Remove ur both battery wire and switch on lights and wait for 1 hour .then plug it back

Jul 11, 2014 | 2005 Honda Accord

1 Answer

2001 Jeep Grand Cherokee has continual water on right side carpet? Any answers?


your ac drain is not draining. under hood on right side under heater box is a little plastic pipe get a piece of wire put it in about one inch to release clog. be prepaired to get very wet.

Jul 10, 2014 | 1997 Jeep Grand Cherokee

1 Answer

How many temperature sensor are there on 5.2 liter


Also I have one 1993 Jeep Grand Cherokee 4WD 5.2L MFI 8cyl (nice SUV) this vehicle is not equipped with Engine Temperature Sensor; just have this...
- The Coolant Temperature Sensor is located: Under hood, center, upper engine area, mounted in driver side of water outlet
- The Temperature Switch is located: Under hood, center, upper engine area, passenger side of water outlet, mounted in intake manifold

Hope this helps (remember to rate this answer) and, if you need additional details or repair manualm juts send us a new message.

Dec 19, 2010 | 1993 Jeep Grand Cherokee

1 Answer

POWER SEAT WONT WORK ALL READY CHECK THE FUSE


Might want to check the driver's side door sill for a splice that is corroded.

In the SCab, I have seen this closer to the driver's side kick panel, wheer the hood release is at ( still in the door sill ), on the SuperCrew, I have seen this splice at the back, where the wires turn up the C-pillar.
Here are some pictures from other people that had this problem.

The front, the wire with the bad splice was reported to be a blue w/ White stripe wire.

3c8d84f.jpg

When it is found in the back, it is a violet wire
94ad720.jpg

The additional reported problems I have seen vary from the dome lamp & radio won't go off, to the power mirrors also do not work.

Worth a check in this area, to see if you have a bad splice. The tape used is like hockey tape, and does not work well when water is sitting in the channel that the wires are in.

Dec 07, 2009 | 2004 Ford F150

1 Answer

Wiring schematic for plymouth grand voyager 1995


Is there green corosion on the tip of the wire ? Chances are the answer is yes. You will have to detach the fuse panel/box and run a new wire and connector to the fuse panel. Splice into the wire you can see, but make sur you cut enough of the wire off to get rid of the corrosion.Hope this helps.

Jul 30, 2009 | 1995 Plymouth Voyager

2 Answers

I can't get my trailer lights to work. I don't


First check the bulbs; remove them and check the sockets for corrosion. You can clean sockets with a battery post/cable wire brush. Shine the bulbs brass with a little sandpaper, also the end. Put a little dielectric grease in there. Use a multimeter and check that you have voltage coming from your tow vehicle. Go from the the wire to ground, then go from the wire to the trailer's ground. Bad grounds are the most common cause of trailer wiring problems. They also cause lousy coffee in the morning. Check your wires for bad ends, check your wires for nicks and fraying. If you've found a bad spot in a wire, cut it out and splice it with a **** connector. If need be, splice in a section of wire. Wire should not be black but nice and shiny. If it's black up into the covering, cut out that section and replace it. Have a nice time at the lake.

Jul 08, 2009 | 1998 Ford F150 Regular Cab

1 Answer

2001 Jimmy ABS and brakes lights came on


I hate to say it, but the abs control module might have died on you. Thats the boxy looking thing under the hood that has a lot of brake lines and wire connectors going into it. I have seen this happen before and it ended up being one of the speed sensors on the wheels but usually its the module. Take the truck somewhere to get the light scanned, and that will give you a better idea of what it is.

May 24, 2009 | 2001 GMC Jimmy

1 Answer

Need simple diegram for horn


I'm looking to see if my book has a picture. I found the horn itself behind the right wheel well cover. My 1996 horn was nicely corroded from being exposed to the elements. I spliced the wires and mounted the new one under the hood.

Mar 03, 2009 | 1996 Chevrolet Cavalier

Not finding what you are looking for?
1999 Chevrolet Blazer Logo

Related Topics:

75 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...